
USER'S MANUAL
May be covered by one or more of the following: U.S. Patents #4538297, 4647876, 4696044, 4745309,
4881047, 4893099, 5124657, 5263091, 5268527, 5319713, 5333201, 5402498 and 5493617.
Other patents pending. Foreign patents pending.
1

Y our Rampage pedal has been tested and complies with the following
Standards and Directives as set forth by the European Union:
Council Directive(s): 89/336/EEC Electromagnetic Compatibility
Standard(s): EN55013, EN50082-1
This means that this product has been designed to meet stringent guidelines
on how much RF energy it can emit, and that it should be immune from other
sources of interference when properly used. Improper use of this equipment
could result in increased RF emissions, which may or may not interfere with
other electronic products.
T o insure against this possibility, always use good shielded cables for all
audio input and output connections. This will help insure compliance with the
Directive(s).
Copyright © 2003 Rocktron - A Division of GHS Corporation
All Rights Reserved.
2

Introduction
Congratulations on your purchase of the Rocktron Rampage™ distortion
pedal! The Rampage™ is designed to provide ultra-high gain distortion
with very little noise.
Along with Bass, Treble, Sustain and Output level controls, the
Rampage also provides a special "Scoop" control which allows you to cut
the mids by up to 30dB.
The Rampage is housed in an ultra-rugged chassis with slightly recessed
controls to protect against any accidental bumps which might alter your
settings.
Functions
3

Functions
1 = Adjusts low frequency levels
2 = Adjusts mid frequency levels
3 = LED - When lit the LED indicates that the Rampage is "Active".
4 = Adjusts high frequency levels
5 = Adjusts overall volume levels
6 = Adjusts level of distortion
7 = 9 Volt DC Adapter Input
8 = Input Jack
9 = Output Jack
10 = Battery Compartment - push black tab to open compartment
11 = This switch determines whether the Rampage is "Active" or "Bypassed"
4

Using the Rampage with a power amp and speaker cabinets
6