Page 1
ColourCut Hair Clipper
HC5038
I www.remington.co.uk
Register online for an EXTRA year guarantee
Visit uk.remington- europe.com/product-registration
You must regis ter within 28 days of pu rchase.
Page 2
f
e
g
2
Page 3
Thank you for buying your new Remington® produc t. Please read these instructions
carefully and keep them safe. Remove all packaging before use.
IMPORTANT SAFEGUARDS
• This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been supervised/instructed and
understand the hazards involved. Children shall not play with the
appliance. Cleaning and user maintenance shall not be done by children
unless they are older than 8 and supervised. Keep the appliance and cable
out of reach of children under 8 years.
• WARNING: Keep the appliance dry.
• Do not use the product with a damaged cord. A replacement can be
obtained via our International Service Centres.
• Do not use the appliance if it is damaged or malfunc tions.
• Do not use attachments other than those we supply.
• Do not leave the appliance unattended while plugged in.
• Keep the power plug and cord away from heated surfaces.
• Make sure the power plug and cord do not get wet.
• Do not plug or unplug the appliance with wet hands.
• Do not twist or kink the cable, or wrap it round the appliance.
• This appliance is not intended for commercial or salon use.
PARTS
1. On/o switch
2. Taper lever – (6 positions, 0.5 – 2mm)
3. 9 attachment guide combs
Not shown:
• Taper combs
• Neck brush
• Cleaning brush
• Scissors
• Styling comb
• Hairdresser’s cape
3
Page 4
INSTRUCTIONS FOR USE
BEFORE STARTING THE CUT
• Inspect the clipper making sure that it is free from hair and dirt.
• Seat the person so that their head is approximately at your eye level.
• Before cutting, always comb the hair so it is tangle free and dry.
TO ATTACH A COMB
• Hold the comb with its teeth upward.
• Slide it onto and along the clipper blade until the front of the comb rmly sits
against the clipper and click into position.
TO REMOVE THE COMB
• Holding the clipper with the blades facing away from you, rmly push the comb
upward and away from the blades.
• Each comb attachment is marked accordingly on its outside middle sur face.
• Please note a 0. 5mm cutting length can be achieved from holding the clipper, with
no comb attachment, perpendicular to the sk in. A 1.0mm cut ting length is achieved
from holding the clipper, with no comb attachment, with the top of the blade
surface in contact with the skin.
• This is with the taper setting set at the closest gap between the blades.
Guide Combs Cutting Length (mm)
1 (# 0) 1.5
2 (# 1) 3
3 (# 2) 6
4 (# 3) 9
5 (# 4) 12
6 (# 5) 16
7 18
8 22
9 25
INSTRUCTIONS FOR CUTTING HAIR
• For even cutting, allow the comb attachment/blade to cut its way through the hair.
Do not force it through quickly. If you are cutting for the rst time, start with the
maximum comb attachment.
4
Page 5
STEP 1 – NAPE OF THE NECK
• Attach the 3mm or 6mm xed comb
• Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre
of the head at the base of the neck.
• Slowly lif t the clipper, working upwards and out wards through the hair, trimming
just a little at a time.
STEP 2 – BACK OF THE HEAD
• With the 12mm or 16mm guide comb attached, cut the hair at the back of the head.
STEP 3 – SI DE OF THE HEAD
• With the 3mm or 6mm guide comb attached, trim sideburns. Then change to the
longer 9mm guide comb and continue to cut the top of the head.
STEP 4 – TOP OF THE H EAD
• Use the longer length xed combs of 22mm or 25mm to cut hair on top of the head
against the direction in which the hair normally grows.
• Always work from the back of the head.
STEP 5 – THE FINISHING TOUCHES
• Use the clipper without an attachment comb for close trimming around the base
and sides of the neck.
• To produce a clean straight line at the sideburns, reverse the hair clipper. Place the
reversed clipper at right angles to the head, tips of the blades lightly touching the
skin and then work downwards.
SHOR T TAPERED STYLES – “FLAT TOPS” & SHORT CUTS
• Starting with the longest xed comb (25mm), cut from the back of the neck to the
crown. Hold the guide comb at against the head and slowly move the clipper
through the hair.
• Use the same procedure from the lower side to the upper side of the head. Then cut
the hair against the direction in which it grows and level with the sides.
• To give a “at top” look, the hair on top of the head must be cut over the top of a at
comb.
• Use a closer guide comb to taper the hair down to the neck line as desired.
CARE FOR YOUR HAIRCLIPPER
AFTER EACH USE
• To ensure long lasting performance of your clipper, clean the blades and unit
regularly.
• Ensure the appliance is switched o and unplugged from the mains before
cleaning.
5
Page 6
• Brush the accumulated hair from the blades and body of the clipper. Do not
submerge the clipper in water.
• We recommend oiling the blades after cleaning with a little sewing machine oil.
• Note: Ensure the clipper is turned o when cleaning.
EVERY SIX MONTHS
• At regular intervals the blade set should be removed and cleaned.
• The blade set can be removed and reinstalled by using a screwdriver.
• Brush out hair and do not use water or cleaners on the blade set or internal body
housing.
CAUT ION:
• Do not use liquid cleaners on the blades or harsh or corrosive chemicals on the
blade casing. Always use a soft brush to remove the accumulated hairs.
• Always store this appliance and cord in a moisture-free area.
• Do not wrap the supply cord around the appliance.
6
Page 7
RECYCLING
W
To avoid environmental and health problems due to hazardous
substances, appliances and rechargeable and non-rechargeable
batteries marked with one of these symbols must not be disposed of
with unsor ted municipal waste. Always dispose of electrical and
electronic products and, where applicable, rechargeable and
non-rechargeable batteries, at an appropriate ocial recycling/
collection point.
7
Page 8
SERVICE AND GUARANTEE
Defects aecting product functionality appearing within the
guarantee period will be correc ted by replacement or repair at our
option provided the product is used and maintained in accordance
with the instructions. Your statutory rights are not aected.
"
Register at: https://uk.remington-europe.com/product-registration
Consumables are guaranteed only for their recommended lifecycle. Replacement/spare
parts* are excluded and are only covered by a 1 year warranty.
*Examp les include, but a re not limited to, ada ptors, haircare a ttachments, g rooming accesso ries, etc.
To claim an extra 1 year guarantee, register your product online
within 28 days of purchase.
8
Page 9
SERVICE CENTRE
UNITED KINGDOM
G
0800 212 438 (free call mainland UK)
Spectrum Brands (UK) Ltd
Fir Street, Failsworth, Manchester
M35 0HS, UK
www.remington.co.uk
IRELAND
G
142 951 40
Remington Consumer Products,
Unit B12, Ballymount Corporate Park,
Ballymount, Dublin 12
https://ie.remington-europe.com
9
Page 10
10
Page 11
11
Page 12
Ref. No. HC5038
Type No. HC5030
19/UK/ HC5038 T22-7000989 Version 06 /19
Remington® is a Registered Trade Mark of Spectrum Brands, Inc., or one of its subsidiaries.
Spectrum Brands (UK) Ltd
Fir Street,
Failsworth,
Manchester
M35 0HS
www.remington.co.uk
© 2019 Spectrum Brands, Inc.
Loading...