Thank you for purchasing a Panasonic cordless telephone.
This handset is an accessory handset for use with Panasonic base units
BB-GT1500/BB-GT1540. You must register this handset with your base
unit before it can be used.
This installation manual describes only the steps needed to register and
begin using the handset. Please read the base unit’s operating
instructions for further details.
Charge the battery for 7 hours before initial use.
Please read this Installation Manual before using the unit and save for
future reference.
BB-GTA150
PQQX15951ZA DM0507SH0
GTA150(e).fm Page 2 Monday, May 14, 2007 4:15 PM
Accessory information
Included accessories
Accessory itemOrder numberQuantity
ChargerPQLV30054PB1
AC adaptor for chargerPQLV2081
BatteryHHR-P1071
Handset cover
Belt clipPQKE10478Z21
*1 The handset cover comes attached to the handset.
*1
PQYNGTA150BR1
Sales and support information
LTo order replacement accessories, call 1-800-332-5368.
LTTY users (hearing or speech impaired users) can call 1-866-605-1277.
Setting up the handset
Connecting the charger
(120 V AC, 60 Hz)
Note:
LUse only the included Panasonic AC adaptor PQLV208.
LThe AC adaptor must remain connected at all times. (It is normal for the adaptor to
feel warm during use.)
LThe AC adaptor should be connected to a vertically oriented or floor-mounted AC
outlet. Do not connect the AC adaptor to a ceiling-mounted AC outlet, as the weight
of the adaptor may cause it to become disconnected.
Fasten the AC adaptor cord to prevent
it from being disconnected.
Hooks
Hooks
GTA150(e).fm Page 3 Monday, May 14, 2007 4:15 PM
Battery installation
Press the notch of the handset cover
1
firmly, and slide it in the direction of
the arrow.
2 Insert the battery (A), and press it
down until it snaps into position (B).
Then close the handset cover (C,
D).
B
A
Attention:
C
D
Battery charge
Place the handset on the charger for 7
hours before initial use.
LWhile charging, the charge indicator
on the handset lights in amber. When
the battery is fully charged, the
indicator lights in green.
Charge
contacts
Note:
LIf you want to use the handset
immediately, charge the battery for at
least 15 minutes.
LTo ensure that the battery charges
properly, clean the charge contacts of
the handset and charger with a soft,
dry cloth once a month. Clean more
often if the unit is subject to the
exposure of grease, dust, or high
humidity.
A nickel metal hydride battery that is
recyclable powers the product you have
purchased.
Please call 1-800-8-BATTERY (1-800822-8837) for information on how to
recycle this battery.
For product assistance, visit www.panasonic.com/help3
For A assistance, visit www.joip.com
GTA150(e).fm Page 4 Monday, May 14, 2007 4:15 PM
Panasonic battery performance
Operation
While in use (talking) Up to 6 hours
While not in use
(standby)
While using the clarity
booster feature
Note:
LThe handset can be left on the
charger without any ill effect on the
battery.
LThe battery level may not be
displayed correctly after you replace
the battery. In this case, place the
handset on the charger and let it
charge for 7 hours.
Operating
time
Up to 14 days
Up to 4 hours
Registration
Register the handset to a BB-GT1500/
BB-GT1540 base unit.
1 Base unit:
BB-GT1500
Press and hold {HANDSET
LOCATOR} until the STATUS
indicator flashes in red.
BB-GT1540
Press and hold {LOCATOR} until
the registration tone sounds and the
STATUS indicator flashes in red.
LIf all registered handsets start
ringing, stop ringing by pressing
the same button. Then repeat this
step.
LAfter the STATUS indicator starts
flashing in red, the rest of the
procedure must be completed
within 90 seconds.
2 Handset:
{OKL}
LWhen the handset has been
registered successfully, _ will
change to w.
Changing the display
language
1
{OFF} i {MENU} i
{#}{1}{1}{0}
2 {V}/{^}: Select the desired setting.
3 Press down the center of the joystick
You can hang the handset on your belt
or pocket using the included belt clip.
To attach the belt clip
To remove the belt clip
While pressing the top of the clip (A),
pull the right edge in the direction of the
arrow (B).
B
A
Wall mounting
1 Drive the screws (not included) into
the wall.
25.4 mm
(1 inch)
Screws
(120 V AC, 60 Hz)
2 Mount the charger (A), then slide it
down (B) and to the right (C) until it
is secure.
A
B
C
For product assistance, visit www.panasonic.com/help5
For A assistance, visit www.joip.com
GTA150(e).fm Page 6 Monday, May 14, 2007 4:15 PM
Headset (optional)
Connecting a headset to the handset
allows for hands-free phone
conversations. We recommend using a
Panasonic KX-TCA60/KX-TCA86/KXTCA88HA/KX-TCA92/KX-TCA93/KXTCA94/KX-TCA95 headset. See page
2 for ordering information.
LHeadset shown is KX-TCA86.
Specifications
General
Operating environment:
5 °C – 40 °C (41 °F – 104 °F)
Handset
Frequency:
5.74 GHz – 5.84 GHz
Dimensions:
Approx. height 156 mm × width 48 mm ×
depth 33 mm (6
inches × 1
Mass (Weight):
Approx. 160 g (0.35 lb.)
Power output:
200 mW (max.)
Power supply:
Ni-MH battery (3.6 V, 650 mAh)
Charger
Dimensions:
Approx. height 68 mm × width 82 mm ×
depth 87 mm (2
inches × 3