Rand McNally H100 Owner's Manual

ELECTRONIC LOGGING DEVICE

User Manual

Installing Your HD 100 > Installation Instructions

Installing your HD 100 can take as little as 10 minutes. Installation
instructions are provided here, as well as quick diagnostic
information so you can verify your device is working correctly.

Box contents*:

• HD 100 device

• HD 100 device tray

• Get Started card

• User Manual

• Driver and DOT Quick
Reference card

*

Does not include IntelliRoute® TND™ 720 device

• E-Log sticker for vehicle

• 9-pin power cable

• USB-to-Mini USB cable

• Adhesive mounting strips (2)

• Screws and nuts (4)

• Cable ties (4)

Installation Instructions

1. Locate the truck’s diagnostic port. Connect the cable to the port

and turn the collar on the cable end to lock it in place.

NOTE: For information on alternative installation options, refer
to the Alternative Installation Options on page 13.

2. Route the cable from the diagnostic port to the location you
selected for mounting the HD 100 device, making sure to place
it on a flat surface, away from any vents and any locations
where it may interfere with the driver.

NOTE: Tuck the cable in the space between the windshield
and the dash.

8

HD 100 User Manual

Installing Your HD 100 > Installation Instructions

3. Connect the HD 100 to the cable and place it (with the

tray attached) on the flat surface.

4. Make sure the area selected is clean and dry. Peel the protective
layer off one side of the adhesive mounting strips and place on
the bottom of the HD 100 tray. Then peel off the other
protective layer, and place the device with tray attached on your
dash in the desired location, pressing firmly to secure it to
the dash surface.

NOTE: Do not cover the HD 100 device or place anything over
it, as this may interfere with the GPS signal.

HD 100 User Manual

9