Peerless-AV IBA4-W Installation

Peerless Industries, Inc.
2300 White Oak Circle
Aurora, IL 60502

800.865.8870

708.865.2110
www.peerlessmounts.com

Instruction / Installation Sheet

Peerless Industries, Inc. IBA4-W Easy Mount Recessed Low Voltage Cable Plates

Parts Included

1. One (1) Easy Mount Recessed Low Voltage Cable Plate

Tools Needed

1. Drywall saw

2. 6 Ft. tape measure

3. Pencil

4. Screwdriver

Use Peerless Industries, Inc.’s Easy Mount Recessed Low
Voltage Cable Plates to install low voltage cables behind your flat
panel TV, (see Figures 2 & 3), your amplifier or other audio and
video devices. These recessed low voltage cable plates are
designed for use with Low Voltage / Data Cables “ONLY”.

Easy Mount Recessed Low Voltage Cable Plates are designed
with the low voltage mounting brackets molded to the back of the
plate (see Figure 1). The wall plate can be installed upright or
upside down (see Figures 2 & 3 for upright installation).

Determine the location of your flat panel TV, amplifier or
audio/video device. Use the enclosed template to cut a hole in
the drywall. When cutting the hole in the drywall, allow for the
location of the stud. Now simply pull your audio/video cables
through the wall and through the opening in the Easy Mount
Recessed Low Voltage Cable Plate (to help insert larger cables
through the opening in the wall plate, the back scoop of the wall
plate is removable). Now insert the Easy Mount Recessed Low
Voltage Cable Plate flush into the wall. Next, screw down the wall
plate screws with wings. The wings will fasten tightly against the
back of the drywall (see Figure 3) and your installation is
complete.

Figure 1

Figure 3 - Back View

weiV kcaB – W-4ABI weiV tnorF – W-4ABI

Using Template (below),
Cut a Hole in the Drywall

Low Voltage Mounting

Bracket Wing

Figure 2 - Front View

These Recessed Cable Plates are Designed for Use

with Low Voltage / Data Cables “ONLY”.

Do Not Run or Pull the TV Cord or Other Electrical

Cords Inside the Drywall. National Electrical Code (NEC)

Does Not Allow the Installation of the TV Power Cord or an

Extension Cord Behind the Wall.

CAUTION

 Never install low voltage wiring during lightning storms.
 Never install low voltage wiring in wet locations

unless the wire is specifically designed for wet
locations.

 Never touch un-insulated low voltage wires or

terminals unless the wire has been disconnected at
its source.

 Use caution when installing low voltage cables.

IMPORTANT INSTRUCTIONS

 Read and understand all instructions.
 Follow all warning and instructions marked on the

product.

 Do not use this product near water, for example

near a bath tub, wash bowl, kitchen sink, or
laundry tub, in a wet basement, or near a
swimming pool.

 SAVE THESE INSTRUCTIONS.

This product is patent protected by U.S. Patent number 7390964

RoHS Compliant

4-1/16”

TEMPLATE

IBA4-W

Easy Mount Recessed Low Voltage Cable Plate

2-5/16”

ACTUAL SIZE

CUT ALONG DOTTED LINE 

ISSUED: 12-09-10 DOC#: 125-9168 Rev. 1