Panasonic cs-me9sb4u installation
TEM P
O
TIMER
S
O
N
OFF1
2
C
K
Install Manual
Air Conditioner
FAN
AUTO
SPEED
HEAT
AIR
COOL
SWING
DRY
FAN
OFF/ON
FF/ON
MODE
TEMP
AIRSWING
POWERFUL/
QUIET
FANSPEED
TIMER
ET
SET
123
3
CANCELONOFF
CANCEL
AC RC
SETCHECK CLOCK RESET
HEC
E
S
O
L
C
N
E
P
O
N
E
P
O
E
S
O
L
C
A
I
R
T
I
M
S
P
W
E
O
R
I
W
N
E
G
O
R
F
F
/
O
N
CS-ME9SB4U
Indoor Unit
Destination
USA
Canada
Please file and use this manual together with service manual for Model No. CU-2E18SBU, CU-3E19RBU, CU-4E24RBU, CU-5E36QBU
Order No. PAPAMY1604017CE, PAPAMY1505100CE, PAPAMY1312037CE.
WARNING
This service information is designed for experienced repair technicians only and is not designed for use by the general public.
It does not contain warnings or cautions to advise non-technical individuals of potential dangers in attempting to service a product.
Products powered by electricity should be serviced or repaired only by experienced professional technicians. Any attempt to service
or repair the products dealt with in this service information by anyone else could result in serious injury or death.
PRECAUTION OF LOW TEMPERATURE
In order to avoid frostbite, be assured of no refrigerant leakage during the installation or repairing of refrigerant circuit.
© Panasonic Corporation 2016
11. Installation Instruction
11.1 Attached Accessories
yt’QemaN
Drainhosewithaclip
Heat Insulator
1
2
Installation parts you
should purchase (
Sleeve ( )
Bushing-Sleeve (
Putty (Gum Type Sealer) (
)
)
)
Band
Flat washer for M10
Screw M5
Remote Control
Remote control holder
Remote control holder fixing screw
Battery
Applicable piping kit
CZ-3F5, 7BP 3/8" (9.52 mm) 1/4" (6.35 mm)
CZ-4F5, 7, 10BP 1/2" (12.7 mm) 1/4" (6.35 mm)
Piping size
Gas Liquid
4
Bend the pipe as
8
4
or more
1
1
8ft(2.4m)
FloororGradelevel
closely on the wall as
possibl e, but be careful
that it doesn’t break.
Vinyl tape (Wide) (
• Apply after carrying
out a drainage test.
)
2
2
Attaching the remote control holder to the wall
Remote control holder fixing screws
Remote
control
Remote control holder
Indoor unit
a
Outdoor
b
unit
It is advisable to avoid more than 2 blockage
directions. For better ventilation & multipleoutdoor installation, please consult au thorized
dealer/specialist.
•
This illustration is for explanation pur pose s only.
The indoor unit w ill actually face a different way.
•
Respective outdoor unit installation procedure
shall refer to instruction manual provided in the
outdoor unit packaging.
Saddle (
)
11.2 Indoor Unit
11.2.1 Selecting the Location for the Indoor Unit
Provide a check port on the piping side ceiling for repair and maintenance.
Install the indoor unit once the following conditions are satisfied and after receiving the customer approval.
1 The indoor unit must be within a maintenance space.
2 The indoor unit must be free from any obstacles in path of the air inlet and outlet, and must allow spreading
of air throughout the room.
3 Mount with the lowest moving parts at least 8 ft (2.4 m) above floor or grade level.
"
16
11
19
39
(1000)
(Unit: inch (mm))
or more
Obstacles
3
/8"
"
8
/
1
96"–118
(2400 – 30 00)
Floor
(500) or
more
/16"
1911/16"
(500) or
more
11
19
(500) or
more
* If the height from the floor to ceiling exceeds three meters, air flow distribution deteriorates and the effect is
decreased.
4 The installation position must be able to support a load four times the indoor unit weight.
5 The indoor unit must be away from heat and steam sources, but avoid installing it near an entrance.
16
/
13
/16"
(Unit: inch (mm))
(300) or less
11
6 The indoor unit must allow easy draining.
n
nch
7 The indoor unit must allow easy connection to the outdoor unit.
8 Place the indoor unit according to the height from the ceiling shown in the illustration below.
9 The indoor unit must be from at least 9.8 ft (3 m) away from any noise-generating equipment. The electrical
wiring must be shielded with a steel conduit.
10 If the power supply is subject to noise generation, add a suppressor.
11 Do not install the indoor unit in a laundry. Electric shocks may result.
Note
Thoroughly study the following installation locations
1 In such places as restaurants and kitchens, considerable amount of oil steam and flour adhere to the turbo
fan, the fin of the heat exchanger and the drain pump, resulting in heat exchange reduction, spraying,
dispersing of water drops, drain pump malfunction, etc.
In these cases, take the following actions:
o Make sure that the ventilation fan for smoke-collecting hood on a cooking table has sufficient capacity so
that it draws oily steam which should not flow into the suction of the air conditioner.
o Make enough distance from the cooking room to install the air conditioner in such place where it may not
suck in oily steam.
Air conditioner
Use the ventilation fan for smoke-
Ensure ample
distance
Cooking table
collection hood with sufficient capacity.
2 Avoid installing the air conditioner in such
circumstances where cutting oil mist or iron
powder exist especially in factories, etc.
3 Avoid places where inflammable gas is
generated, flows-in, contaminated, or leaked.
4 Avoid places where sulphurous acid gas or
corrosive gas can be generated.
5 Avoid places near high frequency generators.
Model Name Height in the ceiling
ME9***
11" (280 mm) or
more
11.2.2 Installation of Indoor Unit
This air conditioner uses a drain up motor.
Horizontally install the unit using a level gauge.
CEILING OPENING DIMENSIONS AND
BOLT LOCATION
The paper model for installation expand or shrink
according to temperature and humidity.
Check on dimensions before using it.
Caution
During the installation, care must be taken
not to damage electric wires.
The dimensions of the paper model for installation
are the same as those of the ceiling opening
dimensions.
Be sure to discuss the ceiling drilling work with the
workers concerned.
HANGING
it: i
(mm))
259/16" (650) (Ceiling opening)
23/8"
(60)
7
20
/8" (530)
(Hanging bolt)
2213/16" (580)
(Unit size)
Refrigerant pipe
(U
Drain pipe
3
2
/8"
(60)
23/8"
(60)
" (530)
" (580)
16
/
13
(Unit size)
22
8
/
7
20
(Hanging bolt)
" (650) (Ceiling opening)
16
/
9
25
"
8
/
3
(60)
17
Loading...