This service manual is intended for qualified service technicians ; it is not meant for the casual do-ityourselfer. Qualified technicians have the necessary test equipment and tools, and have been trained
to properly and safely repair complex products such as those covered by this manual.
Improperly performed repairs can adversely affect the safety and reliability of the product and may
void the warranty. If you are not qualified to perform the repair of this product properly and safely, you
should not risk trying to do so and refer the repair to a qualified service technician.
WARNING
This product contains lead in solder and certain electrical parts contain chemicals which are known to the state of California to cause
cancer, birth defects or other reproductive harm.
Health & Safety Code Section 25249.6 – Proposition 65
NOTICE
(FOR CANADIAN MODEL ONLY)
Fuse symbols (fast operating fuse) and/or (slow operating fuse) on PCB indicate that replacement parts must
be of identical designation.
REMARQUE
(POUR MODÈLE CANADIEN SEULEMENT)
Les symboles de fusible (fusible de type rapide) et/ou (fusible de type lent) sur CCI indiquent que les pièces
de remplacement doivent avoir la même désignation.
(FOR USA MODEL ONLY)
1. SAFETY PRECAUTIONS
The following check should be performed for the
continued protection of the customer and service
technician.
LEAKAGE CURRENT CHECK
Measure leakage current to a known earth ground (water
pipe, conduit, etc.) by connecting a leakage current tester
such as Simpson Model 229-2 or equivalent between the
earth ground and all exposed metal parts of the appliance
(input/output terminals, screwheads, metal overlays, control
shaft, etc.). Plug the AC line cord of the appliance directly
into a 120V AC 60Hz outlet and turn the AC power switch
on. Any current measured must not exceed 0.5mA.
Reading should
not be above
0.5mA
Earth
ground
Device
under
test
Also test with
plug reversed
(Using AC adapter
plug as required)
Leakage
current
tester
Test all
exposed metal
surfaces
ANY MEASUREMENTS NOT WITHIN THE LIMITS
OUTLINED ABOVE ARE INDICATIVE OF A POTENTIAL
SHOCK HAZARD AND MUST BE CORRECTED BEFORE
RETURNING THE APPLIANCE TO THE CUSTOMER.
2. PRODUCT SAFETY NOTICE
Many electrical and mechanical parts in the appliance
have special safety related characteristics. These are
often not evident from visual inspection nor the protection
afforded by them necessarily can be obtained by using
replacement components rated for voltage, wattage, etc.
Replacement parts which have these special safety
characteristics are identified in this Service Manual.
Electrical components having such features are identified
by marking with a
in this Service Manual.
The use of a substitute replacement component which does
not have the same safety characteristics as the PIONEER
recommended replacement one, shown in the parts list in
this Service Manual, may create shock, fire, or other hazards.
Product Safety is continuously under review and new
instructions are issued from time to time. For the latest
information, always consult the current PIONEER Service
Manual. A subscription to, or additional copies of, PIONEER
Service Manual may be obtained at a nominal charge from
PIONEER.
on the schematics and on the parts list
AC Leakage Test
2
DV-533, DV-3310, DV-533K, DV-5310KD
2. EXPLODED VIEWS AND PARTS LIST
NOTES:• Parts marked by "NSP" are generally unavailable because they are not in our Master Spare Parts List.
2.1 PACKING
6
2
3
1
The mark found on some component parts indicates the importance of the safety factor of the part.
•
Therefore, when replacing, be sure to use parts of identical designation.
Screws adjacent to mark on the product are used for disassembly.
DV-533/RDXJ/RA, RDXJ/RB, DV-3310/RAMXQ, DV-533K/RLXJ/NC, RLXJ/RB, RLXJ/RD, LBXJ and DV-5310KD/RAMXQ are
constructed the same except for the following :
36 Jack HolderSee Contrast table (2)
37 Class 1 Caution LabelSee Contrast table (2)
(2) CONTRAST TABLE
DV-533/RDXJ/RA, RDXJ/RB, DV-3310/RAMXQ, DV-533K/RLXJ/NC, RLXJ/RB, RLXJ/RD, LBXJ and DV-5310KD/RAMXQ are
constructed the same except for the following :
Part No.
Mark No.Symbol and
1
4
NSP
5
NSP
6
7
Description
DVDM Assy
JACB Assy
FLKB Assy
KEYB Assy
MJKB Assy
DV-533DV-3310DV-533K
RDXJ/RARDXJ/RBRAMXQRLXJ/NCRLXJ/RBRLXJ/RDLBXJRAMXQ
VWS1487
VWV1844
VWG2284
VWG2290
Not used
VWS1487
VWV1844
VWG2284
VWG2290
Not used
VWS1501
VWV1844
VWG2287
VWG2290
Not used
VWS1487
VWV1845
VWG2286
VWG2290
VWV1849
VWS1487
VWV1845
VWG2286
VWG2290
VWV1849
VWS1487
VWV1845
VWG2286
VWG2290
VWV1849
VWS1487
VWV1845
VWG2285
VWG2290
VWV1849
DV-5310KD
VWS1489
VWV1846
VWG2288
VWG2296
VWV1849
NSP
8
POWER SUPPLY Unit
9
Flexible Cable (16P)
10
Flexible Cable (17P)
11
Flexible Cable (30P)
16
Rear Panel
18
Bonnet S
18
Bonnet
19
Flexible Cable (7P)
20
DVD-V Plate
23
Tray Panel
24
Ring
25
Front Panel Assy
26
Pioneer Name Plate
29
Screw
31
Label
32
Label
34
Headphone Knob
35
Headphone Knob G
35
Headphone Knob S
36
Jack Holder
37
Class 1 Caution Label
VWR1340
VDA1860
VDA1862
VDA1871
VNA2301
VXX2775
Not used
Not used
VAM1121
VNK4835
Not used
VXA2463
VAM1109
BCZ40P060FZK
Not used
VRW1872
Not used
Not used
Not used
Not used
Not used
VWR1340
VDA1860
VDA1862
VDA1871
VNA2353
VXX2775
Not used
Not used
VAM1121
VNK4835
Not used
VXA2463
VAM1109
BCZ40P060FZK
Not used
VRW1872
Not used
Not used
Not used
Not used
Not used
VWR1340
VDA1861
VDA1863
VDA1872
VNA2341
Not used
VNA2332
Not used
VAM1121
VNK4836
VNK4840
VXA2467
VAM1112
BCZ40P060FNI
VRW1739
VRW1872
Not used
Not used
Not used
Not used
Not used
VWR1340
VDA1860
VDA1862
VDA1871
VNA2302
VXX2774
Not used
VDA1868
VAM1121
VNK4836
VNK4840
VXA2464
VAM1112
BCZ40P060FNI
Not used
VRW1872
PAC1707
PAC1952
Not used
VNE2254
Not used
VWR1340
VDA1860
VDA1862
VDA1871
VNA2354
VXX2774
Not used
VDA1868
VAM1121
VNK4836
VNK4840
VXA2464
VAM1112
BCZ40P060FNI
Not used
VRW1872
PAC1707
PAC1952
Not used
VNE2254
Not used
VWR1340
VDA1860
VDA1862
VDA1871
VNA2355
VXX2774
Not used
VDA1868
VAM1121
VNK4836
VNK4840
VXA2464
VAM1112
BCZ40P060FNI
Not used
VRW1872
PAC1707
PAC1952
Not used
VNE2254
Not used
VWR1339
VDA1860
VDA1862
VDA1871
VNA2296
VXX2773
Not used
VDA1868
VAM1121
VNK4837
VNK4840
VXA2454
VAM1129
BCZ40P060FNI
Not used
Not used
Not used
Not used
VNK4901
VNE2254
Not used
VWR1340
VDA1861
VDA1863
VDA1872
VNA2295
Not used
VNA2332
VDA1869
VAM1123
VNK4836
VNK4840
VXA2452
VAM1112
BCZ40P060FNI
VRW1739
VRW1872
PAC1707
PAC1862
Not used
VNE2254
VRW1889
5
DV-533, DV-3310, DV-533K, DV-5310KD
2.3 LOADING MECHANISM ASSY
Note :
Refer to
" Apply Position of Lubricant".
Daifree
GEM1036
8
6
To DVDM
CN151
2
Refer to
"2.4 TRAVERSE MECHANISM
8
ASSY-S".
8
23
15
14
12
Lubricating Oil
GYA1001
13
22
9
2222
16
8
20
3
17
21
7
A
11
1
A
A
4
5
22
10
Lubricating Oil
GYA1001
18
22
19
LOADING MECHANISM ASSY PARTS LIST
•
Mark No. Description Part No.
NSP1 LOAB AssyVWG2279
2 Traverse Mechanism Assy-SVXX2782
3 Loading Motor AssyVXX2505
4 Motor PulleyPNW1634
5 Carriage DC Motor / 0.3WPXM1027