Pilz PSENmag Product Flyer
PSENmag safety switches – The highest
level of safety at the lowest price
Due to their non-contact operating mode, the safety switches
PSEN ma1.4 are suitable for use anywhere there is heavy
soiling. They can be used in combination with safe control
technology.
Approved up to PL e of EN ISO 13849-1, SIL 3 of
EN/IEC 62061 and Category 4 of EN 954-1, they meet the
very highest safety requirements and offer a complete solution
that's safe, approved and economical.
As well as the space-saving installation, the new safety
switches PSENmag provide an operating distance
of 3 or 10 mm and an additional signal contact with LED.
Your benefi ts at a glance
• Connected via a plug connection or with cable
• Flexible cable outlet, including connector, so there's no need
for an angled connector
• Flexible mounting, both the sensor and the actuator support
every conceivable mounting confi guration
• Cost effective thanks to series connection
• Operating distance of 3 or 10 mm
• Additional signal contact and LED
PSENmag cable version available from May 2009
PSENmag connector version available from July 2009
Product range
PSENmag
Non-contact magnetic safety switches PSEN
g
n
i
s
u
o
h
2
1
M
PSEN ma1.4a PSEN ma1.4p PSEN 1.2p PSEN ma1.3a
… highest level of
safety at a low price
Non-contact, magnetic safety
switches are used to monitor the
position of guards in accordance
with EN 60947-5-3 and also for
general position monitoring.
PSENmag gives you a costoptimized system comprising
Pilz sensor and control system,
including approval.
Type code for PSENmag
PSEN ma1.4a-50
Maximum freedom
for installation
The compact design of the
PSENmag saves installation
space. Connector and cable for
all mounting and approach directions, plus an assured operating
distance of 3 or 8/10 mm, enable
fl exible assembly and rapid,
simple installation.
High requirements –
implemented economically
PSENmag switches can be
used where a high category is
specifi ed, where there is heavy
soiling or where strict hygiene
regulations need to be met.
The low wear and tear of
the rugged, fully encapsulated
housing, in conjunction with the
non-contact, magnetic operating
principle, guarantees a long
product service life.
Product area
Pilz SENsors
Product range
ma – PSENmag
Operation
Non-contact,
magnetic
18
Contacts
1 NO/NO
2 NC/NO
Design
1 Square, dimensions:
36 x 26 x 13 mm
2 Round, M30
3 Round, M12
with signal contact
4 Square, dimensions:
37 x 26.4 x 18 mm
Connection type
a Cable, 5 m
b Cable, 10 m
n Connector, M12,
5-pin
p Connector, M8:
- 4-pin
- 8-pin
Operating distance
1 3 mm
2 8 mm/12 mm
3 6 mm
4 4 mm
5 3 mm/10 mm
1)
1)
Depends on the actuator 2) Ri = 0 Ω
LED/ATEX/Series
connection
0 Without LED
1 With LED
2 Only with PSEN ix1
3 ATEX, without LED
1)
4 ATEX, with LED
5 ATEX, without LED,
only with PSEN ix1
6 ATEX, without LED
7 Only with PSEN ix1
8 ATEX, with LED,
only with PSEN ix1
9 Special types
2)
2)
2)
2)
Loading...