Peerless-AV KLR64255, KLR62232 Installation Instructions
KLR62232, KLR64255
ENG
1
2019-06-14 #:150-9227-1
WARNING
ENG - This product is designed to be installed on wood stud, solid concrete or cinder block walls. Hardware is
included for wood stud, solid concrete and cinder block installation. Do not begin to install product until you have
read and understood the instructions and warnings contained in this user guide. Before installing make sure
the supporting surface will support the combined load of the equipment and hardware. Screws must be tightly
secured. Do not overtighten screws or damage can occur and product may fail. Never exceed the Maximum
Load Capacity. Always use an assistant or mechanical lifting equipment to safely lift and position equipment. This
product is intended for indoor use only. Use of this product outdoors could lead to product failure or personal
injury. Be careful not to pinch ngers when operating the mount. To reduce the risk of electric shock or re, do not
expose product to water or moisture. Be sure power cord is routed so that it will not be tripped on, stepped on,
or pinched by heavy items. Avoid overloading electrical outlets or extension cords. Always disconnect the power
cord from the power outlet when installing, servicing, or not using the product for an extended period of time. Do
not block ventilation slots or fan exhaust on product. Blocking airow could damage product. Arrange product to
allow air to ow freely around product. Keep product away from direct sunlight or any source of heat. For support
please call 800-4-SIGNAGE.
ENG
Symbols
Do not overtighten screws.
ENG
WARNING
ENG
#
ENG
Skip to step.
2
2019-06-14 #:150-9227-1
ENG
Tools Needed for Assembly.
To properly tighten screws: Tighten until screw
ENG
head makes contact, then tighten another 1/2
turn. Do not overtighten screws.
1
2
5/32"
(4mm)
5/16"
(8mm)
3
+1/2
4
3/8"
(10mm)
3
2019-06-14 #:150-9227-1
ENG
Parts (Before beginning, make sure you have all parts shown below).
Parts List
A enclosure 1 152-1544 152-1545
B wall mount 1 ST635 ST640
C #14 x 2-1/2" wood screw 4 5S1-015-C03 5S1-015-C03
D 8mm concete anchor 4 590-0320 590-0320
E power strip 1 600-0370 600-0370
F locking bracket 1 152-T1502 152-T1511
G hook on bracket 1 152-T1508 152-T1520
H M5 x 20mm 3 510-1065 510-1065
KLR62232
Part #
KLR64255
Part #Description Qty
(1)
A
enclosure
E
power strip
(1)
B
wall mount
(1)
G
hook-on
bracket
(1)
(1)
F
locking bracket
4
2019-06-14 #:150-9227-1
(4)
C
#14 x 2-1/2" wood screw
(3)
H
M5 x 20mm
1
ENG
Follow and complete instructions for included wall
mount.
(4)
D
8mm concrete anchor
B
5
2019-06-14 #:150-9227-1
2
ENG
Hold enclosure over display in desired location,
and make sure that it is level. Mark the top
location of the enclosure.
B
A
3
ENG
Remove display.
ENG
4mm
Loosen.
6
2019-06-14 #:150-9227-1
Loading...