Philips FW870C/22, FW870C/21, FW870C/19, FW870C/18, FW830C/34 User Manual

FW830C FW870C
1
Important notes for users in the U.K.
CLASS 1
LASER PRODUCT
Mains plug
FrançaisEnglish
This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows:
1 Remove fuse cover and fuse.
Español
2 Fix new fuse which should be a BS1362 5 Amp, A.S.T.A. or BSI
approved type.
3 Refit the fuse cover.
Deutsch ∂ППЛУИО¿PortuguêsSuomiDanskSvenskaItalianoNederlands
If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp.
Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere.
How to connect a plug
The wires in the mains lead are coloured with the following code: blue = neutral (N), brown = live (L). As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows:
• Connect the blue wire to the terminal marked N or coloured black.
• Connect the brown wire to the terminal marked L or coloured red.
• Do not connect either wire to the earth terminal in the plug, marked E (or e) or coloured green (or green and yellow).
Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not simply over the two wires.
Copyright in the U.K.
Recording and playback of material may require consent. See Copyright Act 1956 and The Performer’s Protection Acts 1958 to
1972.
2
Italia
DICHIARAZIONE DI CONFORMITA’
Si dichiara che l’apparecchio FW830C e FW870C Philips risponde alle prescrizioni dell’art. 2 comma 1 del D.M. 28 Agosto 1995 n. 548.
Fatto a Eindhoven , il 30/2/1999
Philips Consumer Electronics
Philips, Glaslaan 2
5616 JB Eindhoven, The Netherlands
Norge
Typeskilt finnes på apparatens underside.
Observer:
Den innebygde netdelen er derfor ikke frakoplet nettet så lenge apparatet er tilsluttet nettkontakten.
For å redusere faren for brann eller elektrisk støt, skal apparatet ikke utsettes for regn eller fuktighet.
Nettbryteren er sekundert innkoplet.
INDEX
FW830C
FW870C
English .....................................4
Français .................................27
Español ..................................51
Deutsch..................................75
Nederlands..........................101
Italiano.................................125
Svenska ...............................149
Dansk ...................................171
Suomi ...................................195
Português ............................217
∂ППЛУИО¿
............................ 241
EnglishFrançais
Español
NederlandsItalianoSvenskaDanskSuomiPortuguês∂ППЛУИО¿ Deutsch
3
English
4
CONTENTS GENERAL INFORMATION SAFETY INFORMATION
General Information ........................ 5
Safety Information ........................... 5
Preparation ................................. 6 - 7
Controls ..................................... 8 - 10
Operating The System ...........11 - 13
CD ............................................. 14 - 16
Tuner .........................................17 - 18
Tape...........................................19 - 20
Aux ...................................................20
Karaoke ...........................................20
Recording.................................21 - 22
Clock ................................................ 23
Timer ................................................ 23
Sleep Timer.................................... 24
Maintenance .................................. 24
Specifications ................................ 25
Troubleshooting............................. 26
General Information
• The typeplate (which contains the serial number) is located at the rear of the system.
• Recording is permissible if copyright or other rights of third parties are not infringed.
• This product complies with the radio interference requirements of the European Community.
Environmental Information
All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet).
Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.
Acknowledgement
The Dolby B NR System and the double-D symbol d are trademarks of Dolby Laboratories Licensing Corporation. Manufactured under license from Dolby Laboratories Licensing Corporation.
Accessories
– Remote control – Batteries (two AA size) for remote
control – AM loop antenna – FM wire antenna – AC power cord
(Supplied)
Safety Information
• Before operating the system, check that
the operating voltage indicated on the
typeplate (or the voltage indication
beside the voltage selector) of your
system is identical with the voltage of
your local power supply. If not, please
consult your dealer. The typeplate is
located at the rear of your system.
• When the system is switched on, do not
move it around.
• Place the system on a solid base (e.g. a
cabinet).
• Place the system in a location with
adequate ventilation to prevent internal
heat build-up in your system.
• The system incorporates a built-in
safety feature that prevents over
heating.
• Do not expose the system to excessive
moisture, rain, sand or heat sources.
• Under no circumstances should you
repair the system yourself, as this will
invalidate the warranty!
• If the system is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens of the CD unit inside the system. Should this occur, the CD player will not operate normally. Leave the power on for about one hour with no disc in the system until normal playback is possible.
• Electrostatic discharge may cause unexpected problems. See whether these problems disappear if you unplug the AC power cord and plug it in again after a few seconds.
• To disconnect the system from the power supply completely, remove the AC power plug from the wall socket.
English
5
PREPARATION
English
Rear Connections
G
STANDBY ON
E
V
L
E
R
L
E
F
C
O
O
N
O
T
W
R
B
O
U
L
S
MIN MAX
CUT OFF FREQUENCY
HIGH POWER SUBWOOFER
60Hz 150Hz
F
AUDIO OUT
E
D
AUDIO IN
LRLR
A
MAINS
DIGITAL
OUT
AC
~
AM ANTENNA
SUB-
WOOFER
OUT
AUX IN
FM ANTENNA 75
LINE OUT
FRONT
+
L
– –
R
+
LR
H
C
6
B
PREPARATION
+
-
+
-
A AM Loop Antenna
Connection
Connect the supplied loop antenna to the AM ANTENNA terminal. Place the AM loop antenna far away from the system and adjust its position for the best reception.
B FM Wire Antenna
Connection
Connect the supplied FM wire antenna to the FM ANTENNA 75 terminal. Adjust the position of the FM antenna for the best reception.
Outdoor Antenna
For better FM stereo reception connect an outdoor FM antenna to the FM ANTENNA 75 terminal using a 75 coaxial wire.
C Speakers Connection
• Connect the right speaker to Front terminal R, with the red wire to + and the black wire to -.
• Connect the left speaker to Front terminal L, with the red wire to + and the black wire to -.
• Clip the stripped portion of the speaker wire as shown.
12 mm
unlock lock
D Line Out Connection
(wireless
ready)
You can connect the audio left and right LINE OUT terminals to a optional CD Recorder ANALOGUE IN terminals. This allows you to record in an analogue format.
You can also install additional optional front active speakers away from the system (e.g. in another room) to reduce the inconvenience of running long speaker wires across rooms. You can place as many remote speakers as you like provided they operate at the same radio frequency. Connect the wireless radio frequency transmitter to the LINE OUT terminals. Place the active speakers at your preferred location. Be sure to follow the instructions supplied with the active speakers.
Note: – Availability of a wireless transmitter and its
peripherals is subjected to the approval of local authorities. Please check with your local safety or approving authority.
E Connecting other
equipment to your system
You can connect the audio left and right OUT terminals of a TV, VCR, Laser Disc player, DVD player or CD-Recorder to the AUX/CD-R IN terminals at the rear of the system.
F Subwoofer Out Connection
Connect the optional active subwoofer to the SUBWOOFER OUT terminal. The subwoofer reproduces just the low bass effect (e.g. explosions, the rumble of spaceships, etc.). Be sure to follow the instructions supplied with the subwoofer.
G Digital Out Connection
You can record the digital sound from the CD, through this output, on any audio equipment with digital input (e.g. CD Recorder, Digital Audio Tape (DAT) deck, Digital to Analog Converter and Digital Signal Processor).
Connect one end of the cinch cable (not supplied) to the DIGITAL OUT socket and the other end to the audio equipment with digital input.When connecting the cinch cable, make sure it is fully inserted.
H AC Power Supply
After all other connections have been made, connect the AC power cord to the system and to the wall outlet.
Inserting batteries into the Remote Control
• Insert the batteries (Type R06 or AA) into the remote control as shown in the battery compartment.
• To avoid damage from possible battery leakage, remove dead batteries or batteries that will not be used for a long time. For replacement, use type R06 or AA batteries.
English
7
CONTROLS
English
$ #
DISC CHANGE
DISC 1 DISC 2 DISC 3
OPEN•CLOSE
%
@
!
0
2
1
9 8
7
6
5
4
3
REC
DUB
(HSD)
MINI HIFI SYSTEM
STANDBY ON
CLOCK/ TIMER
E
R
O
M
E
T
R
N
E
PROG
J
O
PERSONAL
G
TUNER AUX
BAND
CD1 • 2 • 3
STOP• CLEARSEARCH • TUNING PLAY • SIDE
DSC
SURF
PAN
INTERACTIVE SOUND STUDIO
TAPECD
TAPE 1 • 2
STROBE VEC
HOLD
PRESET
A.REV
CDR
DBB
º
3
VEC
MAX
DBB
SOUND CONTROL
DISPLAY
S
O
X
A
M
V
O
L
U
M
U
CHANGER
N
D
E
DC
^
DOLBY B
DOLBY B
RDS/
CD TEXT
NEWS/TA
NEWS!
&
*
NR
NR
RDS
( )
¡_ ™ £
LEVEL
MIC
MIC
§
^
ª
#
ª
§
&
¤
DBB
í
à
REPEAT PROGRAM
CD DIRECT
SIDE
Å
VOLUME
É
Ç
SHUFFLE
2
TUNERTAPE 1/2CD
SLEEP TIMERAUXIS/VEC
21
DSC
ë
á
3
ª
&
§
&
&
0
ª
8
Loading...
+ 18 hidden pages