SARGENT 776 User Manual
INSTALLATION INSTRUCTIONS
773, 774, 775, & 776 Electromechanical Exit Trim Solenoid
Locks & 54-Prefix (Lever Monitor Switch) to ElectroLynx™
Connector System
General Description
This manual includes instructions for wiring all 700 series electromechanical trims to the
ElectroLynx connector system. The correct wiring configuration must be selected depending
on type and function of the trim being installed. Refer to table of contents to select appropriate wiring instruction for product being installed.
Important
• Disconnect all input power before beginning installation to prevent electrical shock and equipment damage
• Installer must be a trained, experienced service person
• All wiring must comply with applicable local electrical codes, ordinances and regulations
CAUTION:
The DC voltage applied to the lock must not exceed 13.5VDC for 12 Volt models and 27VDC for
24 Volt models. If the voltage exceeds these values, the solenoid may be damaged.
Specifications / Functions
Solenoid
Type: 12 or 24VDC, Intermittent or Continuous Duty
Current draw is .50Amp @ 12VDC and .25Amp @ 24VDC
Built-in full wave bridge rectification
Fail Safe Models:
773 without cylinder
775 with cylinder
Fail Secure Models:
774 without cylinder
776 with cylinder
54- (prefix for lever monitor switch) The switch monitors outside lever rotation.
Switch contact rating: 2Amp max @ 30VDC.
Copyright © 2013, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
3/4/13
1 1-800-810-WIRE • www.sargentlock.com • A7725B
Installation Notes
1. With new applications, a raceway harness with 8 & 4-pin connectors will be pre-installed inside
door by ASSA ABLOY door manufacturer when specified during the ordering process. Raceway
harness kits are also available for retrofit applications.
2. If door does not have a raceway harness with connectors, consult factory for raceway harness
retrofit kit or cut connectors off product and hardwire as required.
3. Wiring to pigtail harness is per facility wiring requirement. Follow individual instructions below.
Connector System notes:
The system is designed to be installation friendly with connectors from the electric hinge through
the door to the lock. The only wiring is to the loose wires on the pigtail harness assembly on the
frame side of the electric hinge.
IMPORTANT:
The plug and receptacle connectors are designed to mate and lock together (Fig. 1). Plug the
connectors into each other with the locking mechanism aligned as indicated.
Do NOT force connectors on any other way.
8-Pin Connector
Receptacle
Locking mechanism
Plug
Fig. 1
Copyright © 2013, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
3/4/13
2 1-800-810-WIRE • www.sargentlock.com • A7725B
Loading...