Seco-Larm SK-919TD1S-UPQ Specsheet

Copyright 2015 © SECO-LARM U.S.A, I nc. Al l right s r eser ved.

16842 Millikan Ave, Irvine, CA 92606

1-Channel RF Transmitters and Receiver

SK-919TD1S-UP 1-Button Pre-Coded Transmitter
SK-919TT1S-BU

1-Button DIP-Switch Coded Transmitter

• Range: Up to 500ft (152m)*, 315MHz

SK-910RBQ Specifications:

Operating frequency

315MHz

Memory capacity

15 Transmitter button codes

Operating voltage

11~24 VAC/VDC

Operating
current

Standby

8mA@12VDC

Active

30mA@12VDC

4-Sec momentar y, 1-sec momentary,

toggle, latch, validity

Relay contact rating

Form C 10A@24VDC/120VAC

Screw terminals: Power (+,-)

1 relay (NO/NC/COM)

Dimensions

37/16”x37/16”x11/8” (87x87x28 mm)

SK-919TP1H-BUQ 1-Button Handheld Transmitter

• Range: Up to 500ft (152m)*, 315MHz

Compatible with all 315MHz SECO-LARM receivers

SK-910RBQ 1-Channel Receiver

• Five programmable relay output modes:

SK-919TD1S-UP

SK-919TP1H-BUQ

SK-910RBQ

*Actual range will vary gr eatly depending on the installation and operating environment

Also Available from SECO-LARM®:

SK-91ERSD

Increase range up to 1,000ft
Range Antenna

• LED Transmission indicator

• Includes 12VDC alkaline battery

• SK-919TD1S-UP: Over 68 billion possible codes

• SK-919TT1S-BU: Use to code many transmitters with the same

code, or to match a transmitter already in use

• Compatible with all 315MHz SECO-LARM rec

• Over 68 billion possible codes

• Includes two 3VDC lithium batteries

• Visor clip and belt clip included. Belt-clip holster and wall-mount

bracket also available (model #: SK-9HBC)

• Slimline design

• Low battery indicator – LED flashes when battery drops below 2VDC

•

eivers

- 4-Second momentary

- 1-Second momentary

- Toggle (ON/OFF)

- Latch

- Validity

• 11~24 VAC/VDC Operation

• Range: Up to 500ft (152m)*, 315MHz

• Controls garage doors, gates, house lights, alarm panels or other

devices via remote

• LED Indicates RF reception, learn mode entered, transmitter
learned, memory cleared, and relay output mode

• Pushbutton programming, no need to cut jumpers

• Up to 15 transmitter button codes can be learned

• Compatible with all 315MHz SECO-LARM transmitters

Tel: [phone] • Fax: [phone]
[e-mail] • www.seco-larm.com

(304m)* with the Extended

Relay output modes

Connectors

The SECO-LARM policy is one of continua l development. For that reason, S ECO-LARM reserves the right to

change prices and specifications without not ice. SECO-LARM is not respons ible for mis prints.

PiSK-910RBQ_1-Channel RF Transmitters and Receiver_150515.pdf