Removing the door window
IMPORTANT!
1
2
3
6
11
8
4
5
7
12
10
333 446
Work description
1. Remove the blanking pieces (5) and the armrest (4).
2. Undo the door moulding (1).
The door moulding must be lifted upwards as the hooks on the lower edge will otherwise come off.
3. Remove the scraper strip (2).
4. Prise off the switch panel (9) and the boarding step lighting (10) and disconnect
the connectors.
Work description
03:43-00 Issue 1 en-GB 1 (3)
©
Scania CV AB 2012, Sweden
Removing the door window
5. Unhook the opening cable on the back of the door trim panel (7).
6. Lift the door trim panel upwards and outwards.
7. Remove the blanking piece (8).
Work description
03:43-00 Issue 1 en-GB 2 (3)
©
Scania CV AB 2012, Sweden
Removing the door window
1
2
200 625
8. Wind down the door window, so that the window winder arm (6) is visible in the
hole where the blanking piece was fitted.
9. Suspend the door window with suction cups to prevent it from sliding down.
10. Remove the locking clamp.
11. Detach the window winder arm.
12. Remove the door panel retaining screws (11).
13. Lift the door panel upwards and outwards, and push at the same time the door
lock opening cable through the panel.
14. Drill out the pop rivets in the door window guide rail (3), and remove the screws.
15. Lift out the guide rail and door window from the door.
Work description
03:43-00 Issue 1 en-GB 3 (3)
©
Scania CV AB 2012, Sweden
Loading...