Sharp XG-V10XU, XG-V10XM, XG-V10WM, XG-V10WU User Manual 2

How to Connect a Sharp Projector to a Network

NOTE: IP Address is Static - verify with

IT / MIS Department.

1.) AN-L10T Installation

2.) Projector Configuration

3.) S.A.P.S. Configuration

Refer to Operation Manual - page 5

Refer to O/M page numbers 2 - 3 for details

There are (4) four items to configure

on the projector menu.

Refer to Operation Manual - page 6

Refer to Operation Manual - page 7

Refer to Operation Manual - page 4

Must be

obtained from

IT / MIS

Department

Quick Reference Guide

Applicable Models: XG-V10WU XG-V10XU B.) Set IP Address

XG-V10WM XG-V10XM

Quick Reference Guide Sections:

1.) Install Lan Card into expansion slot on A/V connector side of the projector

C.) Set Gateway

2.) Configure Projector Menu

A.) Set ID Number B.) Set IP Address C.) Set Gateway D.) Set Subnet Mask

A.) Set ID Number D.) Set Subnet Mask

L:\tekcentr\cactrain\qck_ref.xls

3:18 PM

10/12/2001

How to Connect a Sharp Projector to a Network

Refer to Operation Manual - page 8

Refer to Operation Manual - page 14

Refer to Operation Manual - page 10 - 11

Refer to Operation Manual - page 15

Refer to Operation Manual - page 12

Refer to Operation Manual - page 16

Refer to Operation Manual - page 14

Quick Reference Guide

3.) Configure S.A.P.S.

A.) Select Multiple control setting

E.) Configure E-Mail Sending Criteria

B.) Set the following fields under the projector setting menu

ID # Port IP Address F.) Configure E-Mail Sender Settings Option

Check use projector

C.) Set the "Projector Name"

D.) Insert E-Mail Address in E-Mail Address Book

G.) Scan for Network Configured Projector

Any Problems

call 1-888-Go-Sharp

(1-888-467-4277)

L:\tekcentr\cactrain\qck_ref.xls

3:18 PM

10/12/2001