Panasonic UG-5510 Material Safety Data Sheet

PanasonicPanasonic

Document Imaging Company

Product Engineering

- 50 Meadowland Parkway, Panazip 2F-4, Secaucus, NJ 07094

Material Safety Data Sheet

Published on - September 11, 2001

The following 8 pages contain the Material Safety Data Sheet (MSDS) for the Toner
and OPC Drum used for Panafax UF-790.

The applicable Product Order Number is:

UG-5510 - Toner Cartridge (Toner and OPC Drum).

•

Matsushita Graphic Communication Systems, Inc.

Document System Products Division

9-1 Hiraide Industrial Park, Utsunomiya City, Tochigi, 321-8502 Japan

TEL : Japan (0) 28-683-6660, FAX : Japan (0) 28-662-8393

Material Safety Data Sheet

Page: 1 of 4

MSDS No.: 021-000155

MSDS-2000

Date :

11th September, 2001

SECTION 1 PRODUCT IDENTIFICATION
Product Name : Toner, Toner Cartridge UG-5510 for Panasonic Facsimile machine

Model UF-790

Product No. : UG-5510 Toner

SECTION 2 COMPOSITION/INFORMATION ON INGREDIENTS

INGREDIENTS

(Common Name) CAS #

PROPORTION

(% by wt.) OSHA PEL ACGIH TLV OTHER LIMITS

· Styrene acrylate
copolymer

27136-15-8 > 56.0 None established None established None

· Iron oxide 1317-61-9 < 40.0 None established None established None

· Polypropylene 9010-79-1 < 4.0 None established None established None

SECTION 3 HAZARDOUS IDENTIFICATION
EMERGENCY OVERVIEW : Odorless black fine powder

Not a highly flammable, but when suspended in air, is
combustible as with most organic powders.

POTENTIAL HEALTH EFFECTS:

EYE EFFECTS : Solid or dusts may cause irritation or corneal injury.

SKIN EFFECTS : Essentially nonirritating to skin.

Skin absorption is unlikely due to physical properties.

INGESTION EFFECTS : Oral toxicity is believed to be low.

INHALATION EFFECTS :

Minimal irritation to respiratory track may occur.

FIRE AND EXPLOSION

SENSITIVITY TO MECHANICAL IMPACT:
SENSITIVITY TO STATIC CHARGE:

None
None

Page: 2 of 4

MSDS No.: 021-000155

MSDS-2000

SECTION 4 FIRST AID MEASURES
EYES: Flush eyes immediately with plenty of water for at least 15minutes.

SKIN: Flush with plenty of water. Use soap.

INGESTION: No adverse effects anticipated by this route of exposure incidental

to proper handling.

INHALATION: Remove to fresh air. If effects occur, consult medical personnel.

SECTION 5 FIRE FIGHTING MEASURES
FLAMMABLE PROPERTIES

FLASH POINT: No data available.
FLAMMABLE LIMITS: No data available.

EXTINGUISHING MEDIA : Water fog, dry chemical, foam or CO

2

.

FIRE-FIGHTING EQUIPMENT: Wear full bunker gear including a positive pressure

self-contained breathing apparatus in case of burning
in large quantities.

SECTION 6 ACCIDENTIAL RELEASE MEASURES
Minimize the release of particulates. Wear personal protective equipment.

Do not use vacuum cleaner.
After by lightly spraying with water to prevent development of dust, spills should
be swept up or wiped up. Then, residuals can be removed with soap and water.
Preferred to use the material in a place, covering up the floor and surrounding
matters with suitable sheets such as paper, in a case of being not fit to scrub
the floor with water. These used sheets should be wrapped up in spills and transfer
into a suitable container for disposal.
Garments may be washed or dry cleaned, after removal of loose toner.

SECTION 7 HANDLING AND STORAGE
Avoid creating dust. Clean up all spills promptly.

Inhalation and contact with skin or eyes should be avoided.
Provide general ventilation. Good general ventilation should be sufficient for
most conditions.
Store in a cool, well ventilated place away from flames and spark-producing
equipment.
May toners be preferred to use or to handle at the suitable place without
concerning about smudges to which are given rise by releasing them.

SECTION 8 EXPOSURE CONTROLS/PERSONAL PROTECTION
RESPRIRATORY PROTECTION: For most conditions, no respiratory protection

should be needed; however, in dusty atmospheres, use
an approved dust respirator.

SKIN PROTECTION: No precautions should be needed under normal use.

EYE PROTECTION: No precautions should be needed under normal use.