InstructionSheet
InstructionSheet
IMPORTANT SAFETY INFORMATION. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Follow label information
and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials,
and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and
during servicing or relamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by
qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard.
Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in
compliance with the National Electrical Code and local codes. The use of accessory equipment not recommended by
the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from
product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens or
the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.
INSTALLATION INSTRUCTIONS
TYPE “R” FIXTURE MOUNTING STRAP
1. Mount “R” strap parts to outlet box as shown using
O.B. screws.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .01855700
www.prescolite.com • Prescolite TollFree Technical Support 1.888.PRS.4TEC • Hours: 8am - 5pm ET
2. Mount fixture with running thread nipples and hex or
cap nuts provided.
3. If fixture is to be installed in a wet location:
-use an O-ring behind each hex or cap nut.
-apply calk to the 4 sides of the canopy.
Fixture
O-Ring
“R” Strap Parts
3-1/2” or 4" Outlet Box
101 Corporate Drive • Spartanburg, SC 29303
With representatives of
Copyright 2006, 01/06 revision, All Rights Reserved - Printed in U.S.A.
fices in principal cities throughout North
America.
Loading...