Philips MCB395 05 User Manual
Micro Hi-Fi System
Register your product and get support at
www.philips.com/welcome
User manual
Benutzerhandbuch
Manuale dell'utente
Brukerhåndbok
Brugervejledning
MCB395
Important notes for users in the
U.K.
Mains plug
This apparatus is fitted with an approved 13
Amp plug. To change a fuse in this type of plug
proceed as follows:
1 Remove fuse cover and fuse.
2 Fix new fuse which should be a BS1362 5 Amp,
A.S.T.A. or BSI approved type.
3 Refit the fuse cover.
If the fitted plug is not suitable for your socket
outlets, it should be cut off and an appropriate
plug fitted in its place.
If the mains plug contains a fuse, this should
have a value of 5 Amp. If a plug without a fuse
is used, the fuse at the distribution board
should not be greater than 5 Amp.
Note: The severed plug must be disposed of to
avoid a possible shock hazard should it be
inserted into a 13 Amp socket elsewhere.
How to connect a plug
The wires in the mains lead are coloured with
the following code: blue = neutral (N),
brown = live (L).
¶ As these colours may not correspond with the
colour markings identifying the terminals in
your plug, proceed as follows:
– Connect the blue wire to the terminal
marked N or coloured black.
– Connect the brown wire to the terminal
marked L or coloured red.
– Do not connect either wire to the earth
terminal in the plug, marked E (or e) or
coloured green (or green and yellow).
Before replacing the plug cover, make certain
that the cord grip is clamped over the sheath
of the lead - not simply over the two wires.
CAUTION
Use of controls or adjustments or
performance of procedures other than
herein may result in hazardous
radiation exposure or other unsafe
operation.
Copyright in the U.K.
Recording and playback of material may
require consent. See Copyright Act 1956 and
The Performer’s Protection Acts 1958 to 1972.
2
1
2
3
4
5
6
7
8
9
^
%
$
#
5
@
7
!
0
33
Italia
DICHIARAZIONE DI CONFORMITA’
Si dichiara che l’apparecchio MCD289 Philips
risponde alle prescrizioni dell’ar t. 2 comma 1
del D.M. 28 Agosto 1995 n. 548.
Fatto a Eindhoven
Philips Consumer Electronics
5616 JB Eindhoven, The Netherlands
Philips, Glaslaan 2
Norge
Typeskilt finnes på apparatens underside.
Observer: Nettbryteren er sekundert
innkoplet. Den innebygde netdelen er
derfor ikke frakoplet nettet så lenge
apparatet er tilsluttet nettkontakten.
For å redusere faren for brann eller elektrisk
støt, skal apparatet ikke utsettes for regn eller
fuktighet.
DK
Advarsel: Usynlig laserstråling ved åbning når sikkerhedsafbrydere er ude af funktion. Undgå
utsættelse for stråling.
Bemærk: Netafbryderen er sekundært indkoblet og ofbryder ikke strømmen fra nettet. Den
indbyggede netdel er derfor tilsluttet til lysnettet så længe netstikket sidder i stikkontakten.
4
Index
English ------------------------------------------------ 6
Deutsch --------------------------------------------- 30
Italiano ---------------------------------------------- 54
Bokmål --------------------------------------------- 78
Dansk --------------------------------------------- 102
English
Deutsch
ItalianoBokmål
Dansk
5
Contents
English
General Information
Supplied accessories ............................................ 7
Environmental Information ................................ 7
Safety Information ................................................ 7
About MP3 disc .................................................... 7
Hearing Safety ....................................................... 8
Preparations
Rear connections ................................................. 9
Before using the remote control.................... 11
Replacing battery (lithium CR2025) into the
remote control ................................................... 11
Controls
Controls on the set ........................................... 12
Remote control .................................................. 13
Basic Functions
Switching on/off the set and selecting functions
Switching the system to Eco Power Standby
mode ..................................................................... 15
Power-saving automatic standby ..................... 15
Volume control ................................................... 15
Sound control ..................................................... 15
Displaying the clock ........................................... 15
CD/MP3-CD Operations
Discs for playback .............................................. 16
Playing a disc ........................................................ 16
Text display .......................................................... 16
Selecting a different track ................................. 16
Finding a passage within a track ...................... 17
Selecting a desired album/track ...................... 17
Different play modes: SHUFFLE and REPEAT17
Programming the disc tracks ........................... 17
Reviewing the programme ............................... 17
Erasing the programme ..................................... 17
Connecting a USB device or memory card ........ 10
Connecting a non-USB device ...............................10
................................................................................ 15
DAB Reception
Tuning to DAB for the first time .................... 18
Re-tuning .............................................................. 18
Manual tuning ...................................................... 18
DAB information display ................................... 19
Channel & Frequency .............................................. 19
Date and Time ........................................................... 19
Bit Rate and Audio Status ....................................... 19
Menu operation .................................................. 19
Programming DAB stations ............................. 19
Tuning to preset DAB stations ........................ 19
Tuner
Tuning to radio stations .................................... 20
Programming radio stations ............................. 20
Automatic programming .........................................20
Manual programming ............................................... 20
To listen to a preset station ................................... 20
RDS ....................................................................... 21
Switching through RDS information ..................... 21
Automatic clock setting via RDS .......................... 21
External Sources
Using a non-USB device.................................... 22
Using a USB mass storage device ................... 22
Clock/Timer
Setting clock ........................................................ 24
Setting the timer................................................. 24
Activating and deactivating TIMER ................. 25
SLEEP .................................................................... 25
Specifications ........................................... 26
Maintenance.............................................. 27
Tr oubleshooting .................................... 28
6
General Information
Congratulations on your purchase and welcome
to Philips!
To fully benefit from the support that Philips
offers, register your product at www.philips.com/
welcome.
This product complies with the radio
interference requirements of the European
Community.
Supplied accessories
–2 speaker cables
– remote control
Environmental Information
All unnecessary packaging has been omitted. We
have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene (bags,
protective foam sheet).
Your system consists of materials which can be
recycled and reused if disassembled by a
specialised company. Please observe the local
regulations regarding the disposal of packaging
materials, exhausted batteries and old
equipment.
● The ventilation should not be impeded by
covering the ventilation openings with items,
such as newspapers, table-cloths, cur tains, etc.
● Do not expose the system, batteries or discs to
excessive moisture, rain, sand or heat sources
caused by heating equipment or direct sunlight.
● No naked flame sources, such as lighted candles,
should be placed on the apparatus.
● No objects filled with liquids, such as vases, shall
be placed on the apparatus.
● Install this unit near the AC outlet and where the
AC power plug can be reached easily.
● If the system is brought directly from a cold to a
warm location, or is placed in a very damp room,
moisture may condense on the lens of the disc
unit inside the system. Should this occur, the CD
player would not operate normally. Leave the
power on for about one hour with no disc in the
system until normal playback is possible.
● The mechanical par ts of the set contain self-
lubricating bearings and must not be oiled or
lubricated.
● When the system is switched to Standby
mode, it is still consuming some power.
To disconnect the system from the
power supply completely, remove the AC
power plug from the wall socket.
English
Safety Information
● Before operating the system, check that the
operating voltage indicated on the typeplate (or
the voltage indication beside the voltage
selector) of your system is identical with the
voltage of your local power supply. If not, please
consult your dealer.
● Where the MAINS plug or an appliance coupler
is used as the disconnet device, the disconnet
device shall remain readily operable.
● The apparatus shall not be exposed to dripping
or splashing.
● Place the system on a flat, hard and stable
surface.
● Place the system in a location with adequate
ventilation to prevent internal heat build-up in
your system. Allow at least 10 cm (4 inches)
clearance from the rear and the top of the unit
and 5 cm (2 inches) from each side.
About MP3 disc
Supported formats
– ISO9660, Joliet, Multisession
– Max. track number plus album is 500
– Max. nested directory is 8 levels
– The max. album number is 99
– The max. MP3 programme track number is
20
– Suppor ted VBR bit-rate
– Supported sampling frequencies for MP3 disc
are: 32 kHz, 44.1 kHz, 48 kHz
– Supported Bit-rates of MP3 disc are: 32, 64,
96, 128, 192, 256 (kbps)
Sound Quality
Ta ke note that MP3-CD compilations should
best contain only MP3 tracks (.mp3). To
achieve a good MP3 quality, a bit rate of
128 kbps is recommended.
7
General Information
English
Hearing Safety
Listen at a moderate volume.
● Using headphones at a high volume can impair
your hearing. This product can produce sounds
in decibel ranges that may cause hearing loss for
a normal person, even for exposure less than a
minute. The higher decibel ranges are offered
for those that may have already experienced
some hearing loss.
● Sound can be deceiving. Over time your hearing
"comfort level" adapts to higher volumes of
sound. So after prolonged listening, what sounds
"normal" can actually be loud and harmful to
your hearing. To guard against this, set your
volume to a safe level before your hearing
adapts and leave it there.
To establish a safe volume level:
● Set your volume control at a low setting.
● Slowly increase the sound until you can hear it
comfortably and clearly, without distortion.
Listen for reasonable periods of time:
● Prolonged exposure to sound, even at normally
"safe" levels, can also cause hearing loss.
● Be sure to use your equipment reasonably and
take appropriate breaks.
Be sure to observe the following
guidelines when using your headphones.
● Listen at reasonable volumes for reasonable
periods of time.
● Be careful not to adjust the volume as your
hearing adapts.
● Do not turn up the volume so high that you
can't hear what's around you.
● You should use caution or temporarily
discontinue use in potentially hazardous
situations.
● Do not use headphones while operating a
motorized vehicle, cycling, skateboarding, etc.; it
may create a traffic hazard and is illegal in many
areas.
8
Disposal of your old product
Your product is designed and
manufactured with high quality
materials and components,
which can be recycled and
reused.
When this crossed-out wheeled bin symbol is
attached to a product it means the product is
covered by the European Directive 2002/96/EC
Please inform yourself about the local separate
collection system for electrical and electronic
products.
Please act according to your local rules and do
not dispose of your old products with your
normal household waste. The correct disposal of
your old product will help prevent potential
negative consequences for the environment and
human health.
DAB/FM T-type antenna
Preparations
English
Speaker
(right)
AC power cord
Rear connections
The type plate is located at the rear of the
system.
For users in the U.K.: please follow the
instructions on page 2.
A Power
● Before connecting the AC power cord to the
wall outlet, ensure that all other connections
have been made.
WARNING!
–For optimal performance, use only the
original AC power cord.
–Never make or change connections with
the power switched on.
Speaker
(left)
B FM/DAB antenna connection
Hang up one end of the T-shape DAB/FM
antenna and keep the other end at horizontal
angle to it to ensure sound DAB reception.
Note:
– This system does not support MW reception.
To avoid overheating of the system, a safety
circuit has been built in. Therefore, your
system may switch to Standby mode
automatically under extreme conditions. If
this happens, let the system cool down
before reusing it (not available for all versions).
9
Loading...