Schneider Electric APVS9601 User Manual
Important Safety Information
Read the instructions carefully and look at the equipment to become familiar with the device before trying to
install, operate, service or maintain it. The following special messages may appear throughout this document or on
the equipment to warn of potential hazards or to call attention to information that
clarifies or simplifies a procedure.
The addition of this symbol to a Danger or Warning product safety label indicates
that an electrical hazard exists that will result in personal injury if the instructions are
not followed.
This is the safety alert symbol. It is used to alert you to potential personal injury
hazards. Obey all safety messages that follow this symbol to avoid possible injury or
death.
DANGER
DANGER indicates a hazardous situation which, if not avoided, will result in death or serious injury.
WARNING
WARNING indicates a hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION
CAUTION indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
NOTICE
NOTICE is used to address practices not related to physical injury.
User Manual
Easy UPS
SNMP Card APVS9601
2
SNMP Card APVS9601
Product Description
Integrated with SchneiderUPS software, devices with the SNMP Card installed can be monitored and controlled in the
LAN. These devices can manage using SNMP Protocol versions 1, 2c and 3 standards.
APVS9601 SNMP Card:
Provides support for SchneiderUPS Network Shutdown.
Supports using a Dynamic Host Configuration Protocol (DHCP) to provide the network (TCP/IP) values of the
NMC.
Devices in which you can install the SNMP Card
The SNMP Card can be installed in any compatible device that has an Intelligent Card Slot, including:
Easy UPS On-Line: SRV series UPS
Package Contents
The packaging is recyclable; save it for reuse or dispose of it properly.
(1)
SNMP Card
(1)
User manual
(1)
Utility CD
Disclaimer
Schneider Electric is not responsible for damage sustained during reshipment of this product.
The SNMP Card is sensitive to static electricity. When handling the SNMP Card, touch only
the end plate while using one or more of these electrostatic-discharge devices (ESDs): wrist
straps, heel straps, toe straps, or conductive shoes.
Please recycle
The shipping materials are recyclable. Save them for later use, or dispose of them
appropriate.
3
SNMP Card APVS9601
Product Overview
Front Panel
Sensor port
Connects SNMP card to temperature or
smoke sensor.
10/100 Base-T connector
Connects SNMP card to the Ethernet
network.
Status LED
See “Status LED”.
Status LED
Color LED
Condition
Description
100M LED (Green)
Flash
Port is operating at 100Mbit/s
Off
Card is not connected to the network
10M LED (Yellow)
Flash
Port is operating at 10Mbit/s
Off
Card is not connected to the network
Loading...