HELPFUL INFORMATION
Auto Operation Button
■ Automatic Operation
• If the remote control fails to function or misplaced, press Auto Operation button
for Automatic operation.
• The Automatic operation will be activated immediately once the Auto operation
button is pressed. However, temperature cannot be adjusted in this operation.
• The power LED on the indoor unit blinks until the operation mode is selected
automatically.
• To cancel this operation, press once more.
■
•
•
TIMER
SLEEP
POWER
ECONOMY
POWERFUL
•
•
■ Remote Control Signal Receiving Sound
• To switch off the beep (Signal Receiving Sound), press this Auto Operation
button for 10 seconds continuously or longer.
“Beep”, “beep” sound will be heard at the tenth seconds.
Note: “Beep” sound will be heard at the fifth seconds; However please press
continuously until you heard “beep” , “beep” sound.
• Repeat this, if you want to switch on the Signal Receiving Sound.
■
•
•
•
* Note: If you press this button continuously for 5 to 10 seconds, Test Run
operation will be performed. A “beep” sound will be heard at the fifth seconds, to
identify the starting of Test Run operation.
(This is for Servicing purpose only.)
*
Auto Restart Control
• If power is resumed after a power failure, the operation will restart
automatically after 3 - 5
• Operation will be automatically restart under the previous operation mode and
airflow direction when power is resumed as the operation is not stopped by
remote control.
1/2 minutes.
25
POWER FAILURE
•
•
Timer Setting
• When power failure occurs, the timer setting is cancelled. Once power is
resumed, reset the timer.
•
Thunder and Lightning
• This air conditioner is equipped with a built-in surge
protective device. However, in order to further
protect your air conditioner from being damaged by
abnormally strong lightning activity, you may switch
off the main power supply and unplug from power
socket.
•
ENERGY SAVING AND OPERATION HINTS
Air Filter and Air Purifying Filter
Clean the air filter every 2 weeks and
Setting Temperature
Set the temperature 1°C higher
(Cooling operation) or 2°C
lower (Heating operation) than
actually desired.
Approximately 10% of electricity
costs can be saved.
change the Air Purifying Filter every 3
months. Dirty filter may reduces cooling
or heating efficiency.
Keep All Doors and Windows Closed
Otherwise, cooling and heating
performance will be reduced and
electricity costs is wasted.
ENGLISH
Outdoor Unit
Do not block the air outlet
vents. Otherwise, it will lower
the cooling or heating
performance.
Timer and Sleep Mode
To prevent wastage of electricity,
use sleep mode when sleeping or
Timer when going out to save
electricity cost.
Avoid Direct Sunlight
Keep curtains or drapes closed to keep
out direct sunlight during cooling
operation.
26
! WARNING
This appliance must be earthed.
! CAUTION
Remove power plug or disconnect from the mains before servicing the appliance.
IMPORTANT
The wires in this mains lead are coloured in accordance with the following code:
Green-and-yellow : Earth
Blue : Neutral
Brown : Live
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is
marked with the letter E or by the earth symbol ! or coloured green or green-and-yellow.
The wire which is coloured blue must be connected to the terminal which is marked with the letter N
or coloured black.
The wire which is coloured brown must be connected to the terminal which is marked with the letter L
or coloured red.
NOTE
If the supply cord is damaged, it must be replaced by the special cord obtainable at authorized
service/parts centers.
Disconnect the mains plug from the supply socket when not in use, where supply connection is via
mains plug.
27
!
!
ENGLISH
!
28
Loading...