Sony XM-GTR2022 Operating Manual

XM-GTR2022

2/1 channel GTR amp

202W x 2 RMS (20Hz-20kHz, <1%THD+N, at 4 Ohm, 14.4V)

Maximum power output of 400W per channel at 4 Ohm.

250W x 2 RMS (20Hz-20kHz, <1%THD+N, at 2 Ohm, 14.4V)

Maximum power output of 600W per channel at 4 Ohm.

500W x 1 RMS (20Hz-20kHz, <1%THD+N, at 4 Ohm mono, 14.4V)

This unit can be used as a bridging amplifier with a maximum output of 1200W at 4 Ohms.

Direct connection (High Level Input) can be made with the speaker output of your car audio unit if it is not equipped with RCA line output.

Hi-

Level Sensing power On feature allows the unit to be activated

without need for remote connection.

Built in variable 12 dB/Oct LPF (Low Pass Filter) from 50-300Hz enables users to concentrate the power on lower frequencies.

Variable 0-10 dB 40Hz bass boost provides additional bass response at lower frequencies.

Sony Electronics Inc. • 16530 Via Esprillo • San Diego, CA 92127 • 1.800.222.7669 • www.sony.com

Last Updated: 01/20/2010

XM-GTR2022

2/1 channel GTR amp

Please visit the Dealer Network for current information at

www.sony.com/dn

Features

202W x 2 RMS (20Hz-20kHz, 1%THD+N, at 4 Ohm, 14.4V)

Maximum power output of 400W per channel at 4 Ohm.

250W x 2 RMS (20Hz-20kHz, 1%THD+N, at 2 Ohm, 14.4V)

500W x 1 RMS (20Hz-20kHz, 1%THD+N, at 4 Ohm mono,

14.4V)

This unit can be used as a bridging amplifier with a maximum output of 1200W.

High Level input with Sensing Power On Direct connection

(High Level Input) can be made with the speaker output of your car audio unit if it is not equipped with RCA line output. Hi-Level Sensing power On feature allows the unit to be activated without need for remote connection.

Variable LPF filter and 40 Hz boost Built in variable 12 dB/Oct LPF (Low Pass Filter) from 50-300Hz enables users to concentrate the power on lower frequencies. Variable 0-10 dB 40Hz bass boost provides additional bass response at lower frequencies.

Specifications

Audio

Frequency Response: 5-50kHz (+0/-3 dB) Input Level: 0.3 - 6.0V (RCA input) or 1.2 - 12.0V (High Level Input) Impedance: 2-8 Ohms Stereo or 4-8 Ohms Mono Operation: 2/1 channel configuration Tone Control(s): Low Pass Filter: 50-300Hz, -12dB/Oct Harmonic Distortion: 0.01% (at 1kHz) Low Boost: 0-10dB (40Hz) Signal-to-Noise Ratio (dB): 93 dBA

Power

Output Power: Maximum Output: 400W x2 or 1200W x1 (at 4

Ohms)

Current Drain: At rated output:48A (at 4 Ohms)

Remote Input: 1 mA

Rated Output: 202 Watts x 2 RMS (20Hz-20kHz, 1% THD+N, 4

Ohms, 14.4V) 250 Watts x 2 RMS (20Hz-20kHz, 1% THD+N, 2 Ohms, 14.4V)

500 Watts x 1RMS Mono (20Hz-20kHz, 1.0% THD+N, at 4 Ohms,

14.4V)

Power Requirements: 12V DC Car Battery (Negative Ground) Internal Power Supply: OTL Output Transformerless Circuit

Pulse Power Supply

Input Voltage: 10.5-16V Power Supply Voltage

Inputs and Outputs

RCA Audio Input(s): Pin Jacks: 0.3 - 6V Audio In: RCA Pin Jacks, High Level Input Connector Audio Out: Speaker terminals with screws

Dimensions

Weight: 11 lbs. 13 oz

Measurements: 10 7/8 x 2 1/4 x 15 7/8"

(276 x 57 x 403mm)

Supplied Accessories

Mounting Screws (4) High Level Input Cord

Color:

Black and Gray

UPC Code:

027242721159

1. CEA-2006 Compliant —

Standardized “Voluntary”

Testing & Measurement Methods for Mobile Audio

Amplifiers. This standard advocates a uniform method for determining an amplifier’s RMS power and signal

to-noise ratio. Using 14.4 volts, RMS watts are measured into a 4-ohm impedance load at 1 percent Total Harmonic Distortion (THD) plus noise, at a frequency range (for general purpose amplifiers) of 20 Hz to 20,000 Hz.

© 2009 Sony Electronics Inc. All rights reserved. Reproduction in whole or in part without written permission is prohibited. Sony, Memory Stick, nav-u, Quick-BrowZer, Walkman, Xplod, ZAPPIN, and the Sony, nav-u and Xplod logos are trademarks of Sony. iPhone and iPod are trademarks of Apple Inc., registered in the U.S. and other countries. Bluetooth is a trademark of Bluetooth SIG, Inc. NAVTEQ Maps & Traffic is a trademark of NAVTEQ. All other trademarks are trademarks of their respective owners. Features and specifications are subject to change without notice. Non-metric weights and measures are approximate.