Oster FPSTBW8100 Installation Manual
WINE VACUUM CORK
CORCHO EVACUADOR PARA VINO
User Guide/ Guía del Usuario:
FPSTBW8100
Safety
Seguridad
How to use
Cómo usar
Care & Cleaning
Cuidado y Limpieza
FAQ s
Preguntas frecuentes
Warranty
Garantía
www.oster.com
IMPORTANT SAFEGUARDS
When using the Wine Vacuum Cork, basic safety precautions should always
be followed including the following:
1. READ ALL INSTRUCTIONS BEFORE USE
2. Do not operate WINE VACUUM CORK after the appliance malfunctions
or if it is dropped or damaged in any manner. Refer to warranty section.
3. To protect against risk of electrical shock, do not put the
WINE VACUUM CORK in water or other liquid. This may cause
personal injury and/or damage to the product.
4. To protect against fi re, do not operate the unit in the presence of
explosive and/or fl ammable fumes.
5. Do not use the WINE VACUUM CORK for other than intended use.
6. For household indoor use only. Do not expose the
WINE VACUUM CORK to rain or other extreme conditions.
7. Do not attempt to disassemble the WINE VACUUM CORK. It has no
serviceable parts. Your WINE VACUUM CORK is guaranteed for one
year. In the event of a malfunction in this time please contact our
customer services department.
8. Use only AAA ALKALINE BATTERIES IN THE UNIT.
9. Make sure the battery cover is securely locked in place before operating.
10. Remove batteries from battery compartment if storing unit for
extended periods of time.
11. Maintain Appliance away from face and eyes.
2
www.oster.com
THIS PRODUCT IS FOR HOUSEHOLD USE ONLY
SAVE THESE INSTRUCTIONS
Thank you for purchasing the OSTER™
Wine Vacuum Cork. Before you use this product
for the fi rst time, please take a few moments to
read these instructions and keep it for reference.
Pay particular attention to the Safety Instructions
provided. Please review the product service and
warranty statements. To learn more about Oster™
products, please visit us at www.oster.com or
call us at 1-800-334-0759.
www.oster.com
3
LEARNING ABOUT YOUR
WINE VACUUM CORK
a
b
c
d
f
e
g
h
i
Battery Cover
a
Battery Compartment
b
c
Pressure Indicator
Display
d
e
Temperature Display Button
4
www.oster.com
Pressure Release Button
f
g
Silicone Gasket
h
Temperature Gauge
i
Bottom Cap
HOW TO:
Installing the Batteries
Before using your Wine Vacuum Cork for the fi rst time
install a fresh set of batteries in the battery compartment
as shown here:
1 Remove the battery cover by
twisting it counterclockwise
toward the unlock icon.
2 Insert 2 AAA alkaline batteries
into the battery compartment,
observing proper +/- polarities
3 Replace the battery cover by
twisting it clockwise toward
the lock icon until the cover
clicks into place.
4 Replace batteries when
required with only AAA
alkaline batteries.
5 Dispose old batteries per
local and national laws
and regulations.
www.oster.com
5
Operating the Wine Vacuum Cork
1 Remove bottom cap. Fully place the
wine vacuum cork on top of the neck
of an opened bottle of wine. Hold
the bottle of wine securely with
one hand and push the unit down
fi rmly and twist slightly to secure
the seal with the other hand. This
will activate the pump as shown in
fi gure 1. Repeat if necessary.
Note: It is not necessary to press
any buttons to activate the pump.
Once vacuum process starts, you
can release the vacuum cork.
fi gure 1
Vacuum process has two stages.
Stage One
The automatic vacuum pump activates, evacuating excess
air from inside the wine bottle. The “o” icon will move across
the display while the motor is running as shown in fi gure 2.
The blue back light will remain on during this time.
6
fi gure 2
www.oster.com
The pressure indicator on top of the unit will begin to sink
as the pressure in the bottle is reduced. Then a second
evacuation stage will automatically follow to extract the
air for a tighter seal.
Stage Two
During this stage the display will show the remaining
seconds counting down from 60 in increments of 1 second.
Once it reaches the last second and the display shows “1”,
the air pump will stop and the display will show the current
temperature of the wine inside in degrees Fahrenheit as
shown in fi gure 3.
The back light remains on for another 5 seconds.
The display will then completely shut off 60 seconds after
the motor stops.
Note: If the pressure in the bottle
does not reach the pre-set value in
the fi rst 60 seconds of air extraction,
the display will show “Err” as shown
in the fi g 4. If this happens please
check the following:
a Whether the Wine Vacuum Cork
is properly placed on top of the
fi gure 3
fi gure 4
neck of the bottle.
b Whether the silicone gasket fi ts the opening of the bottle.
c Whether there are any external objects on the opening
or neck of the bottle.
www.oster.com
7
Note: Most vacuum seals lose their vacuum over time. With
our unique Two Stage process, the device senses this loss in
pressure and reactivates the 2nd stage automatically to
ensure a better vacuum seal.
Converting the Temperature from
Fahrenheit to Celsius
(The default temperature unit is Fahrenheit)
1 Press and hold the temperature display button for about
2 seconds in stand by mode to activate the display.
2 Next press and hold the temperature display button for
about 5 seconds. The display will then switch to show
the temperature in degrees Celsius. You can toggle from
F to C or C to F again by pressing and holding for
another 5 seconds.
The back light remains on for another 5 seconds during
this phase. The display will then completely shut off after
60 seconds.
Automatic Tilt Shut Off
Do not tilt the bottle while the
vacuum is in use. If the bottle is tilted
beyond 45 degrees, the automatic
tilt shutoff feature stops the vacuum
process. This helps avoid spills. The
Display will show “––––“, as shown
in fi gure 5. The blue back light will
remain on for another 5 seconds
fi gure 5
then turn off but the display will
continue to show “––––“. If this happens
refer to the FAQ’s section for help.
8
www.oster.com
Low battery warning
When the batteries are low the
display will show a low battery
warning as shown in fi gure 6.
The blue back light will remain on
for another 5 seconds then turn off
but the display will continue to
show “Lo”. If this happens refer to the
FAQ’s section for help
fi gure 6
Releasing vacuum seal and removing the unit
from bottle
1 Press the pressure release button. Wait for the vacuum
to be released from the bottle (this will take a few seconds).
2 Hold bottle with one hand, then pull unit off with
the other.
3 Pour and enjoy.
Storing your wine with the
Wine Vacuum Cork attached
1 It is recommended to store your bottle in the upright
position for an optimal seal.
2 Bottles can be stored on their sides once they are vacuum
sealed, however the re-evacuation process will not occur
as the bottle has been tilted past the 45 degree angle.
Note: A bottle sealed with the unit may be stored in
the refrigerator however, cold temperatures may reduce
the battery performance. Do not operate the unit in
freezing temperatures.
www.oster.com
9
Loading...