Wi-Fi® BackupCamera
User Manual
FCC Compliance Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and may cause harmful interference to radio communications if not installed and used in accordance with the instructions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and the receiver.
•Connect the equipment into an outlet that is on a different circuit from the device.
•Consult the dealer or an experienced radio/TV technician for help.
When using the device, ensure that the antenna of the device is at least 20 cm away from all persons.
IC Compliance Statement
This device complies with Part 15 of the FCC Rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
1.This device may not cause interference, and
2.This device must accept any interference, including interference that may cause undesired operation of the device.
This Class B digital apparatus complies with Canadian ICES-003.
IC Caution
Intentional or unintentional changes or modifications to the equipment not expressly approved by Rand McNally could void the user’s authority to operate the equipment.
IC attestation de conformité
Ce dispositif est conforme à la norme FCC Partie 15 et aux norme(s) RSS permis-exempte(s) d’Industrie Canada. L’opération est soumise aux deux conditions suivantes:
1.Ce dispositif ne peut pas provoquer d’interférence nocive et
2.Ce dispositif doit accepter toute interference reçue, y compris les interférences qui peuvent causer un mauvais fonctionnement du dispositif.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Attention
Les changements ou modifications à l’équipement, que ce soient intentionnelles ou non, non expressément approuvés par Rand McNally pourraient annuler l’autorisation de l’utilisateur à utiliser cet équipement.
Important information about your backup camera
About installation: Please note the following installation instructions are intended to be used as a general guide. Specific requirements will vary by vehicle type, make, and model. Rand McNally recommends that the backup camera be installed by a qualified vehicle technician. Rand McNally is not responsible for damage caused by the installation.
Rand McNally follows a continuous review process and reserves the right to provide enhancements that may not be reflected in the pictures and specifications in this document. While the information contained herein is believed to be correct when compiled, Rand McNally does not guarantee its accuracy.
Professional installation is recommended to get the most out of your Wireless Backup Camera. Visit randmcnally.com/pro-install to see recommended service providers.
2
Download the Wireless Backup Cam app
On your OverDryve™ device, go to the Rand McNally Market and download the Wireless Backup Cam app.
3
Loading...