InstructionSheet
InstructionSheet
TANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
IMPOR
and instructions concerning W
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn of
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.
INSTALLATION INSTRUCTIONS
STACCATO WALL BRACKETS
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .01857600
et or Damp Locations, installation near combustible materials, insulation, building materials,
f power at fuse or circuit breaker.
All servicing or relamping must be performed by
www.prescolite.com • Prescolite TollFree Technical Support 1.888.PRS.4TEC • Hours: 8am - 5pm ET
1. Make electrical connections. Connect ground wires to
green ground leads. Connect white (common) to white
leads. Connect power supply (line) to black leads. (see
wiring diagram).
WARNING: DO NOT pinch wires. Consult a Qualified
Electrician for all other options that require other
wiring configurations.
Attach mounting strap and block assembly to box using
2.
outlet box screws. (Fig. 1) If necessary, the mounting
strap may be reversed. Remove the screws holding the
block to the strap and reassemble the block on the
opposite side of the strap. (Fig. 2)
3. Place the canopy over the mounting block.
4. Place the fixture arm over the mounting block. Hold the
fixture firmly against the wall and tighten the 2 set
screws in the arm.
5. NOTE: Up-down lights mounted outdoors must have
waterproof rubber boot on up-down socket.
6. See accompanying Instruction Sheet for lamp installation procedure for PAR 56 units.
Fig. 1
Outlet Box Screws
Universal Mounting
Strap & Block Assembly
Fig. 2
Mounting Block
Mounting Strap
Set Screws
1
3
/4" or 4" Outlet Box
101 Corporate Drive • Spartanburg, SC 29303
With representatives of
Copyright 2005, 08/05 revision, All Rights Reserved - Printed in U.S.A.
fices in principal cities throughout North
Canopy
America.
Arm
Loading...