Please staple your receipt and/or write in the name and phone number of the retai l store where you purchased your treadmill.
Name: ______________________________ Phone Number: ___________________ Receipt: _____ _________________
Precautions:
WARNING: To reduce the risk of burns, fire, electric shock, or injury to persons, read the following important precautions and
information before operating the treadmill. It is the responsibility of the owner to ensure that all users of this treadmill are
adequately informed of all warnings and precautions.
PRECAUTIONS
• Use the treadmill only as described in this manual.
• Place on a level surface, with 6 feet (2 m) of clearance behind it. Do not place the treadmill on any surface that blocks air
openings. To protect the floor or carpet from damage, place a mat under the treadmill.
• When choosing a location for the treadmill be sure that the location and position permit access to a plug.
• Keep the treadmill indoors, away from moisture and dust. Do not put the treadmill in a garage or covered patio, or near
water.
• Do not operate the treadmill where aerosol products are used or where oxygen is being administered.
• Keep children under the age of 12 and pets away from the treadmill at all times.
• The treadmill should not be used by persons weighing more than 400LBS (182 Kgs).
• Never allow more than one person on the treadmill at a time. Wear appropriate exercise clothing when using the treadmill.
Do not wear loose clothing that could become caught in the treadmill. Athletic support clothes are recommended for both
men and women. Always wear athletic shoes. Never use the treadmill with bare feet, wearing only stockings, or in
sandals.
•When connecting the power cord, plug the power cord into a grounded circuit. No other appliance should be on the same
circuit.
• Always straddle the belt and allow it to start moving before stepping onto the belt.
• Always examine your treadmill before using to ensure all parts are in working order.
• Allow the belt to fully stop before dismounting.
• Never insert any object or body parts into any opening.
• Follow the safety information in regards to plugging in your treadmill.
• Keep the power cord away from the incline wheels and do not run the power cord undern eath your treadmill. Do not
operate the treadmill with a damaged or frayed power cord.
•Always unplug the treadmill before cleaning and/or servicing. Service to your treadmill should only be performed by an
authorized service representative, unless authorized and/or instructed by the manufacturer. Failure to follow these
instructions will void the treadmill warranty.
• Never leave the treadmill unattended while it is running.
• Use “safety key” when operating the treadmill and make sure the “safet y ke y” is clipped to the users clothing.
• Remove the “safety key” and store it in a safe place when the treadmill is not in use. Keep the “safety key” away from
children.
www.smoothfitness.com
3
Power Requirements:
IMPROPER CONNECTION OF THE EQUIPMENT GROUNDING CONNECTOR CAN RESULT IN THE RISK OF AN ELECTRIC
SHOCK. CHECK WITH A QUALIFIED ELECTRICIAN OR SERVICE MAN IF YOU ARE IN DOUBT AS TO WHETHER THE
PRODUCT IS PROPERLY GROUNDED. DO NOT MODIFY THE PLUG PROVIDED WITH THE PRODUCT, IF IT WILL NOT FIT
THE OUTLET; HAVE A PROPER OUTLET INSTALLED BY A QUALIFIED ELECTRICIAN.
This treadmill can be seriously damaged by sudden voltage changes in your home’s electrical power. Voltage spikes, surges and
noise interference can result from weather conditions or from other appliances being turned on or off. To reduce the possibility of
treadmill damage, always use a surge protector (not included) with your treadmil l.
Surge protectors can be purchased at most hardware stores. The manufacturer recommends a single outlet surge protector with a
UL 1449 rating as a Transient Voltage Surge Suppressor (TVSS) with a UL suppressed voltage rating of 400V or less and an
electrical rating 110VAC, 15 amps.
This treadmill must be grounded to reduce the risk of electrical shock. Grounding provides a path of least resistance for electric
current, should the treadmill malfunction. This treadmill is equipped with an electrical cord that has an equipment-grounding
conductor and a grounding plug. Always plug the power cord into a surge protector, and plug the surge protector into an
appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.
This product is for use on a nominal 110-volt circuit, and has a grounding plug that looks like the plug il lustrated in the drawing
below.
GFCI outlets and GFCI Circuit Breakers are NOT recommended for use on this product. GFCI outlets and GFCI Circuit Breakers
may cause this equipment to function improperly.
POWER REQUIREMENTS
4 9.45TV TREADMILL
Open the boxes:
Open the boxes of your new equipment. Inventory all parts included in the boxes, and compare them to the Supplied
Components and Supplied Hardware lists on pages 5-6 for a full count of the parts included. If you are missing any
parts or have any questions contact us directly at 888-800-1167
*Assembly instructions are on pages 19-31.
Gather your tools:
Before you begin, make sure that you have gathered all the necessary tools you may require to assemble the unit
properly. Having all of the necessary equipment at hand will save time and make the assembly quick and hassle-free.
Clear your work area:
Make sure that you have cleared away a large enough space to properly assemble the unit. Make sure the space is
free from anything that may cause injury during assembly. After the unit is fully assembled, make sure there is a
comfortable amount of free area around the unit for unobstructed operation.
Invite a friend:
Some of the assembly steps may require heavy lifting. It is recommended that you obtain the assistance of another
person when assembling this product.
User Weight Limitation:
Please note that there is a weight limitation for this product. If you weigh more than 400LBS (Approx. 182 Kgs). It is
not recommended that you use this product. Serious injury may occur if the user’s weight exceeds the limit shown
here. This product is not intended to support users whose weight exceeds this limit.
Care and maintenance:
The safety level can be maintained only if it is examined for damage and wear.
Replace any defective components immediately and stop all use of the equipment until repaired.
Always take care when mounting the equipment. Straddle the equipment by placing your feet on the straddle rails.
Dismount from the equipment only after all parts have stopped.
Always check the wear and tear components like pulley, belts, etc.…To prevent injury.
There is an emergency stop, in the form of a SAFETY KEY, to prevent injury; you can stop the treadmill immediately
b
BEFORE YOU BEGIN
y actuating the emergency stop for emergency dismount.
www.smoothfitness.com
SUPPLIED COMPONENTS
This list identifies the major components you will use to assemble this product.
5
No. Description Qty.
A
Computer
1
B Front Handlebar Assembly 1
C Handlebar 2
D Upright Assembly Left 1
E Upright Assembly Right 1
F Main Frame Assembly 1
This list identifies the hardware you will use to assemble the product. To help distinguish between
the various types of screws and bolts, use the scale below to measure them and compare them to
he sizes listed. t
No. Description Qty.
804
M8 × 15mm Bolt
2
805 M8 × 50mm Bolt 12
806 # 8 × 20mm Screw 18
4 × 15mm Thread Cutting
807
Screw
19
826 M8 Nylon Nut 2
843 M8 × 15 mm Allen Head Bolt 4
845 13 × 42mm Shaft 2
846 #8 × 23mm Washer 2
A 5mm Allen Key 1
B 8mm Allen Key 1
C Screwdriver 1
D 5mm Allen Wrench 1
E Spanner 1
F 6mm Allen Wrench
1
826
804
805
843
B
CEA
806
845
807
846
D
F
MILLIMETERS
www.smoothfitness.com
7
SUPPLIED COMPONENTS
These instructions are for the TV attachment. Prior to assembling the TV attachment, lease follow
the product assembly instructions to complete the treadmill assembly.
TV attachment parts list :
No. Description Qty.
1 TV screen 1
2 TV screen suspension pad1
3 M6 × 10 Bolt 4
4 TV bracket 1
5 M5 × 10 Bolt 4
6 M3 × 10 Bolt 10
7 M6 × 10 Allen head bolt 2
8 Pivot side cover 2
9 Pivot bushing 2
10 M8 × 45 Allen head bolt 1
11 Pivot top cover 1
12 Spacer 1
13 Pivot shaft 1
14 Pivot bottom cover 1
15 TV bracket support tube 1
16 Support tube cover 2
18 Cable wire 1
19 TFT TV 8Pin wire 1
20 Extra Speaker 2
Overlay
Computer Insert
Console PC Board
Console Housing – Upper
Console Housing – Bottom
Safety Key Base
Safety Key
Safety Key Wire – Upper
Computer Wire – Upper
Computer Ground Wire
Hand Pulse Wire – Upper
E – Prom
Motion Control Board
Motion Control Board Wire
Motion Control Sensor Wire
Water Bottle Holder
Complete Handle Bar Components
Handle Bar Upright
Handle Bar Upright Foam Grip
Front Handle Bar
Front Handle Bar Foam Grip-Short
Front Handle Bar Foam Grip-Long
Hand Pulse Set
Motion Control
Motion Control Base
Base Frame
Safety Key Wire – Lower
Computer Wire –Lower
Power Switch Plate Cover
Power Switch Plate
Power Breaker
Power Switch
Bushing
Fix Bolt Sets
Front Caster
Rubber Cushion
Level Adjuster
Base Frame End Cap
Cushion
I/O Console
Shock
Complete Motor Components
Motor Hood
Elevation Motor
Elevation Gear Sleeve
Driving Motor
Motor Holder
Driving Belt
Motor Control Board
Elevation Control Board
Elevation Support Tube
Elevation Support Tube Cover - LEFT
Motor Bottom Cover
Deck Frame Side Cover - LEFT
Plastic Clamp - TOP
Plastic Clamp - BOTTOM
Elevation Support
Deck Rubber Cushion
Rear Vent Cover
Elevation Support Tube Cover - RIGHT
Deck Frame Side Cover – RIGHT
Complete Running Deck Components
Running Belt
Side Rail
Running Deck
Side Rail End Cap - LEFT
Side Rail End Cap - RIGHT