Phonic P450, P550, PA550, PA450 User Manual
PHONIC CORPORATION
Page 2 P(A)450/550 USER’S MANUAL
Introduction.......................................................................................................................3
Features..........................................................................................................................3
Precautions........................................................................................................................4
Maintenance........................................................................................................5
P450/550 Passive Version.....................................................................................5
PA450 / 550 Active Version...................................................................................6
Application......................................................................................................................7
Installation.....................................................................................................................10
Dimensions......................................................................................................................11
Block diagram.........................................................................................................12
Specifications......................................................................................................14
Suggested Readings...........................................................................................15
Phonic reserves the right to improve or alter any information supplied within this document without prior
notice. V1.2 2003/04/17
CONTENTS
PHONIC CORPORATION
Page 3P(A)450/550 USER’S MANUAL
INTRODUCTION
Thank you for purchasing the Phonic
’
S P450/550
and PA450/550 sound reinforcement molded
loudspeaker. The development of these
non-powered and powered bi-amplified speaker
system is a natural extension of Phonic
’
S
extensive experience and knowledge of
professional audio equipments. These speakers
truthfully reproduce sound for a wide range of
applications. Please take some time to go through
this manual for best performance as well as
longest possible operation life from your
P450/550 and PA450/550. And remember to
keep it safely for future reference.
FEATURES
P450 and PA450
• Frequency response: 50Hz ~ 20KHz
• 12" long-throw low frequency transducer
• High SPL Output/Low Distortion
• Multi-cell high-dispersion horn with ultra-
wide audience coverage (90ox45o)
• Precision titanium compression driver
• Ergonomic handles for easy transport
• Stackable, stand mountable and arrayable
• Reclines for use as a stage monitor
• Tough, impact-resistant, lightweight molded
enclosure
P450
• 250 watts (RMS) / 500 watts (program) power
handling
• High sound pressure level, 96dB SPL @ 1W/
1M
• Speakon and 1/4" jack connectors included
PA450
• 330 watts RMS (250W LF/80W HF)
delivered to the internal transducers
• Built-in precision 24dB/oct. Linkwitz-Riley
electronic crossover
• 3-input mixer, 2-band EQ and link out
• Maximum sound pressure level: 121 dB
SPL @ 1M
• Electronic Time Correction, Phase
Alignment, & Equalization
P550 and PA550
• Frequency response: 40Hz ~ 20KHz
• 15" long-throw low frequency transducer
• High SPL Output/Low Distortion
• Multi-cell high-dispersion horn with ultra-
wide audience coverage (90ox45o)
• Precision titanium compression driver
• Ergonomic handles for easy transport
• Stackable, stand mountable and arrayable
• Reclines for use as a stage monitor
• Tough, impact-resistant, lightweight molded
enclosure
P550
• 300 watts (RMS) / 600 watts (program) power
handling
• High sound pressure level, 98dB SPL @ 1W/
1M
• Speakon and 1/4" jack connectors included
PA550
• 400 watts RMS (300W LF/100W HF)
delivered to the internal transducers
• Built-in precision 24dB/oct. Linkwitz-Riley
electronic crossover
• Maximum sound pressure level: 124 dB SPL
@ 1M
• 3-input mixer, 2-band EQ and link out
• Electronic Time Correction, Phase
Alignment, & Equalization
INTRODUCTION / FEATURES
PHONIC CORPORATION
Page 4 P(A)450/550 USER’S MANUAL
PRECAUTIONS
Place the system near a power outlet so you can
easily plug it in.
Connect the included power cord only to an AC
outlet of the type stated in this manual or printed on
the system.
Hold the power cord plug when disconnecting it from
an AC outlet. Never pull the cord in case you
damage it.
Do not scratch, bend, twist, pull, or heat the power
cord. Do not place heavy objects, including this
unit, on top of the power cord. Be careful not to
place heavy objects on a power cord covered by a
carpet, either. A damaged power cord can easily
cause fire or electrical shock hazard.
If the power cord is damaged (i.e., cut or a bare wire
is exposed), ask the local dealer for a replacement.
Using the unit with a damaged power cord can easily
cause fire or electrical shock hazard.
Do not touch the power plug with wet hands. Doing
so may lead to potential electrical shock hazard.
Should this unit be dropped or the cabinet be
damaged, turn the power switch off immediately.
Then remove the power plug from the AC outlet, and
contact the local dealer. If you ignore it and
continue to use the unit without following this
instruction, fire or electrical shock is a very likely
result.
If you smell anything, or notice any abnormality,
such as smoke, odor, or noise, or if a foreign object
or liquid gets inside the unit, turn it off immediately .
Remove the power cord from the ACoutlet. Consult
your dealer for repair. Using the unit in this
condition could easily cause fire or electrical shock
hazard.
Turn off all audio equipment and speakers when
connecting to this unit. Use the correct connecting
cables and connect as specified.
Always lower the volume control to the minimum
level before turning power on. A sudden blast of
sound may cause hearing discomfort.
When rack-mounting the unit, allow enough free
space around the unit for normal ventilation.
For normal ventilation during operation, remove the
rear of the rack or open a ventilation hole. If the
airflow is not adequate, the unit will heat up inside
and may cause fire.
If you stack the speakers, secure the handles of the
speakers by using a belt and fix the speakers to the
floor or wall to prevent them from falling and causing
injury. Without safety protection in advance, do not
stack more than two speakers.
Do not use the handles to suspend the speaker; it
may otherwise fall and cause injury .
XLR-type connectors are wired as follows:
pin 1=ground, pin 2=hot(+), and pin 3=cold(-).
Using a mobile telephone near this unit may induce
noise. If noise occurs, take the telephone away from
the unit.
Do not use the speaker at uncomfortably loud level
that may cause hearing discomfort.
Do not allow water to spill into this system or allow
the unit to become wet, which may result in
electrical shock.
Do not place a container with liquid or small metal
objects on top of this system. Liquid or metal
objects inside this system are could easily cause
fire or electrical shock hazard.
Do not remove the unit
’
s cover. You would likely
receive an electrical shock. If internal inspection,
maintenance, or repair is necessary, please refer to
your dealer.
Do not modify the unit under any circumstance.
Doing so can easily cause fire or electrical shock
hazard.
PRECAUTIONS
PHONIC CORPORATION
Page 5P(A)450/550 USER’S MANUAL
P450 / 550
P450/P550 speaker accepts either 4-pin speakon
connector or 1/4" phone jack, and are always parallel
connected. Only Pin 1+ and Pin 1- are used in the
speakon connector, and wired as follow: Pin1+ for
“+”
and Pin1- for “-”.
Please see the following illustration for connection.
MAINTENANCE / P450/550 P ASSIVE VERSION
MAINTENANCE
These speakers are high quality units made
especially according to Phonic specification.
Overpowering the unit or overheating it because of
improper system arrangement could harm the unit.
For longest possible operating life, it is
recommended that there is at least a few inches
away from the wall when you place the active version
speaker against it. Please also avoid exposing the
speaker to moisture or extreme cold weather
condition. Do not put the speaker anywhere near
water--swimming pool, swamp, kitchen sink, laundry
tub, bathtub, or a wet basement. Use a damp cloth
to clean the cabinets.
Replacement diaphragms and re-cone kit can be
ordered from local dealers. Please contact your
Phonic dealer when they are needed. Only identical
parts should be used for replacement. Phonic takes
no responsibility for improper repair, replacement,
or any other services conducted by unqualified
technician.
Loading...