SAMSUNG LTN150XB-L03 Specification

Global LCD Panel Exchange Center
SAMSUNG TFT-LCD
MODEL NO.:LTN150XB-L03
www.panelook.com
Approval
Any Modification of Spec is not allowed without SEC’ permission
APPROVED BY :
SAMSUNG ELECTRONICS CO., LTD.
Doc.No. Rev.No Page / 24LTN150XB-L03 104-A00-G-030321
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
www.panelook.com
Global LCD Panel Exchange Center
CONTENTS
www.panelook.com
Approval
Revision History
General Description
1. Absolute Maximum Ratings
1.1 Absolute Ratings of environment
1.2 Electrical Absolute Ratings
2. Optical Characteristics
3. Electrical Characteristics
3.1 TFT LCD Module
3.2 Backlight Unit
4. Block Diagram
4.1 TFT LCD Module
4.2 Backlight Unit
5. Input Terminal Pin Assignment
5.1 Input Signal & Power
5.2 LVDS Interface
5.3 Backlight Unit
5.4 Timing Diagrams of LVDS For Transmitting
5.5 Input Signals, Basic Display Colors and Gray Scale of Each Color.
5.6 Pixel format
-------------------( 3 )
-------------------( 4 )
-------------------( 5 )
-------------------( 7 )
-------------------( 10 )
-------------------( 13 )
-------------------( 14 )
6. Interface Timing
6.1 Timing Parameters(DE Mode)
6.2 Timing Diagrams of interface Signal (DE Mode)
6.3 Power ON/OFF Sequence
7. Mechanical Outline Dimension
8. General Precautions
Doc.No. Rev.No Page / 24LTN150XB-L03 204-A00-G-030321
-------------------( 19 )
-------------------( 22 )
--------------------( 23 )
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
www.panelook.com
Global LCD Panel Exchange Center
www.panelook.com
Date
Feb.13, 2003 000 All
Rev.No. Summary
Page
REVISION HISTORY
REVISION HISTORY
-LTN150XB-L03 model rev.000 specification was First issued.
Approval
Doc.No. Rev.No Page / 24LTN150XB-L03 304-A00-G-030321
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
www.panelook.com
Global LCD Panel Exchange Center
GENERAL DESCRIPTION
DESCRIPTION
LTN150XB-L03 is a color active matrix TFT (Thin Film Transistor) liquid crystal display (LCD) that uses amorphous silicon TFT as a switching devices. This model is composed of a TFT LCD panel, a driver circuit and a backlight system. The resolution of a 15.0" contains 1,024 x 768 pixels and can display up to 262,144 colors. 6 O'clock direction is the Optimum
viewing angle.
FEATURES
• Thin and light weight
• High contrast ratio
• XGA ((1024x768) pixels) resolution
• Low power consumption
• DE (Data enable) only mode.
• 3.3V LVDS (FPD Link) Interface with 1 pixel / clock
• EDID,SPWG-B style
www.panelook.com
Approval
APPLICATIONS
• Notebook PC and desktop monitors
• Display terminals for AV application products
• Monitors for Industrial machine
• If the usage of this product is not for PC application, but for others, please contact SEC
GENERAL INFORMATION
ITEM SPECIFICATION
Display area 304.128(H)X228.096(V) (15.0”diagonal)
Driver element a-si TFT active matrix
Display colors 262,144
Number of pixel 1024 x 768
Pixel arrangement RGB vertical stripe
UNIT
mm
pixel
mm
NOTE
Pixel pitch 0.297(H) x 0.297(V)
Normally whiteDisplay Mode
Surface treatment HAZE 25, HARD-COATING 3H
Doc.No. Rev.No Page / 24LTN150XB-L03 404-A00-G-030321
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
www.panelook.com
Global LCD Panel Exchange Center
www.panelook.com
Mechanical Information
ITEM TYP. MAX. NOTE
Horizontal (H)
Module
size
Note (1) Measurement condition of outline dimension
Vertical (V)
Depth (D) -
Weight
. Equipment : Vernier Calipers . Push Force : 500g f (minimum)
MIN.
316.8
241.4
1. ABSOLUTE MAXIMUM RATINGS
1.1 ENVIRONMENTAL ABSOLUTE RATINGS
ITEM UNIT
Storage temperate
SYMBOL MIN. MAX.
T
STG
317.3
242.0 242.6
- 6.5
585g
-25 60
317.8
605g
Approval
(1)
NOTE
O
C
(1)
Operating temperate
(Temperature of glass surface)
Shock ( non-operating )
Vibration (non-operating)
Note (1) Temperature and relative humidity range are shown in the figure below.
95 % RH Max. ( 40
Maximum wet - bulb temperature at 39 (2) 2ms, half sine wave, one time forᇹX,ᇹY,ᇹZ. (3) 10 ௥300௥10 Hz, Sweep rate 10 min, 30 min for X,Y,Z. (4) At testing Vibration and Shock, the fixture in holding the Module to be tested have to be
hard and rigid enough so that the Module would not be twisted or bent by the fixture.
O
CᆚTa)
100
95
80
60
40
T
OPR
Snop
Vnop
0
-
-
O
C or less. (Ta > 40 OC) No condensation.
Relative Humidity ( %RH)
Operating Range
50
220 G
1. 5
O
C
G
(1)
(2), (4)
(3), (4)
20
Storage Range
5
0
-40-20 0 2040 6080
Temperature (
O
C)
Doc.No. Rev.No Page / 24LTN150XB-L03 504-A00-G-030321
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
www.panelook.com
Global LCD Panel Exchange Center
www.panelook.com
1.2 ELECTRICAL ABSOLUTE RATINGS
(1) TFT LCD MODULE
ITEM SYMBOL MIN. MAX. UNIT NOTE
Power Supply Voltage Vcc
Logic Input Voltage V
NOTE (1) Within Ta ( 25 ᇹ2
O
IN
C )
Vss-0.3 4.0
Vss-0.3
(2) BACK-LIGHT UNIT
ITEM SYMBOL
Lamp current I
Lamp frequency F
L
L 50
MIN. UNIT. NOTE
2.0
Approval
( Vss = GND = 0 V)
V
VVcc + 0.3
Ta = 25 ᇹ2OC
MAX.
rms
7.0
80 KHz (1)
mA
( 1 )
( 1 )
(1)
NOTE (1) Permanent damage to the device may occur if maximum values are exceeded.
Functional operation should be restricted to the conditions described under Normal Operating Conditions.
Doc.No. Rev.No Page / 24LTN150XB-L03 604-A00-G-030321
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
www.panelook.com
Global LCD Panel Exchange Center
2. OPTICAL CHARACTERISTICS
The following items are measured under stable conditions. The optical characteristics should be measured in a dark room or equivalent state with the methods shown in Note (5). Measuring equipment : TOPCON BM-5A
www.panelook.com
Approval
* Ta = 25ᇹ2oC , Vcc=3.3V, fv= 60Hz, fDCLK=65MHz, IL= 6.0mA
ITEM SYMBOL CONDITION MIN. TYP. MAX. UNIT
Contrast Ratio
(5 Points)
Response Time at 25
Luminance of White
Color
Chromaticity
( CIE )
Rising
Falling
Red
Green
Blue
White
CR
T
T
YL
R
R
GX
GY
BX
BY
WX
WY
NOTE
200
R
F
-
-
-
-
10
30
160
20
40
-
msec
-
cd/m
2
(1), (3)
(1), (4)
φ = 0,
X
Y
θ = 0
Normal
0.546
0.311
0.576
0.341
0.606
0.371
Viewing Angle
0.293
0.502
0.123
0.102
0.283 0.343
0.299 0.359
0.323
0.532
0.153
0.132
0.313
0.329
0.353
0.562
0.183
0.162
(1), (5)
Viewing
Angle
13 Points White Variation
Hor.
Ver.
θ
L
θ R
CRᆚ10
(at center point)
φ H
φ L
L -
40
40
20
40
-
45
45
25
45
1.65
Doc.No. Rev.No Page / 24LTN150XB-L03 704-A00-G-030321
-
­Degrees
-
-
(6)
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
www.panelook.com
Global LCD Panel Exchange Center
www.panelook.com
Note 1) Definition of Viewing Angle :
θ L
o
θL=90
x
6 O’ clock direction
o
φL= 90
Note 2) Definition of Contrast Ratio (CR) :
CR1 + CR2 + CR3 + CR4 + CR5
CR =
φ L
5
Normal Line
o
θ = 0
φ = 0
,
φ H
Approval
o
θ R
12 O’ clock
y
direction
φH= 90
o
x’y’
o
=90
θ
R
POINTS : , , , , at FIGURE OF NOTE 6)
45 9
7
10
Note 3) Definition of Response time :
Display data
Optical Response
White(TFT OFF)
100%
90%
Black(TFT ON)
TR
White(TFT OFF)
TF
10%
0%
Note 4) Definition of Average Luminance of White : measure the luminance of white at 5 points.
Average Luminance of White ( Y L,AVE )
Y
L4 + YL5 + YL7 + YL9 + YL10
Y L,AVE =
Time
5
POINTS : , , , , at FIGURE OF NOTE 6)
45 9
7
10
Doc.No. Rev.No Page / 24LTN150XB-L03 804-A00-G-030321
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
www.panelook.com
Loading...
+ 17 hidden pages