Powersolve PSV60 User Manual

AC-DC Battery Backed Power Supply

PSV60 Series
50 Watt Open Frame
Dual Output
Battery Backed

Features

• Universal input range 90-264Vac

• 12V Battery Back-up (with external sealed lead acid battery)

• Integral Battery Charger

• Dual +5V & +12V Outputs

• AC Power FAil & Battery Low Signals

• Battery Under Voltage Lockout

Electrical Specification

INPUT

Input Voltage Range 90 - 264Vac
Frequency 47 - 63Hz
Input Current 1.5A max for 120Vac
Inrush Current 70A max. @ 230Vac, cold start
Earth Leakage Current 3.5mA max.
Input Fuse T2A/250V

www.powersolve.co.uk

OUTPUT

Output 1 +13.8V @ 1A for battery charging (suitable for charging up to 12Ahr 12V battery)
Output 2 +5V @ 4A
Output 3 +12V @ 1.2A (follows 13.8V charger voltage, therefore output will be 13.8V when AC is present

Minimum Load 100mA on outputs 1 & 2
Ripple & Noise 1% Vout
Max. Output Power 50 Watts
Efficiency 70% minimum at max. load, 230Vac input
Turn On Delay 2 seconds max. @ 120Vac input
Hold Up Time 8mS minimum at max. load, 120Vac input
Transient Response 1mS for return to ±10% of nominal for 50% load change, 120Hz 50% duty cycle
Over Voltage Protection 16.0V @ full load for 13.8V output
Short Circuit Protection Protection against short circuit with auto-recovery.

Temperature Coefficient 0.2% per °C max. over entire operating temperature range
Battery Under Voltage Lockout Disconnects load from battery at a preset voltage (approx. 10.5V) to prevent deep discharge of

AC Power Good Signal Goes low with loss of AC input
Battery Low Signal Goes high when battery voltage is low (approx. 11V)
Operating Temperature Range 0 to +50°C
Storage Temperature Range -20 to + 85°C
Safety Meets EN60950 CB Report
EMC Requirement Meets EN55022 ‘B’
Hi-pot Test Primary to Secondary: 3KVac for 1 sec. 10mA

Insulation Resistance Input to Output: >7MΩ 500VDC

and follows 12V battery voltage under battery back-up conditions)

Note: The output can be shorted permanently without damage, but the battery MUST be fused
externally to prevent fire hazard.

the battery.

Secondary to Ground: 500VDC for 1 sec. 10mA

Powersolve Electronics Ltd. 8A Arnhem Road, Newbury, RG14 5RU. England

Tel: [phone] Fax: [phone] Email: [e-mail]

AC-DC Battery Backed Power Supply

Mechanical and Connection Details

www.powersolve.co.

uk

Input Connector:

3 pin 5.08mm terminal block

Output Connector:

6 pin 3.96mm (0.156”) Molex Header
Pin 1 & 2: +5V
Pin 3, 4 & 5: Return
Pin 6: +12V

Battery Connector:

2 x 6.3 x 0.8mm Fast On Blades

Signal Connectors (TB1 & TB2):

2.54mm (0.1”) Molex Headers

Powersolve Electronics Ltd. 8A Arnhem Road, Newbury, RG14 5RU. England

Tel: [phone] Fax: [phone] Email: [e-mail]