Power Probe Ppsk User Manual
MULTIPURPOSE BUTANE
SOLDERING TOOL
PPSK
Instruction Manual
OPERATING INSTRUCTIONS
WARNINGS:
1.
Do not fill gas or store near open flame, heater
or combustible materials.
2.
Use only high quality Butane Gas.
3.
Butane Gas is highly flammable, please handle
with care.
Do not drop, puncture, or incinerate.
4.
Do not store or operate in a place that
5.
temperature is higher than 50ºC or 122ºF.
Keep out of reach of children.
6.
Cool down before putting protective cap on or
7.
storing.
Do not try to overkill the tank!
8.
GAS FILLING AND REFILLING IGNITION
1.
Move the FLOW CONTROL KNOB to the middle
position.
Move the SWITCH upward and to the right.
BUTANE
1.
Ensure the Switch is turned to the
‘OFF’ Position before filling.
Reverse the unit; insert the gas
2.
container’s nozzle vertically into
Filling Valve.
When gas escapes from Filling
3.
Valve, remove the nozzle from the
Filling Valve.
2.
Press down the IGNITION BUTTON to light up
3.
the unit.
When the unit is working as a soldering tool, 3
4.
seconds after ignition, you will find the Soldering
Head becomes red.
1 2 3 4
SHUTTING OFF
Move the SWITCH upward and to the left, the
switch will return to ‘OFF’ position.
FLAME LENGTH OR
TEMPERATURE ADJUSTMENT
After ignition, turn the FLOW CONTROL
KNOB to right to increase the flame length of
the torch or the temperature of soldering tip or
hot air, to left to decrease the flame length or
the temperature.
IGNITION BUTTON
FLOW CONTROL KNOB
SWITCH
OPERATING TIPS HOW TO FIT OR REPLACE
AFTER FILLING OR REFILLING WITH GAS,
1.
WAIT FOR APPROXIMATELY 2 MINUTES SO
THAT THE GAS IN THE CYLINDER CAN BE
STABLE.
Soldering Tips must be tin-plated before using
2.
them for the first time. A thin layer of solder
should be applied to the Tip when it has been
heated.
Soldering should NOT be carried out on “live”
3.
circuits, as this soldering unit does not possess
any special electrical insulation.
Keep your soldering sponge moist.
4.
DIFFERENT ACCESSORIES
NOTE: ALWAYS ALLOW UNIT TO COOL BEFORE
REMOVING OR REPLACING TIPS.
1.
REPLACE SOLDERING TIPS
with 7mm Wrench on the Soldering Tip or Hot
Blow Head and 8mm Wrench on the Soldering
Head, you can tight Tip or Hot Blow Head or
unscrew them.
7mm
8mm
2.
When you unscrew the Nut, you can remove
Guard and Soldering Head, then this unit
becomes an open flame torch.
PROBLEM
Does not ignite 1. No gas
Torch flame has no proper
power
Tip does not heat up
Filling Valve
ST-21
Standard Tip
ST-22
3mm Diagonal Tip
TROUBLE SHOOTING
2. Gas pressure too high or too low
1. Insufficient gas power 1. Refill butane gas
1. Insufficient gas power
2. Catalyst is damaged
Switch
Flow Control Knob Ignition Button Guard
ST-23
3.5mm Chisel Tip
CAUSE SOLUTION
Nut
SH-32
SH-42
Hot Knife
Hot Blower
1. Refill butane gas
2. Slide flow control knob to lower
or higher position
1. Refill butane gas
2. Replace with new part
SA-91
7mm Wrench
Protective Cap
7
Soldering Head
SA-52
Reflector
SA-92
8mm Wrench
8
3114MA06
Loading...