SEKONIC L-308DC service manual

DC

L-3 0 8

Quick Guide

DC

L-3 0 8

Quick Guide

POWER button LUMISPHERE

MODE button

Liquid Crystal
Display(LCD)

ISO button

Flash Synchro terminal
Cord mode: Attach ash Cord.
Push MEASURING button to trigger ash and measure light.

MEASURING
button

UP button

DOWN button

LCD SCREEN

Battery Indicator

Frame Rate, Shutter Angle
Illuminance, Shutter Speed

Measuring Mode

g

An

lx
fc

EV

Aperture, EV

ISO Display

Custom setting

●

1) To enter the custom setting mode, hold the
MODE button and then press the POWER button
to turn the meter ON.

Custom setting Item

CS number

2) Press the UP button or DOWN button to select
the desired custom setting number.

3) The Custom setting item will change each time
the MODE button is pressed.

CS No. Custom Setting Group Custom Setting Item

CS1 Display mode

“HD_C”

CS2 Increments of T & F

“1.0” “0.5”

CS3 Simplied illuminance

HD_CINE CINE

Full 1/2 1/3

“CINE” “PHOTO”

No Display Lux FC

“N ON E” “ lx ” “fc”

4) Press POWER button to exit Custom Setting
mode.

JE2297610

“0.3”

DC

L-3 0 8

Quick Guide

Measuring / Setting mode in each Display mode

●

Press the MODE button to select a Measuring / Setting mode.

HD CINE mode

Shutter Speed
Priority mode

Simplied
Illuminance mode

Frame Rate
Setting mode

Press MODE button

to select

CINE mode

Frame Rate
Prioirty mode

Simplied
Illuminance mode

Shutter Angle
Setting mode

Press MODE button

to select

PHOTO mode

Shutter Speed
Priority mode

Press MODE button

Cord Flash mode

to select

EV mode
(Ambient mode)

Auto-reset cordless
ash mode

Hold ISO button, and press MODE button to return to the
previous Measuring / Setting mode.

DC

L-3 0 8

Quick Guide

Common operation in each mode

●

Set ISO

Hold ISO button, and press the UP/DOWN buttons.

Use as Incident Meter

Slide Lumisphere over meter cell.

Use as Reected Meter

Slide Lumisphere away to expose meter cell.

Measure Illuminance or Brightness /Contrast Dierence

Clip in at Lumidisc over meter cell.

Calibration compensation function

●

Calibration compensation can be made in precise 1/10
step increments in a +/- 1.0 EV range.
The calibration compensation can be set independently
in each Display mode. Select the Display mode in
advance in the custom setting function.

1) To enter the calibration compensation
mode, hold the ISO button
and press the POWER button
to turn the meter ON.

Calibration
compensation

2) Select the compensation
amount by pressing the
UP or DOWN button.

3) Press POWER button to
exit calibration compensation
mode.

Setting
Display mode

Compensation
amount