Rocktron Rampage Bass 30 User Manual

Instruction Manual

Y our Rocktron Bass30 Bass Amplifier has been tested and complies with the following Standards
and Directives as set forth by the European Union:

Standard(s): IEC60065 Professional Audio/Video or Similar

Equipment, EN55013:1997, EN61000-3-2 (1995)
EN61000-3-3(1995), EN55020:1995, CSA E65-94

This means that this product has been designed to meet stringent guidelines on how much RF
energy it can emit, and that it should be immune from other sources of interference when
properly used. Improper use of this equipment could result in increased RF emissions, which may
or may not interfere with other electronic products.

To insure against this possibility, always use good shielded cables for all audio input connections.
This will help insure compliance with the Directive(s).

Specifications

OUTPUT

SPEAKER

WEIGHT

DIMENSIONS

INPUT IMPEDANCE

HEADPHONE IMPEDANCE

LINE OUTPUT JACK

EQ

EFFECTS LOOP

Copyright © 2005 GHS Corporation
All Rights Reserved.

30 W atts
Custom 10” Speaker 8 Ohms
29 lbs., 13.2KGs

18.5” (H) x 15.5” (W) x 13” (D)
470mm(H) x 394mm(W) x 331mm (D)
1M
32 Ohms or greater (600 Ohms for best results)
1/4”
4-band
Yes

Precautions

NOTE: IT IS VERY IMPORTANT THAT YOU READ THIS SECTION TO
PROVIDE YEARS OF TROUBLE FREE USE. THIS UNIT REQUIRES CAREFUL
HANDLING.

• All warnings on this equipment and in the operating instructions should
be adhered to and all operating instructions should be followed.

• Do not use this equipment near water. Care should be taken so that
objects do not fall and liquids are not spilled into the unit through any
openings.

• The power cord should be unplugged from the outlet when left unused
for a long period of time.

DO NOT ATTEMPT TO SERVICE THIS EQUIPMENT. THIS EQUIPMENT
SHOULD BE SERVICED BY QUALIFIED PERSONNEL ONLY. DO NOT MAKE
ANY INTERNAL ADJUSTMENTS OR ADDITIONS TO THIS EQUIPMENT AT
ANY TIME. DO NOT TAMPER WITH INTERNAL ELECTRONIC
COMPONENTS AT ANY TIME. FAILURE TO FOLLOW THESE
INSTRUCTIONS MAY VOID THE WARRANTY OF THIS EQUIPMENT, AS
WELL AS CAUSING SHOCK HAZARD.

OPERATING TEMPERATURE

Do not expose this unit to excessive heat. This unit is designed to operate between
32° F and 104° F (0° C and 40° C). This unit may not function properly under
extreme temperatures.