Scania A80, A30 Service Manual
00:45-51
Issue 3
Dismantling information
Scania Touring
Scania - Higer A80, A30
Work description
en-GB
©
Scania CV AB 2013, Sweden
General ...................................................................................................... 3
Draining and removing ........................................................................ 4
Climate system .............................................................................................. 4
Identification of materials for recycling ......................................... 7
General .......................................................................................................... 7
Polymeric materials ....................................................................................... 8
Glass fibre and glass ................................................................................... 11
Aluminium .................................................................................................. 12
Steel and copper .......................................................................................... 13
Colour codes ............................................................................................... 15
©
Scania CV AB 2013
General
This information is aimed at everyone dealing
with reconditioning and scrapping of Scania
vehicles. The information applies to workshops
as well as companies specialising in dismantling and recycling.
The information is applicable to Scania Touring bus bodywork. However, not all parts are
covered in this information booklet. The information is by no means complete.
The first section describes how hazardous
waste is to be separated from the vehicle (environmental disposal).
The purpose of the second section is to facilitate identification and sorting of material for
recycling.
General
00:45-51 Issue 3
©
Scania CV AB 2013 3 (15)
Draining and removing
WARNING!
WARNING!
Draining and
removing
Climate system
Tool
Number Designation Illustration Tool board
587 627 Recycling station -
Refrigerant R134a
Wear protective gloves and goggles.
Welding, smoking or heating are not allowed if
there is refrigerant in the air. Refrigerant generates a very toxic gas when heated.
4 (15)
©
Scania CV AB 2013 00:45-51 Issue 3
1. Connect the recycling station hoses to the
IMPORTANT!
1. Service valve, low-pressure
2. Service valve, high-pressure
low-pressure and high-pressure service
valves.
2. Drain the refrigerant slowly.
The refrigerant must not be released into the
atmosphere and must be recycled according to
local regulations.
Draining and removing
00:45-51 Issue 3
©
Scania CV AB 2013 5 (15)
Loading...