These switches are manually operated devices adaptable to
a wide variety of applications in pneumatic control systems.
They are normally used to perform diverting or supply and
exhaust functions to operate final control components or
index relays in multiple switching systems.
The 2392-504 is a four-branch switch. The 2392-505 is a
five-branch switch that provides one blocked port in each
knob position.
The 2393-504 is a four-branch switch which can be used to
supply a signal to any one of three devices or supply any one
of three signals to a device. Its unused ports are blocked.
Various dials are available for each model and for specific
switch applications.
Table-1 Ordering Data.
Number
2392-504 S520 2-Position - 4 branch
2392-505 S521 2-Position - 5 branch (unused ports blocked)
2393-504 S530 3-Position - 4 branch (unused ports blocked)
For Dial Plate Ordering Data, see page 2.
Table-2 Mounting Brackets.
Number
MCS-S-P Socket Kit
Replaces
Model
Replaces
Model
22-155 K511 Single switch bracket
22-120 Socket
Description
Description
239x-5xx Series
Two and Three Position
Selector Switches
Data Sheet
Material:
Case, Glass-filled nylon
Dial Plates, Anodized aluminum.
Knob, Black sunburst plastic with pointer.
GENERAL INSTRUCTIONS
These devices are to be used on clean, dry, oil free control air
only, and will operate properly when mounted in any position.
The inherent reliability of these devices is enhanced and
prolonged through regular inspection and preventive
maintenance by a qualified control expert. Should any of
these devices become inoperative, it should be replaced by a
new unit.
Caution: This device should be installed by a qualified
service technician with due regard for safety, as improper
installation could result in a hazardous condition.
Table-3 Replacement Parts.
Number
22-173 K550 Replacement knob
Replaces
Model
Description
SPECIFICATIONS
Main Air Pressure: 30 psig maximum.
Air Capacity: 40 scfh
Air Consumption: None
Maximum Ambient Temperature: 140°F
Mounting: Designed for use on 22-120 Pneumodular
manifold socket. These devices can also be mounted by
using the appropriate mounting bracket (see Mounting
Bracket ordering data).
Connections: Barbed nipples for 1/4" OD polyethylene or
5/32" ID polyurethane tubing.
Printed in U.S.A. 1/10 © Copyright 2010 Schneider Electric All Rights Reserved. F-24573-4
On October 1st, 2009, TAC became the Buildings b usi ness of its par ent comp any Schneider Electric. Thi s document r e flec ts the visual identity of Schneider Electric,
however there remains references to TAC as a corporate brand in the body copy. As each document is updated, the body copy will be changed to reflect appropri ate
MOUNTING INSTRUCTIONS
Panel Mounting
Inside: These devices have been designed to be mounted on a 22-120 socket. One
socket, one gasket and two mounting screws are required in addition to the appropriate
manifold backplate.
Surface: These devices may also be mounted on a panel face (1/2” maximum panel
thickness) by using a 1-1/64” mountin g hole.
Field Mounting
These devices may also be mounted without the backplate, socket or gasket to replace
competitive and old Robertshaw devices by using the appropriate mounting bracket as
shown in the ordering information chart on page 1.
TYPICAL APPLICATION
Automatic or Manual Changeover of Day/Night System
In position 1, the switch will connect ports 1 and 5 supplying 16 psig main air
pressure to the thermostat for day operation.
In position 2, the switch will connect ports 2 and 5 supplying either 16 psig
main air pressure for day operation, or 25 psig main air pressure for night
operation, to the thermostat from an E-P relay being controlled by a
programmed timer.
In position 3, the switch will connect ports 3 and 5 supplying 25 psig main air
pressure to the thermostat for night operation.
MOUNTING DIMENSIONS
corporate brand changes.
Copyright 2010, Schneider Electric
All brand names, trademarks and registered
trademarks are the property of their respective
owners. Information contained within this
document is subject to change without notice.
F-24573-4