Sony PLAYSTATION (PS ONE) SCPH-102 User Manual

Instruction Manual
Thank you for purchasing the PlayStation® (PS one®) video game console.
You can enjoy playing PlayStation® format CD­ROM discs with both the
[PAL]
designation, and audio CDs with this unit. Before using the unit, please read this instruction manual and retain it for future reference.
PlayStation® logo and
3-066-615-22(1)
Connector section
1/u (on/standby)/RESET button and 1/u indicator
Disc cover
§ (open) button
MEMORY CARD slots
Controller ports
L2 button, R2 button, L1 button, R1 button
Directional buttons ¢ button, ® button,
button, π button
SCPH-102 B
© 2000 Sony Computer Entertainment Inc. All rights reserved.
START button
ANALOG mode button
SELECT button Left analog stick, right analog
stick, L3 button, R3 button
2

WARNING

To prevent fire or shock hazard, do not expose the unit to rain or moisture.
To prevent fire or shock hazard, do not place a container filled with liquids on top of the console.
To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only.
Caution
The use of optical instruments with this product will increase eye hazard.
Read before operating your PS one® console
A few people may experience epileptic seizures when viewing flashing lights or patterns in our daily environment. These persons may experience seizures while watching TV pictures or playing video games. Even players who have never had any seizures may nonetheless have an undetected epileptic condition. Consult your doctor before playing video games if you have an epileptic condition or should you experience any of the following symptoms during play: altered vision, muscle twitching, other involuntary movements, loss of awareness of your surroundings, mental confusion, and/or convulsions.
Use the supplied AC adaptor only. If you use other types, it may cause fire, electrical shocks or a malfunction.
This appliance is classified as a CLASS 1 LASER product. The CLASS 1 LASER PRODUCT MARKING is located on the bottom of the PS one® console.
Precautions
Your PS one® console is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off.
About the nameplate
The nameplate is located on the bottom of the
PS one® console.
Notice
If this unit is affected by static electricity or burst-noise, it may not work correctly.
WARNING
USING THE PS one® CONSOLE IN A MOVING VEHICLE COULD DISTRACT THE DRIVER. IT IS DANGEROUS AND MAY BE ILLEGAL TO USE A SCREEN WHICH IS NOT SECURELY MOUNTED OR IS WITHIN THE DRIVERS VIEW OR WHERE THE DRIVER CAN SEE REFLECTIONS OF IT. DO NOT USE THE PS one CONSOLE IN THE FRONT SEAT OF A MOVING VEHICLE. If the PS one® console is used in a moving vehicle, the user should ask the drivers permission and follow the drivers instructions. Many games include loud or sudden noises that can be distracting, and it may be necessary to operate at a reduced volume, with the volume turned off or by using headphones. If used loose in a moving vehicle the PS one® console, like any loose object, could cause injury to the user, the driver and other passengers in accidents or as a result of sudden braking. It is unsafe to leave children unaccompanied in a car, whether playing with the PS one® console or not.
PLEASE KEEP THIS WARNING AVAILABLE FOR REFERENCE.
®

Table of contents Unpacking

2 WARNING
3

3 Unpacking 4 Precautions

5 Connecting your PS one®
console to a TV set
7 Playing a game 9 Using the Analog Controller
(DUALSHOCK®)
11 Using the Memory Card 13 Playing an audio CD 16 Enjoying SoundScope
18 Troubleshooting 21 GUARANTEE
22 Specifications
Check that you have the following items:
• PS one
• RFU Adaptor • AC Adaptor
® console
• Analog Controller (DUALSHOCK
®)
4

Precautions

On safety
The laser beam emitted from the lens of your PS one the eyes. Do not attempt to disassemble the casing. Servicing should be carried out by qualified personnel only.
Should any solid objects or liquid fall into your PS one immediately and have it checked by qualified personnel before any further use.
Disconnect your PS one from the mains if you do not intend to use it for any length of time. When doing this, grasp the adaptor and pull it from the wall socket. Never pull the cord itself.
® console is harmful to
® console, unplug it
® console
For your health
Be sure to take a break of about 15 minutes during every hour of play.
Do not play a game when you are very tired or short of sleep.
Play in a well lit room, sitting as far from the screen as the cord will allow.
On operation
Operate your PS one® console only on 220 - 240 V AC, 50/60 Hz.
Do not cover your PS one® console during use as heat may build up internally.
Avoid rough handling or knocks and do not put any heavy objects on top of your PS one damage the console or the disc.
Do not leave your PS one® console near heat sources, or in a place subject to direct sunlight (operating temperature: 5˚C-35˚C), excessive dust or sand, moisture, liquid, on an uneven surface, or in a car with its windows closed.
If your PS one interference to radio or television reception, turn it off or move it away from the radio or television.
Do not touch the lens inside the disc cover. To protect the lens from dust keep the disc cover closed except when inserting or removing the disc. If the lens is not clean, your PS one console may not operate properly.
The SCPH-1040 Link Cable cannot be used with this unit.
The method for resetting the PS one is different to that for the PlayStation SCPH-5502 B, SCPH-5552 B, SCPH-7002 B, SCPH-7502 B, SCPH-9002 B). For more information, see Restarting a game on page 8.
Avoid prolonged physical contact with the PS one adaptor. This may cause low temperature burns.
® console. This could
® console causes
® (SCPH-1002 B,
® console or AC
About the discs
You can use two kinds of discs with your PS one with both PlayStation® logo and [PAL] designation, and audio CD discs.
Some discs sold in foreign countries cannot be used with this unit.
® console: CD-ROM discs
On handling discs
Do not leave the discs near heat sources or in direct sunlight or excessive moisture.
Store the discs in their cases when theyre not in use.
When handling the discs, do not touch the surface. Hold them by the edge.
Do not stick paper or tape on the discs.
Do not write on the discs with a
®
marker, etc.
®
On condensation
If your PS one® console is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens inside. Should this occur, your PS one console may not operate properly. In this case, remove the disc for several hours until the moisture evaporates. If your PS one operate properly, call the appropriate PlayStation which can be found:
on the customer registration card; within every PlayStation
software manual.
® console still does not
® customer service helpline
® format
Do not connect your PS one® console to a projection TV
Do not connect your PS one® console to a projection TV. Permanent damage may result unless it has an LCD screen.
Never analyse, examine or remodel your PS one
Use your PS one® console according to this instruction manual. Sony Computer Entertainment Inc. expressly prohibits the analysis or remodelling of the PS one the analysis, use of its circuit configurations without express written permission of Sony Computer Entertainment Inc.
® console, and also prohibits
® console
®

Connecting your PS one® console to a TV set

Connecting to a TV with a Euro-AV
B
connector using the Euro-AV
5
Connecting to a TV with an aerial
A
input
ANT
Connect your PS one® console to the aerial input on the TV using the supplied RFU Adaptor. Note that the sound will not be in stereo in this case.
After connecting
Tune your TV to frequency 36.
connector plug
Connect your PS one® console to the Euro-AV connector on the TV using the optional Euro-AV connector plug (not supplied) and optional AV Cable (integrated audio/video) SCPH-1140 E (not supplied), making sure you match the colours on the plug and terminals.
After connecting
Set your TV to the appropriate video input mode. (Refer to the instruction manual of your TV.)
(continued)
6
Connecting your PS one® console to a TV set (continued)
Connecting to a TV with a Euro-AV
C
connector directly
You can improve picture quality by using the optional Euro-AV Cable SCPH-1052. Connect your PS one® console to the Euro-AV connector on the TV.
After connecting
Set your TV to the appropriate video input mode. (Refer to the instruction manual of your TV.)
Connecting to a TV with audio/
D
video inputs
Connect your PS one® console to the TV using the optional AV Cable (integrated audio/video) SCPH-1140 E (not supplied), making sure you match the colours on the plugs and terminals. If your TV is monaural, do not connect the red plug. If you want to hear both left and right sounds from a monaural TV, use a commercially available dual-phono to single-phono (stereo to monaural) type audio cable.
After connecting
Set your TV to the appropriate video input mode. (Refer to the instruction manual of your TV.)
IMPORTANT INFORMATION
A small number of television sets or monitors may display a bouncing or other incorrect screen effect when connected to the PS one warranties offered by SCEE may be limited or disclaimed in such particular cases. Should you experience any difficulties with your PS one appropriate PlayStation
on the customer registration card; within every PlayStation® format software manual.
® customer service helpline which can be found:
® console. Any applicable
® console, please contact the

Playing a game

When you close the disc cover, push here firmly until it clicks.
231
1
Press § (open) button.
The disc cover opens.
Insert a disc in the disc holder with the label side up.
2
Close the disc cover.
3
When you close the disc cover, close it firmly until it clicks.
4
Press 1/u (on/standby)/RESET button.
The 1/u (on/standby) indicator lights up. After the start-up screen, screen 1 appears and the game begins.
Set the supplied Analog Controller (DUALSHOCK®) to the appropriate mode for the software (see page 9).
Tips
When you end a game, press § button, remove a disc and press 1/u/RESET button to turn off the PS one
If you turn on your PS one gives you access to the audio CD control screen and the Memory Cards activity screen, described later on in this instruction manual. If you insert a CD-ROM disc of the PlayStation
If the screen 3 appears, the inserted disc might be of a different format. Check if it has both the PlayStation® logo and [PAL] designation on it. A damaged or dirty disc would also produce this screen.
See ”Troubleshooting“ on page 18.
Notes
When inserting a disc, push the disc gently but firmly until it sits snugly on the central spindle.
MWARNING
Before removing a disc, press the § button and make sure that the disc completely stops. Never touch the disc while it is spinning. Otherwise, you may hurt yourself or damage the disc or your PS one
® console.
® console without first inserting a disc, screen 2 appears. It
® format while screen 2 is on, the game will start automatically.
® console.
(continued)
7
8
Playing a game (continued)
A Restarting a game
1/u/RESET button
Press 1/u (on/standby)/RESET button twice. Be careful not to accidentally press 1/u/RESET button twice while playing the game, or the game will end.
B Removing a disc
When you close the disc cover, push here firmly until it clicks.
§ button
Press § (open) button. While pressing the central spindle gently, pick up the disc holding it by the edge. When you close the disc cover, close it firmly until it clicks.
C Screens that appear after
start-up screen
When you turn on your PS one® console, one of the following screens will appear.
1 A CD-ROM with both PlayStation®
logo and [PAL] designation is inserted.
2 No disc is inserted.
3 A disc that cannot be played with
the PS one® console is inserted.
Loading...
+ 16 hidden pages