InstructionSheet
InstructionSheet
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .06269400
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.
INSTALLATION INSTRUCTIONS
ST612/ST812 SERIES REFLECTOR
SAVE THESE INSTRUCTIONS
PAR-38 LAMP
OR
R-40 LAMP
www.prescolite.com • Prescolite TollFree Technical Support 1.888.PRS.4TEC • Hours: 8am - 5pm ET
CEILING
TRIM
ASSEMBLY
INSTALLED
PL SERIES
FLOURESENT
LAMP
ALL TO BE
W
ILLUMINATED
FIG. 3
FIG. 1
REFLECTOR
TRIM
ASSEMBLY
LENS
RETAINER
SPRING
LENS
LENS
RETAINER
SPRING
Install Lamps (NOTE: SEE
1.
WATTAGE).
2. Aim Housing by rotating housing such that lamp faces wall to be illuminated (as
shown in Fig. 1).
3. Trim Installation:
a) Verify alignment of notch in lens with retainer spring (See Fig. 1).
b) Check orientation of trim with lamp (See Fig. 1, lens to be facing wall to be
illuminated).
c) Squeeze torsion spring legs together and place them into torsion spring
brackets (See Fig. 2).
d) Push trim up and allow the torsion springs to pull the trim up against the ceiling.
o remove trim for relamping:
T
4.
Push lens up into fixture, grab cone edge with fingertips and pull the trim down
(Note: lens retaining spring will limit the upward movement of the lens. See Fig. 3).
NOTCH
RELAMP
FIG. 2
INSIDE FIXTURE FOR MAXIMUM
LABEL
TORSION
SPRING
(1 OF 2)
TORSION
SPRING
BRACKET
(1 OF 2)
TRIM
ASSEMBLY
701 Millennium Boulevard • Greenville, SC 29607
With representatives of
Copyright 2007, 02/07 revision, All Rights Reserved - Printed in U.S.A.
fices in principal cities throughout North
America.
Loading...