Pioneer PDF-507 Service manual
ORDER NO.
RRV1951
FILE-TYPE CD PLAYER
PD-F607
PD-F507
Refer to the service manual RRV1877 for PD-F607/KUXJ and
PD-F507/KUXJ.
THIS MANUAL IS APPLICABLE TO THE FOLLOWING MODEL(S) AND TYPE(S).
Type
Model
PD-F607 PD-F507
WYXJ O AC220-240V
WVXJ O AC220-240V
WPWXJ O AC220-240V
MAMXJ O AC220-230V
RLXJ O AC110-120V/220-240V With the voltage selector
RDXJ O AC110-127V/220-240V With the voltage selector
Power Requirement
The voltage can be converted by
the following method.
CONTENTS
1. SAFETY INFORMATION.................................... 2
2. CONTRAST OF MISCELLANEOUS PARTS ..... 3
3. SCHEMATIC AND PCB DIAGRAMS ................. 8
PIONEER ELECTRONIC CORPORATION
PIONEER ELECTRONICS SERVICE, INC.
PIONEER ELECTRONIC (EUROPE) N.V .
PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 501 Orchard Road, #10-00 Lane Crawford Place, Singapore 0923
CC
C
PIONEER ELECTRONIC CORPORATION 1998
CC
P.O. Box 1760, Long Beach, CA 90801-1760, U.S.A.
Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium
4-1, Meguro 1-Chome, Meguro-ku, Tokyo 153-8654, Japan
T–ZZY APR. 1998 Printed in Japan
PD-F607, PD-F507
1. SAFETY INFORMATION
This service manual is intended for qualified service technicians; it is not meant for the casual
do-it-yourselfer. Qualified technicians have the necessary test equipment and tools, and have been
trained to properly and safely repair complex products such as those covered by this manual.
Improperly performed repairs can adversely affect the safety and reliability of the product and may
void the warranty. If you are not qualified to perform the repair of this product properly and safely, you
should not risk trying to do so and refer the repair to a qualified service technician.
IMPORTANT
THIS PIONNER APPARATUS CONTAINS
LASER OF CLASS 1.
SERVICING OPERATION OF THE APPARATUS
SHOULD BE DONE BY A SPECIALLY
INSTRUCTED PERSON.
LASER DIODE CHARACTERISTICS
MAXIMUM OUTPUT POWER : 5 mw
WAVELENGTH : 780-785 nm
LABEL CHECK (For PD-F607/WYXJ,WVXJ and PD-F507/WPWXJ only
PD-F607/WYXJ only
Additional Laser Caution
1.Laser Interlock Mechanism
The position of the switch (S651) for detecting loading
state is detected by the system microprocessor, and
the design prevents laser diode oscillation when the
switch (S651) is not on CLMP terminal side (CLMP
signal is OFF or high level).
Thus, the interlock will no longer function if the switch (S651)
REAR
is deliberatery set to CLMP terminal side. (low level)
The interlock also does not function in the test mode ✽.
Laser diode oscillation will continue, if pin 33 of
CXA1782CQ (IC151) on the MOTHER BOARD ASSY
is connected to GND, or pin 26 of IC351 (LDON) is
connected to low level (ON), or else the terminals of
Q151 are shorted to each other (fault condition).
)
2.When the cover is opened, close viewing of the
objective lens with the naked eye will cause exposure
to a Class 1 laser beam.
✽
: Refer to page 25. on the service manual RRV1877.
PD-F607/WVXJ and PD-F507/WPWXJ only
2
PD-F607, PD-F507
2. CONTRAST OF MISCELLANEOUS PARTS
NOTES : ÷ Parts marked by “ NSP ” are generally unavailable because they are not in our Master Spare Parts List.
÷ The
÷ Reference Nos. indicate the pages and Nos. in the service manual for the base model.
÷ Screw adjacent to ∞ mark on the product are used for disassembly.
÷ When ordering resistors, first convert resistance values into code form as shown in the following examples.
mark found on some component parts indicates the importance of the safety factor of the part.
Therefore, when replacing,be sure to use parts of identical designation.
Ex. 1 When there are 2 effective digits (any digit apart from 0), such as 560 ohm and 47k ohm (tolerance is shown by
J = 5%, and K = 10%).
1
560 Ω = 56 × 10
47k Ω = 47 × 10
= 561................................................... RD1/4PU 5 6 1 J
3
= 473 .................................................. RD1/4PU 4 7 3 J
0.5 Ω = R50 ...................................................................... RN2H Â 5 0 K
1 Ω = 1R0 ......................................................................... RS1P 1 Â 0 K
Ex. 2 When there are 3 effective digits (such as in high precision metal film resistors).
1
5.62k Ω = 562 × 10
= 5621 ........................................... RN1/4PC 5 6 2 1 F
CONTRAST TABLE (FOR PD-F607
)
WYXJ, WVXJ and KUXJ types are constructed the same except for the following :
Ref.
No.
Mark
Symbol and Description
KUXJ WYXJ WVXJ
ASSEMBLES
P5-1 Mother Board Assy PWM2199 PWM2200 PWM2200
P7-16 NSP Power SW Board Assy PWZ3622 PWZ3623 PWZ3623
NSP Headphone Board Assy Not used PWX1549 PWX1549 No.9
NSP Sub Board Assy PWX1540 PWX1541 PWX1541
PACKING
P3-1 Operating Instructions (English) PRB1262 Not used PRB1265
P3-1 Operating Instructions Not used PRE1265 Not used
P3-1 Operating Instructions Not used PRD1026 Not used
P3-5 Control Cable (L=1m) PDE1247 Not used Not used
P3-10 Packing Case PHG2282 PHG2298 PHG2299
P3-12 NSP Warranty Card ARY1051 ARY7009 ARY7009
(English/French)
(German/Italian/Dutch/Swedish
/Spanish/Portuguese)
CD Liner Notes File Not used PHN1051 PHN1051 No.1
Index Label Sheet (25) Not used PRW1422 PRW1422 No.2
Rear Spacer Not used Not used PHC1087 No.3
Polyetylene Bag (115 x 270 x 0.05) Not used Not used Z21-013 No.4
Part No.
PD-F607
Remarks
EXTERIOR
P5-2 Cord Stopper CM-22C CM-22B CM-22B
P5-4 AC Power Cord PDG1015 PDG1003 PDG1055
P5-5 Power Transformer (AC120V) PTT1237 Not used Not used
P5-5 Power Transformer (AC220-240V) Not used PTT1236 PTT1236
P5-8 Rear Base PNA2386 PNA2398 PNA2399
P5-42 65 Label ORW1069 Not used Not used
Insulator (Front Side) Not used PNW2766 PNW2766 No.5
Caution Label Not used Not used PRW1018 No.6
Caution Label HE Not used PRW1233 Not used N0.7
Caution Label Not used VRW1094 Not used No.8
Headphone Angle Not used PNB1584 PNB1584 No.10
Knob Not used RAC1903 RAC1903 No.11
FRONT PANEL SECTION
P7-10 Display Window PAM1740 PAM1739 PAM1739
P7-15 Control Panel PNW2756 PNW2757 PNW2757
P7-20 Rubber Sheet AEB1111 Not used Not used
:
Note
The numbers in the remarks column correspond to the numbers on the exploded diagram, Refer to “EXPLODED VIEWS”.
For ASSEMBLIES, Refer to “ CONTRAST OF PCB ASSEMBLES” and “3. SCHEMATIC AND PCB DIAGRAMS”.
LED Lens Not used PNW2019 PNW2019 No.12
3
Loading...