Page 1
Removing the AC compressor
WARNING!
Environment
General
Applies to 16 litre engines with XPI.
• Always use personal protection equipment when working with refrigerant.
• Refrigerant could cause frostbite injury if it comes into contact with the skin.
• Immediately contact a doctor if the refrigerant comes into contact with the eyes.
• Do not rub! Flush immediately with plenty of water, preferably running water.
• Welding, smoking or heating are not allowed if there is refrigerant present in the
air. Refrigerant generates a very toxic gas when heated.
Work on the air conditioning system must be carried out in compliance with the legislation of the country in question.
General
03:06-00 Issue 1 en-GB 1 (4)
©
Scania CV AB 2012, Sweden
Page 2
Removing the AC compressor
Remove the parts marked in grey
Work description
1. Wash the engine.
2. Remove the alternator.
Work description
315 374
03:06-00 Issue 1 en-GB 2 (4)
©
Scania CV AB 2012, Sweden
Page 3
Removing the AC compressor
Charge air pipe
3. Remove the charge air pipe between the turbocharger and the charge air cooler.
Work description
315 375
03:06-00 Issue 1 en-GB 3 (4)
©
Scania CV AB 2012, Sweden
Page 4
Removing the AC compressor
4. Undo the alternator bracket from the cylinder block. Move the alternator bracket
so that it is possible to access the screws securing the AC compressor to the alternator bracket.
– Undo the AC compressor.
– Lift off the alternator bracket.
– Remove the AC compressor.
Work description
x3
1
2
x5
315 376
03:06-00 Issue 1 en-GB 4 (4)
©
Scania CV AB 2012, Sweden
Loading...