Rocktron R10 User Manual

USER'S MANUAL
R10R10
R10
R10R10
Electric Guitar Amplifier
May be covered by one or more of the following: U.S. Patents #4538297, 4647876, 4696044, 4745309, 4881047, 4893099, 5124657, 5263091, 5268527, 5319713, 5333201, 5402498 and 5493617. Other patents pending. Foreign patents pending.
Council Directive(s): 89/336/EEC, 73/23/EEC Standard(s): EN55 013: 1990/A12:1994, EN55 020: 1988,
EN60 065: 1993, EN60 555-2: 1987, EN60 555-3: 1987/A1: 1991
This means that this product has been designed to meet stringent guidelines on how much RF energy it can emit, and that it should be immune from other sources of interference when properly used. Improper use of this equipment could result in increased RF emissions, which may or may not interfere with other electronic products.
T o insure against this possibility, always use good shielded cables for all audio input connections. This will help insure compliance with the Directive(s).
Copyright © 1999 Rocktron Corporation All Rights Reserved.
Contents
PRECAUTIONS ............................................................................. 1
Front Panel .................................................................................... 2
Back Panel .................................................................................... 2
Specifications ................................................................................ 3
Rocktron Corporation
2870 Technology Drive Rochester Hills, MI 48309 USA
Phone: Fax:
World Wide Web: E-mail:
(248) 853-3055 (248) 853-5937
http://www.rocktron.com rocktron@eaglequest.com
PRECAUTIONS
NOTE: IT IS VERY IMPORT ANT THA T YOU READ THIS SECTION TO PROVIDE YEARS OF TROUBLE FREE USE. THIS UNIT REQUIRES CAREFUL HANDLING.
• All warnings on this equipment and in the operating instructions should be adhered to and all operating instructions should be fol­lowed.
• Do not use this equipment near water. Care should be taken so that objects do not fall and liquids are not spilled into the unit through any openings.
• The power cord should be unplugged from the outlet when left unused for a long period of time.
DO NOT A TTEMPT TO SERVICE THIS EQUIPMENT . THIS EQUIPMENT SHOULD BE SERVICED BY QUALIFIED PERSONNEL ONL Y. DO NOT MAKE ANY INTER­NAL ADJUSTMENTS OR ADDITIONS TO THIS EQUIPMENT A T ANY TIME. DO NOT T AMPER WITH INTERNAL ELECTRONIC COMPONENTS A T ANY TIME. FAILURE T O FOLLOW THESE INSTRUCTIONS MAY VOID THE W ARRANTY OF THIS EQUIPMENT , AS WELL AS CAUSING SHOCK HAZARD.
OPERATING TEMPERATURE
Do not expose this unit to excessive heat. This unit is designed to operate between 32° F and 104° F (0° C and 40° C). This unit may not function properly under ex­treme temperatures.
1
Front Panel
1
1
2
3
4
5
2
INPUT jack
OVERDRIVE button
GAIN control
LEVEL control
TREBLE & BASS controls
3
Connect your guitar output to the 1/4" input jack with a shielded guitar cable.
When pressed IN, OVERDRIVE mode is engaged.
Adjusts the amount of amplification in the preamp. This sets the amount of harmonic distortion the amp will generate. Turn the knob clockwise to increase distortion and counterclockwise for a cleaner sound.
The LEVEL control adjusts the volume. While GAIN sets the amount of amplification in the preamp, LEVEL sets the volume in the last stage of the unit. Once the GAIN is set, adjust the volume with the LEVEL control.
Tone controls, or EQ. The BASS raises or lowers the amount of low frequency sound while TREBLE does the same for the high frequencies.
4
5
6
7
6
7
Back Panel
2
PHONE (Headphone) jack
Plug your headphones into this jack to bypass the power amp and practice in private.
POWER switch and LED
The switch turns the amp ON and OFF. The red LED shows the amp is ON.
R10 Specifications
Power Output
Speaker Parameters
Dimensions
Weight
Power Requirement
10 Watts 6" Velocity® High Definition by Rocktron
9.8" x 7.3" x 11.6" (250 x185 x 295mm) 8lbs. 10 oz. (3.67Kg) 100 Volts AC, 50/60Hz or 117 Volts AC, 50/60Hz
or 220/240 Volts AC, 50/60Hz, as specified on chassis
CE Approved
3
Loading...