The information described in this SPEC is can not be changed without SEC’s permission.
APPROVED BY :
PREPARED BY : LCD Application Engineering Group, Marketing Team
H.W. Park
SAMSUNG ELECTRONICS CO., LTD.
SEC Secret
Doc.No.Rev.NoPage/ 30LTN154AT14-L011
04-A02-S-110909
CONTENTS
Aproval
Revision History
General Description
1. Absolute Maximum Ratings
1.1 Absolute Ratings of environment
1.2 Electrical Absolute Ratings
2. Optical Characteristics
3. Electrical Characteristics
3.1 TFT LCD Module
3.2 Backlight Unit
4. Block Diagram
4.1 TFT LCD Module
4.2 Backlight Unit
5. Input Terminal Pin Assignment
5.1 Input Signal & Power
5.2 LVDS Interface
5.3 Backlight Unit
5.4 Timing Diagrams of LVDS For Transmitting
5.5 Input Signals, Basic Display Colors and Gray Scale of Each Color.
5.6 Pixel format
- - - - - - - - - - - - - - - - - - - ( 3 )
- - - - - - - - - - - - - - - - - - - ( 5 )
- - - - - - - - - - - - - - - - - - - ( 6 )
- - - - - - - - - - - - - - - - - - - ( 8 )
- - - - - - - - - - - - - - - - - - - ( 12 )
- - - - - - - - - - - - - - - - - - - ( 15 )
- - - - - - - - - - - - - - - - - - - ( 16 )
6. Interface Timing
6.1 Timing Parameters(DE Mode)
6.2 Timing Diagrams of interface Signal (DE Mode)
6.3 Power ON/OFF Sequence
7. Outline Dimension
8. Product Markings and Others
9. General Precautions
10. EDID
- - - - - - - - - - - - - - - - - - - ( 21 )
- - - - - - - - - - - - - - - - - - - ( 23 )
- - - - - - - - - - - - - - - - - - - ( 25 )
- - - - - - - - - - - - - - - - - - - ( 26 )
- - - - - - - - - - - - - - - - - - - ( 28 )
SEC Secret
Doc.No.Rev.NoPage/ 30LTN154AT14-L012
04-A02-S-110909
REVISION HISTORY
Aproval
DateRevision No.Page
Aug. 29. 2011A00AllApproval specification of LTN154AT14-L01 model spec was
Sep. 7. 2011A01p. 4
p. 17
Sep. 9. 2011A02p. 17FPC pin assignment of BLU unit was updated.
issued first for Panasonic.
Green product was added on the features.
No. 10 (FPC pin) was changed from FB4 to PWR.
Summary
SEC Secret
Doc.No.Rev.NoPage/ 30LTN154AT14-L013
04-A02-S-110909
Aproval
GENERAL DESCRIPTION
DESCRIPTION
LTN154AT14-L01 is a color active matrix TFT (Thin Film Transistor) liquid crystal display
(LCD) that uses amorphous silicon TFT as a switching devices. This model is composed of
a TFT LCD panel, a driver circuit and a backlight system. The resolution of a 15.4" contains
1,280 x 800 pixels and can display up to 262,144 colors. 6 O'clock direction is the Optimum
viewing angle.
FEATURES
• High contrast ratio, high aperture structure
• 1280 x 800 pixels resolution
• Low power consumption
• Fast Response
• DE (Data enable) only mode
• 3.3V LVDS Interface
• Onboard EEDID chip
• LED BLU
• Color gamut 45%
• Green product (RoHS comply product)
APPLICATIONS
• Notebook PC and desktop monitors
•If the usage of this product is not for PC application, but for others, please contact SEC
GENERAL INFORMATION
ItemSpecificationUnitNote
Display area331.2(H) X 207.0(V) (15.4”diagonal)
Driver elementa-si TFT active matrix
Display colors262,144
Number of pixel1280 x 800 ( 16 : 10, Wide XGA )
Pixel arrangementRGB vertical stripe
Pixel pitch
0.25875(H) x 0.25875(V)
mm
pixel
mm
Display ModeNormally white
Surface treatmentHAZE 25, HARD-COATING 3H, AG
SEC Secret
Doc.No.Rev.NoPage/ 30LTN154AT14-L014
04-A02-S-110909
Mechanical Information
ItemMin.Typ.Max.UnitNote
Horizontal (H)343.5344.0344.5mm
Module
size
Note (1) Measurement condition of outline dimension
Note (1) Temperature and relative humidity range are shown in the figure below.
95 % RH Max. ( 40 OC ≥ Ta)
Maximum wet - bulb temperature at 39 OC or less. (Ta > 40 OC) No condensation.
(2) 3ms, half sine wave, one time for ±X,±Y,±Z.
(3) 18ms, Trapezoidal wave, one time for ±X,±Y,±Z.
(4) 5~500 Hz, Random vibration, 30 min for X,Y,Z.
(5) At testing Vibration and Shock, the fixture in holding the Module to be tested have to be
hard and rigid enough so that the Module would not be twisted or bent by the fixture.
100
95
80
60
STG
T
OPR
Relative Humidity ( %RH)
Operating Range
-20 60C(1)
050C(1)
210
G
50(3),(5)
(2),(5)
40
20
8
Storage Range
5
0
-40-20020406080
Temperature (OC)
SEC Secret
Doc.No.Rev.NoPage/ 30LTN154AT14-L015
04-A02-S-110909
1.2 ELECTRICAL ABSOLUTE RATINGS
Aproval
(1) TFT LCD MODULE
ItemSymbolMin.Max.UnitNote
Power Supply VoltageVDDVDD - 0.3VDD + 0.3V(1)
Logic Input VoltageVINVDD - 0.3VDD + 0.3V(1)
NOTE (1) Within Ta ( 25 ± 2 OC )
VDD =3.3V, VSS = GND = 0V
(2) BACK-LIGHT UNIT
ItemSymbolMinTyp.Max.UnitNote
LED CurrentI
LED VoltageF
NOTE (1) Permanent damage to the device may occur if maximum values are exceeded.
Functional operation should be restricted to the conditions described under Normal Operating
Conditions.
L
V
-18-mA(1)
-3.2-V(1)
Ta = 25 2 C
SEC Secret
Doc.No.Rev.NoPage/ 30LTN154AT14-L016
04-A02-S-110909
Aproval
2. OPTICAL CHARACTERISTICS
The following items are measured under stable conditions. The optical characteristics
should be measured in a dark room or equivalent state with the methods shown in Note (5).
Measuring equipment : TOPCON SR-3
Note 1) Definition of Viewing Angle : Viewing angle range (10≤ C/R at center point )
Normal Line
o
,
= 0
o
R
12 o'clock
direction
y
H= 90
L =90
= 0
L
o
x
L
H
o
6 o'clock
direction
o
L= 90
x'y'
R=90
Note 2) Definition of Contrast Ratio (CR) : Ratio of gray max (Gmax) ,gray min (Gmin)
at 5 points(4, 5, 7, 9, 10)
CR(4) + CR(5) + CR(7) + CR(9) + CR(10)
CR =
5
POINTS : , 5 , , , at FIGURE OF NOTE 6)
49
7
10
Note 3) Definition of Response time :Note 3) Definition of Response time : Sum of TR ,TF
o
Display data
Optical
Response
White(TFT OFF)White(TFT OFF)
TR
Black(TFT ON)
TF
100%
90%
10%
0%
Time
SEC Secret
Doc.No.Rev.NoPage/ 30LTN154AT14-L018
04-A02-S-110909
Note 4) Definition of Luminance of White : measure the luminance of white at 5 points.
Aproval
(320)(640)
Average Luminance of White ( YL,AVE )
10
YL4 + YL5 + YL7 + YL9 + YL10
YL,AVE =
5
5
Note 5) After stabilizing and leaving the panel alone at a given temperature for 30 min , the measurement
should be executed. Measurement should be executed in a stable, windless,and dark room.
30 min after lighting the back-light. This should be measured in the center of screen.
LED current :20mA
Environment condition : Ta = 25oC ±2 oC
(960)
VIEW AREA
9
7
4
(200)
(400)
(600)
(lines)
TFT-LCD module
Photo-detector
( TOPCON SR-3)
Field = 2
o
SR-7 : 50 cm
LCD panel
center of the screen
Optical characteristics measurement setup
SEC Secret
Doc.No.Rev.NoPage/ 30LTN154AT14-L019
04-A02-S-110909
Loading...
+ 21 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.