Remington HC-60, HC-80 Use And Care Manual
(3) (4)
(5)
(6) (7)
(8)
(9)
A Superior Cut
Every Time
Use and
Care Guide
Models HC-60, HC-80
IMPORTANT SAFETY
INSTRUCTIONS
When using an electrical appliance,
basic precautions should always be
observed, including the following.
Read all instructions before using
this appliance.
DANGER
To reduce the risk of electric shock:
■ Do not reach for an appliance that
has fallen into water. Unplug it
immediately.
■ Do not use while bathing or in
the shower.
■ Do not place or drop into water
or other liquid.
■ Do not place or store this appliance
where it can fall or be pulled into a
tub or sink.
■ Except when charging, always
unplug this appliance from the
electrical outlet immediately
after using.
■ Unplug this appliance before
cleaning it.
■ Do not use outdoors or operate
where aerosol (spray) products are
being used, or where oxygen is
being administered.
■ Always store this appliance and
cord in a moisture-free area.
Do not store it in temperatures
exceeding 140°F (60°C).
■ Do not plug or unplug this
appliance when your hands are
wet.
■ Do not use an extension cord
or a voltage converter with this
appliance.
■ Always attach the plug to the
appliance, then to the outlet. To
disconnect, turn all controls to
OFF, then remove plug from outlet.
Detach removable power cords
from appliances for storage.
■ Do not place this appliance on any
surface while operating.
■ This power unit is intended to be
correctly oriented in a vertical or
floor mount position.
■ This appliance has a polarized plug
(one blade is wider than the other).
As a safety feature, this plug will
fit in a polarized outlet only one
way. If the plug does not fit fully
in the outlet, reverse the plug. If it
still does not fit, contact a qualified
electrician. Do not attempt to
defeat this safety feature.
■ Do not use this appliance with a
damaged or broken cutting unit,
as injury may occur. Always make
certain blades are aligned properly.
■ This clipper is designed for use
with 120 Volts AC, 60 HZ electrical
outlets. Do not connect the clipper
to a higher voltage than indicated,
as it may result in personal injury
and/or damage to the clipper.
WARNING
To reduce the risk of burns, fire,
electric shock or injury to persons:
■ This appliance is for household use
only.
■ An appliance should never be
left unattended when it’s plugged
in, except when charging a
rechargeable appliance.
■ Close supervision is necessary
when this appliance is used by,
on, or near children or persons
with special needs.
■ Use this appliance only for its
intended use as described in this
manual. Do not use attachments
not recommended by Spectrum
Brands, Inc.
■ Keep the cord away from heated
surfaces.
■ Never operate this appliance if it
has a damaged cord or plug, if it is
not working properly, if it has been
dropped or damaged, or if it has
been dropped into water. If any
of these things happen, return
the appliance to a Remington
authorized service center for
examination and repair.
■ Never drop or insert any object into
any of the appliance’s openings.
SAvE ThESE INSTRUCTIONS
Part HC-60 HC-80
1. Hair Clipper x x
2. Blade Guard x x
3.
1/8" Guide Comb
x x
4. 1/4" Guide Comb
x x
5. 3/8" Guide Comb
x x
6. 1/2" Guide Comb
x x
7. 5/8" Guide Comb
x
8. 3/4" Guide Comb
x
9. 1” Guide Comb
x
10. Right Ear Guide x
11. Left Ear Guide x
12. Styling Comb x x
13. Scissors x x
14. Barber’s Cape x
15. Sectioning Clips
x4
16. Neck Brush x
17. Cleaning Brush x x
18.
Instruction Book
x x
19. Storage Case x
20. How-To Style Guide
x
Congratulations on your purchase of one of the finest hair clippers available
today. Your Remington
®
hair clipper is designed to perform dependably and
efficiently for years, helping you maintain a range of hair styles.
(11)(10)
(12)
(13)
(14)
(15)
(16)
(17)
(18)
(20)
(19)
(2)
HC-60
HC-80
(1)
A Superior Cut
Every Time
Use and
Care Guide
Models HC-60, HC-80
Register Your New Product Today!
By registering your new Remington
®
product you will receive these important benefits:
Proof of ownership • Product protection • Product registration • Special offers
Register online at: http://prc.prodregister.com/remington
Line Cord Safety Tips
NOTE: This appliance has a polarized
plug (one blade is wider than the
other). As a safety feature, this plug
will fit in a polarized outlet only one
way. If the plug does not fit fully in
the outlet, reverse the plug.
If it still does not fit, contact a qualified electrician. Do not attempt to
defeat this safety feature.
1. To insert plug, grasp it firmly and
guide it into outlet.
2. To disconnect the appliance, grasp
the plug and remove it from outlet.
Do not pull or yank on the cord or
appliance. Do not wrap the cord
around the appliance.
Blade Care
The life of your clippers will depend
on frequency of use, care, hair type
and condition. The HC-80 and HC-60
have blades which do not require
additional oiling.
How to Use
Product Features
(1)
Register Your New Product Today!
By registering your new Remington® product, you will receive these important benefits:
Proof of Ownership • Product Protection • Product Registration • Special Offers
Register online at: www.RemingtonProducts.com
Before Cutting Hair
1. Make sure your hair clipper is
running smoothly, with a slight
vibration.
2. Place a cape around the neck of
the person whose hair is being
trimmed or cut. (A cape is provided
with model HC-80).
3. This person should be seated so
that the top of their head is at your
eye level.
4. Comb the hair as it is normally
styled.
5. Comb out all knots and tangles.
6. Ensure the hair is dry. Hair clippers
perform best with dry hair, making
it easier to see how much hair is
being cut.
7. Hold the hair clipper in the palm of
one hand with your thumb resting
firmly on the top of the hair clipper.
This grip provides comfortable
cutting control. Although the hair
clipper may be used with the left
or right hand, using it right-handed
allows you to access the taper
lever more easily.
To Attach Trimming Guides
1. Select the trimming guide that
matches the length you want
the hair to be after the cut. The
trimming guides are numbered
and marked with 1/8” (3mm),
1/4” (6mm), 3/8” (9mm), 1/2”
(12mm), 5/8”(15mm), 3/4”(18mm),
7/8”(22mm), and 1”(25mm). See
preceding chart to determine
which combs your model contains.
2. While the clipper is off, hold the
trimming guide with the teeth up.
Slide the trimming guide onto the
blades until it locks into place.
3. To cut the hair
at the top
of the head,
hold the hair
between your
fingers and
cut a small
amount at a
time. Cut from
the front to
the back.
4.
Remove the
trimming guide
and replace
with either the
left or right
ear guide
(HC-80 only).
The shorter
guide teeth are
designed to be
toward the ear.
Move the clipper from the back of
the head to the front. This creates a
tapered effect around the ears and
back of the neck.
5. The final trim can be made with
the hair clipper or the included
scissors. Make sure to check over
the entire head for any uneven
areas. For styled hair or giving
quick trims, you may prefer using
your hair clipper without the
trimming guide.
Giving a Comfortable,
Even Cut
Allow the clipper to cut through the
hair without moving it too quickly.
Moving the clipper too quickly may
create a pulling sensation.
Use short strokes when cutting, and
initially use the longest trimming
guide. You can always use a closer
trimming guide later if you want a
closer cut.
How to Give a Haircut
1. Start at the back of the head.
Holding the clipper as shown,
lightly stroke upward making sure
you are taking off the desired
amount of hair. Work your way
up to the crown of the head in
layers. When
completed,
comb the area
to remove any
loose hair and
to determine
whether you
need any
further cutting.
2. Repeat the
same procedure for each side of
the head. Make sure the length of
the hair is trimmed to the same
length on both sides of the head.
6. The adjustable taper control lever
allows you to gradually change
the closeness of your cut, either
with or without a trimming guide.
When the lever is fully forward the
blades will give you the closest
cut. Moving the lever gradually
backward increases the cut length.
Very short styles
1. Using the 1/2” (12mm) trimming
guide, hold the comb flat against
the head and
move the hair
clipper from
the back of
the neck to
the crown of
the head.
2. Cut in a similar
manner from
the side to the
top of the head. Then cut from the
front to the crown of the head.
3. If a “Flat Top” style is desired,
remove the trimming guide and
use the barber’s comb. Trim a
little at a time until a flat look is
achieved.
Trimming Beards &
Mustaches
1. Comb your beard in the direction
it grows.
2. Determine the
length you
want the beard
to remain,
and fit the
appropriate
trimming guide.
Remember
the 1/8”
(3mm) guide
will give you
the shortest beard while the 1/2”
(12mm) or 1” (25mm) will give you
the longest. If you want a longer
beard you can use the comb as a
trimming guide.
3. Start trimming under your chin and
work toward your ear and beard
line. Cut in different directions for a
uniform trim.
4. Lightly stroke the edge of your
mustache in a downward
movement.
Maintenance
■ Do not wrap the cord around the
appliance.
■ This appliance does not contain
any user-serviceable parts. Bring
this appliance to an authorized
service representative for service.
Performance Guarantee
Performance Guarantee
Spectrum Brands, Inc.
Money-Back Offer
If within 30 days after you have
purchased your Remington
®
product,
you are not satisfied with it and
would like a refund, just return it,
together with the sales receipt, to the
retailer from whom it was purchased.
Spectrum Brands, Inc. will reimburse
all retailers who accept such appliances within 30 days from date of
purchase. If you have any questions
regarding this money-back guarantee, please call 800-736-4648 in the
U.S. or 800-268-0425 in Canada.
Limited Five-Year Warranty
Spectrum Brands, Inc. warrants this
product against any defects that are
due to faulty material or workmanship for a five-year period from the
original date of consumer purchase.
This warranty does not include damage to the product resulting from
accident or misuse.
If the product should become defective within the warranty period,
we will replace it free of charge.
Return your product with your name,
address and day time phone number
to: Remington Returns Center, 507
Stokely Dr., P.O. Box 1, Deforest, WI
53532. For more information call
800-736-4648 in the US or 800268-0425 in Canada.
This warranty does not cover
products damaged by the following:
■ Accident, misuse, abuse or alteration of the product
■ Servicing by unauthorized persons
■ Use with unauthorized accessories
■ Connecting it to incorrect current
and voltage
■ Wrapping cord around appliance
causing premature wear & breakage
■ Any other conditions beyond our
control
SPECTRUM BRANDS, INC. SHALL NOT
BE RESPONSIBLE FOR ANY INCIDENTAL,
SPECIAL OR CONSEQUENTIAL DAMAGES
RESULTING FROM THE USE OF THIS
PRODUCT. ALL IMPLIED WARRANTIES,
INCLUDING BUT NOT LIMITED TO
IMPLIED WARRANTIES OF FITNESS AND
MERCHANTABILITY, ARE LIMITED IN
DURATION TO FIVE YEARS FROM DATE
OF ORIGINAL PURCHASE
.
Warranty
This warranty gives you specific legal
rights, and you may also have other
rights that vary from state to state.
Some states do not allow the exclusion or limitation of incidental or consequential damages, or limitations on
how long an implied warranty lasts,
so the above limitations and exclusions may not apply to you.
U.S. residents: To order accessories,
contact us at 800-392-6544, visit us
at www.RemingtonProducts.com, or
visit your local retailer.
KEEP ORIGINAL SALES RECEIPT
AS PROOF OF PURCHASE FOR
WARRANTY PURPOSES.
Questions or comments:
Call 800-736-4648 in the U.S or visit
RemingtonProducts.com
® Registered Trademark of
Spectrum Brands, Inc. (SBI),
or one of its subsidiaries.
© 2013 SBI
Job # 2012-12-11_93
1/13 Part No. T22-0000282
Spectrum Brands, Inc.
Madison, WI 53711
Manufactured to Remington’s
specifications in the PRC.
Usage Tips
Loading...