Peerless-AV IBA4-W - Installation User Manual

Loading...

Instruction / Installation Sheet

Peerless Industries, Inc. IBA4-W Easy Mount Recessed Low Voltage Cable Plates

Peerless Industries, Inc. 2300 White Oak Circle Aurora, IL 60502 800.865.8870 708.865.2110 www.peerlessmounts.com

Parts Included

1.One (1) Easy Mount Recessed Low Voltage Cable Plate

Tools Needed

1.Drywall saw

2.6 Ft. tape measure

3.Pencil

4.Screwdriver

Use Peerless Industries, Inc.’s Easy Mount Recessed Low Voltage Cable Plates to install low voltage cables behind your flat panel TV, (see Figures 2 & 3), your amplifier or other audio and video devices. These recessed low voltage cable plates are designed for use with Low Voltage / Data Cables “ONLY”.

Easy Mount Recessed Low Voltage Cable Plates are designed with the low voltage mounting brackets molded to the back of the plate (see Figure 1). The wall plate can be installed upright or upside down (see Figures 2 & 3 for upright installation).

Determine the location of your flat panel TV, amplifier or audio/video device. Use the enclosed template to cut a hole in the drywall. When cutting the hole in the drywall, allow for the location of the stud. Now simply pull your audio/video cables through the wall and through the opening in the Easy Mount Recessed Low Voltage Cable Plate (to help insert larger cables through the opening in the wall plate, the back scoop of the wall plate is removable). Now insert the Easy Mount Recessed Low Voltage Cable Plate flush into the wall. Next, screw down the wall plate screws with wings. The wings will fasten tightly against the back of the drywall (see Figure 3) and your installation is complete.

These Recessed Cable Plates are Designed for Use with Low Voltage / Data Cables “ONLY”.

Do Not Run or Pull the TV Cord or Other Electrical Cords Inside the Drywall. National Electrical Code (NEC) Does Not Allow the Installation of the TV Power Cord or an Extension Cord Behind the Wall.

CAUTION

Never install low voltage wiring during lightning storms.

Never install low voltage wiring in wet locations unless the wire is specifically designed for wet locations.

Never touch un-insulated low voltage wires or terminals unless the wire has been disconnected at its source.

Use caution when installing low voltage cables.

IMPORTANT INSTRUCTIONS

 

Read and understand all instructions.

 

Follow all warning and instructions marked on the

 

product.

5/16”-2

near a bath tub, wash bowl, kitchen sink, or

Do not use this product near water, for example

 

laundry tub, in a wet basement, or near a swimming pool.

SAVE THESE INSTRUCTIONS.

This product is patent protected by U.S. Patent number 7390964

RoHS Compliant

 

 

 

IBA4-W – Front View

IBA4-W – Back View

Figure 1

Using Template (below),

Cut a Hole in the Drywall

Low Voltage Mounting

Bracket Wing

Figure 2 - Front View

Figure 3 - Back View

4-1/16”

TEMPLATE

IBA4-W

Easy Mount Recessed Low Voltage Cable Plate

ACTUAL SIZE

CUT ALONG DOTTED LINE

ISSUED: 12-09-10 DOC#: 125-9168 Rev. 1