For optimum performance and safety, please read these instructions carefully.
Please keep this manual for future reference.
If you have any questions, contact: 1-800-211-PANA (7262)
Register online at www.panasonic.com/register
La referencia rápida en español se puede encontrar en la página 15.
(U.S. customers only)
P
Model No. SC-AKX75
RQT9789-P
Do the procedures with the remote control. You can
DATE OF PURCHASE
DEALER NAME
DEALER ADDRESS
TELEPHONE NUMBER
10. Protect the power cord from being walked on or
pinched particularly at plugs, convenience
receptacles, and the point where they exit from
the apparatus.
11. Only use attachments/accessories specified by
the manufacturer.
12. Use only with the cart, stand, tripod,
bracket, or table specified by the
manufacturer, or sold with the
apparatus. When a cart is used,
use caution when moving the
cart/apparatus combination to avoid
injury from tip-over.
13. Unplug this apparatus during lightning storms or
when unused for long periods of time.
14. Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has
been damaged in any way, such as power-supply
cord or plug is damaged, liquid has been spilled
or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped.
accordance with the manufacturer’s instructions.
radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
or grounding-type plug. A polarized plug has two
blades with one wider than the other. A groundingtype plug has two blades and a third grounding
prong. The wide blade or the third prong are
provided for your safety. If the provided plug does
not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
also use the buttons on the main unit if they are the
same.
Your system and the illustrations can look differently.
These operating instructions are applicable to the
following system.
SystemSC-AKX75
Main unitSA-AKX75
SpeakersSB-AKX75
SubwooferSB-AKW75
The model number and serial number of this product
can be found on either the back or the bottom of the unit.
Please note them in the space provided below and keep
for future reference.
MODEL NUMBERSC-AKX75
SERIAL NUMBER
User memo:
Inside of product
RQT9789
2
IMPORTANT SAFETY
INSTRUCTIONS
Read these operating instructions carefully before using the unit. Follow the safety instructions on the unit and the
applicable safety instructions listed below. Keep these operating instructions handy for future reference.
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in
8. Do not install near any heat sources such as
9. Do not defeat the safety purpose of the polarized
Safety precautions
ENGLISH
WARNING!
Unit
• To reduce the risk of fire, electric shock or product
damage,
– Do not expose this unit to rain, moisture, dripping or
splashing.
– Do not place objects filled with liquids, such as
vases, on this unit.
– Use only the recommended accessories.
– Do not remove covers.
– Do not repair this unit by yourself. Refer servicing to
qualified service personnel.
• Do not let metal objects fall inside this unit.
CAUTION!
Unit
• To reduce the risk of fire, electric shock or product
damage,
– Do not install or place this unit in a bookcase, built-in
cabinet or in another confined space. Ensure this
unit is well ventilated.
– Do not obstruct this unit’s ventilation openings with
newspapers, tablecloths, curtains, and similar items.
– Do not place sources of naked flames, such as
lighted candles, on this unit.
• Set the unit up on an even surface away from direct
sunlight, high temperatures, high humidity, and
excessive vibration.
• The power plug is the disconnecting device. Install this
unit so that the power plug can be unplugged from the
socket outlet immediately.
• This unit utilizes a laser. Use of controls or adjustments
or performance of procedures other than those
specified herein may result in hazardous radiation
exposure.
Battery
• Danger of explosion if battery is incorrectly replaced.
Replace only with the type recommended by the
manufacturer.
• When disposing the batteries, please contact your
local authorities or dealer and ask for the correct
method of disposal.
• Do not heat or expose to flame.
• Do not leave the battery(ies) in a car exposed to direct
sunlight for a long period of time with doors and
windows closed.
• Do not break open or short-circuit the battery.
• Do not charge the alkaline or manganese battery.
• Do not use the battery if the cover has peeled off.
• Remove the battery if you do not use the remote
control for a long period of time. Keep in a cool, dark
area.
CAUTION: TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT
REMOVE SCREWS.
NO USER-SERVICEABLE PARTS
INSIDE.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
The lightning flash with arrowhead
symbol, within an equilateral triangle,
is intended to alert the user to the
presence of uninsulated “dangerous
voltage” within the product’s
enclosure that may be of sufficient
magnitude to constitute a risk of
electric shock to persons.
The exclamation point within an
equilateral triangle is intended to alert
the user to the presence of important
operating and maintenance
(servicing) instructions in the
literature accompanying the
appliance.
Information on Disposal in other Countries outside
the European Union
This symbol is only valid in the European
Union.
If you wish to discard this product, please
contact your local authorities or dealer and
ask for the correct method of disposal.
RQT9789
3
FCC Note:
Tweeter
32
13
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Any unauthorized changes or modifications to this
equipment would void the user’s authority to operate
this device.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Responsible Party:
Panasonic Corporation of North America
One Panasonic Way, Secaucus, NJ 07094
Support Contact:
Panasonic Consumer Marketing Company of North
America
Telephone No.: 1-800-211-PANA (7262)
RQT9789
4
Supplied accessories
Check and identify the supplied accessories.
Use numbers indicated in parentheses when asking for
replacement parts. (Product numbers correct as of
March 2013. This may be subject to change.)
To order accessories, refer to “Accessory Purchases
(United States and Puerto Rico)” on page 19.
1 x AC power supply cord
(K2CB2CB00022)
1 x AM loop antenna
(N1DYYYY00011)
1 x FM indoor antenna
(RSAX0002)
1 x Remote control battery
1 x Remote control
(N2QAYB000636)
1 x Audio cable
(K2KYYYY00230)
Placement of speakers
Front speakers
Put the speakers so that the tweeter is on the outside.
Subwoofer
Put on the floor or a sturdy shelf to reduce vibration.
CAUTION!
Do not touch the subwoofer cone's reverberating
surfaces:
• This may damage the subwoofer cone.
• The subwoofer cone may be hot.
Use only the supplied speakers.
You can cause damage to the system and decrease the
sound quality if you use other speakers.
Note:
• Keep your speakers at least 10 mm ( ″) away from
the system for proper ventilation.
• Put the speakers on a flat safe surface.
• These speakers do not have magnetic shielding. Do
not put them near TVs, PCs or other equipment easily
influenced by magnetism.
• When you play at high levels for a long period, it can
cause damage to the speakers and decrease the life of
the speakers.
• Decrease the volume in these conditions to prevent
damage:
– When the sound is distorted.
– When you adjust the sound quality.
CAUTION!
• Use the speakers only with the recommended
system. If not, you can cause damage to the
amplifier and speakers and can cause a fire.
Consult an approved service personnel if damage
occurs or if there is a sudden apparent change in
performance.
• Do the procedures included in these instructions
when you attach the speakers.
Making the connections
1
2
4
3a
3b
B
A
Tape
3a
3b
To household
AC outlet
ENGLISH
Connect the AC power supply cord only after all the
other connections have been made.
1 Connect the AM loop antenna.
Stand the antenna up on its base until it clicks.
2 Connect the FM indoor antenna.
Place the antenna where reception is best.
3 Connect the speakers.
Connect the speaker cables to the terminals of the
same color.
4 Connect the AC power supply cord.
Do not use an AC power supply cord from other
equipment.
Conserving power
The system consumes approximately 0.2 W when it
is in standby mode. Disconnect the power supply if
you do not use the system.
Some settings will be lost after you disconnect the
system. You have to set them again.
Preparing the remote control
Use alkaline or manganese battery.
Install the battery so that the poles (+ and –) align with
those in the remote control.
RQT9789
5
Overview of controls
A
B
C
D
E
G
F
H
J
I
K
L
N
M
O
P
SLEEP
D.BASS
DISPLAY
DIMMER
SOUND
PLAY
EXT-IN
RADIO
PRESET EQ
AUTO OFF
A Standby/on switch [`], [1]
Press to switch the unit from on to standby mode or vice versa. In standby mode,
the unit is still consuming a small amount of power.
B Numeric buttons [1 to 9, 0, 10]
To select a 2-digit number
Example: 16: [ 10]=[1]=[6]
C Delete a programmed track
D Select audio source
E Basic playback control
F Select the sound effects
G Auto preset the radio station
H View content information
Decrease the brightness of the display panel
Press and hold [– DIMMER] on the remote control or press [DIMMER] on the main
unit to use this function.
To cancel, do the above step again.
I Set the clock and timer
J Set the program function
K Adjust the volume of the system
L Mute the sound of the system
Press the button again to cancel.
“MUTE” is also canceled when you adjust the volume or when you switch off the
system.
M Set the play menu item
N Set the radio menu item
O Select the option
P Automatically switch off the system
When you are in disc or USB source, the auto off function switches off the system if
you do not use the system for 30 minutes.
To cancel, press the button again.
RQT9789
6
Loading...
+ 14 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.