Oster 3203-33 User Manual
MODEL
MODEL
Instruction Manual and Warranty
STAINLESS STEEL KETTLE
3203-33
3203-33
■
P.N. 111051
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should
always be followed to reduce the risk of fire, electric shock, and/or
injury to persons, including the following:
1. Read all instructions before using the machine.
2. Do not touch hot surfaces. Use handles or knobs.
3. To protect against electric shock, do not immerse this appliance
including power base, in water or any other liquid.
4. Close adult supervision is necessary when this appliance is used by
or near children.
5. Unplug the power base from the power outlet when not in use,
before repositioning and before cleaning. Allow to cool before
putting on or taking off parts, and before cleaning the appliance.
6. Do not operate any appliance with a damaged cord or plug or after
the appliance malfunctions, or has been damaged in any manner.
Return this appliance only to the nearest authorized service center
for examination, repair or adjustment.
7. The use of accessory attachments not recommended by OSTER may
cause hazards or injuries.
8. Do not use outdoors.
9. Do not let cord hang over edge of table or counter, or touch hot
surfaces.
10. Do not place this appliance on or near a hot gas or electric burner
or in a heated oven.
11. Ensure that the kettle is properly located on the power base before
switching on.
12. Remove the kettle from power base before filling or pouring. Do
not attempt to remove the kettle from the power base until it is
switched off, manually or automatically.
13. Use the kettle only with the power base supplied and vice versa.
14. Do not use appliance for other than intended use.
15. Use on a hard, flat level surface only, to avoid interruption of air
flow underneath the appliance.
16. Extreme caution must be used when handling or moving kettle and
pouring from the kettle containing boiling water.
17. Scalding may occur if the lid is removed during the heating cycle.
SAVE THESE INSTRUCTIONS
1
SPECIAL CORD SET INSTRUCTIONS
1. A short power supply cord is provided to reduce the hazards
resulting from becoming entangled in or tripping over a longer cord.
2. An extension cord may be purchased and used if care is exercised in its
use.
3. If an extension cord is used the marked electrical rating of the
extension cord must be at least 15 amps and 120 volts. The resulting
extended cord must be arranged so that it will not drape over the
counter top or table top where it can be pulled on by children or
tripped over accidentally.
* This appliance has a grounded 3-prong electrical plug. It must be plugged
only into a properly grounded 3-prong outlet. Do not modify the plug in
any way.
PRECAUTIONS:
WARNING: TO AVOID SCALDING, handle this kettle with care as
water is heating, boiling, and cooling. The lid must remain in place
during use to avoid steam burns. Keep spout away from persons as
scalding can result from steam.
1. Place the electric kettle well back from the edge of the counter.
2. This kettle is intended for boiling WATER ONLY. Do not heat any
other liquid or attempt to cook any food in this appliance.
3. NEVER place the kettle NEAR HOT SURFACES.
4. Hand wash only. ALL PARTS ARE NOT DISHWASHER SAFE.
5. Do not exceed the “Max” water level mark when filling. Overfilling
could cause hot water to boil out of the spout.
6. Do not hold the switch on as this may damage the auto shut-off
mechanism.
7. Hold top of lid when pouring from the electric kettle.
8. Carry or move electric kettle by handle only.
9. Kettle body may get very hot, be careful when handling.
10. Do not immerse the kettle or power base in water or any other
liquid.
FOR HOUSEHOLD USE ONLY
2
INTRODUCTION
Table of Contents Page #
Important Safeguards 1
Special Cord Set Instructions 2
Precautions 2
Introduction 3
Diagram of Parts 3
Clean Your Electric Kettle Before First Use 4
Using Your Electric Kettle 4
Filter Instructions 5
Filter Removal/Cleaning/Refitting 5
Care and Cleaning 6
Limited Warranty 7
Diagram of parts
Lid
Boil Tube
3
Ergonomic
Handle
Removable
Scale Filter
Illuminated
ON/OFF Switch
Power Base
Clean your electric kettle before first use
1. Wash the inside of the kettle and lid with mild detergent and water.
Rinse each thoroughly. Do not immerse the kettle or power base
in water or any other liquid. These items are not
dishwasher safe.
2. Fill the electric kettle with fresh water to the “MAX” water level mark
on boil tube. Plug power base into power outlet. Place kettle into power
base. Turn the switch ON by pressing up on ON/OFF switch. ON/OFF
light will turn on indicating kettle is ON. Let the water boil.
3. When the water and unit have cooled, discard the water. Rinse with
cold water and repeat.
4. Your electric kettle is now ready for use.
Using your Electric Kettle
1. Position the power base on a flat, heat resistant surface, as close as
possible to a power outlet.
2. Follow cord routing in power base according to exit patterns. Proper
cord routing will result in the power base laying flat when kettle is
placed in base. DO not operate kettle if power base is not flat.
Remove kettle from power base and repeat cord placement
instructions.
3. To fill with water, remove the lid. Fill the electric kettle with water to
below the “MAX” water level mark. NOTE: Do not exceed the
“MAX” water level mark indicated on the electric kettle.
4. Plug the electric cord into an electric outlet. Turn the switch ON by
pushing up on the on/off switch. The on/off light will light to
indicate the unit is on. The water will heat and the electric kettle will
switch off automatically when the water boils. NOTE: Ensure the
ON/OFF switch is clear of obstructions and the lid is firmly closed.
The electric kettle will not turn off automatically if the ON/OFF
switch is constrained, or if the lid is left open.
5. Carefully lift the kettle from the power base and pour the hot water.
6. The kettle will not re-boil until the on/off switch is again switched ON.
Wait 15-20 seconds, allowing kettle to cool down, then switch ON.
4
Loading...