Omega Products CN63500-R1-AL1-LV User Manual

1

/

16 DIN High/Low

Limit Controller

Panel Punches

CN63500 Series

U Dual 4-Digit LED Display
U Thermocouple or RTD Sensor Input
U Remote Reset Input
U Main Limit Output: 5 A Relay,

Selectable for High or Low
Trip Activiation

U 5 A Relay Alarms (Optional)
U Optional NEMA 4X (IP65) Sealed

Front Bezel

U Parameters Security Via

Programmable Lockouts

U Dual Display

The CN63500 Series are temperature limit controllers,
intended to provide an independent shutdown for
thermal processes. The CN63500 accepts signals
from a variety of temperature sensors (thermocouple or
RTD elements), and its comprehensive programming
allows it to meet a wide variety of application
requirements. Dual 4-digit displays allow viewing of the
process temperature and limit setpoint simultaneously.
Front panel indicators inform the operator of the
process and output status. The main limit output and
alarm outputs are field-replaceable. The limit output is
selectable for high or low trip activation. If the process
temperature goes above the limit setpoint for a high
trip, or below the limit setpoint for a low trip, the limit
relay will de-energize to initiate a process shutdown.
The limit output cannot be reset until the process
temperature returns to the proper operating range;
manual reset is required (local or remote). Sensor
failure will initiate a process shutdown. Relay alarm(s)
can be configured to activate according to a variety of
actions (absolute high or low, deviation high or low and
band in or out) with adjustable hysteresis. A standby
feature suppresses the alarm during power-up unit the
process stabilizes outside the alarm region. The unit
is constructed of lightweight, high-impact plastic case
with a tinted front panel. The front panel meets NEMA
4X (IP65) specifications when properly installed.
Multiple units can be stacked horizontally or vertically.
Modern surface-mount technology, extensive testing,
plush high-immunity to noise interference makes the
CN63500 extremely reliable in industrial environments.

Available Visit

omega.com/

panelpunches

CN63500-R1 shown smaller than actual size.

Specifications

Display: 2-line by 4-digit LED
Upper (Main) Display: 10.2 mm H (0.4") red LED

Lower (Secondary) Display:

7.6 mm H (0.3") green LED

Power:

Line Voltage Models: 85 to 250 Vac,
50/60 Hz, 8 VA

Low-Voltage Models:

DC Power: 18 to 36 Vdc, 7 W
AC Power: 24 Vac ±10%,
50/60 Hz, 9 VA
Memory: Non-volatile EEPROM retains all programmable
parameters and values

Environmental Conditions

Operating Range: FM rated @ 0 to 65°C,

UL rated @ 0 to 55°C

Storage Range: -40 to 80°C (-40 to 176°F)
Operating and Storage Humidity: 85% max relative

humidity (non-condensing) from 0 to 65°C (32 to 149°F)

Altitude: Up to 2000 m (6562’)

Isolation Breakdown Ratings

AC Line With Respect to All Inputs and Outputs:

2300V for 1minute (250V working)
Relay Contacts to All Other Inputs and Outputs:
2300 Vac
DC Power With Respect to Sensor Input: 50V working
(500V for 1 minute)

Connection: Wire clamping screw terminals
Weight: 0.17 kg (0.38 lb)

Input Specifications

Sensor Input

Sample Period: 100 ms
Step Response Time: Less than 300 ms typical,

400 ms max (to within 99% of final value)

Normal Mode Rejection: >40 dB @ 50/60 Hz
Common Mode Rejection: >120 dB, DC to 60 Hz
Overvoltage Protection: Input overload 120 Vac for 15 s max

P-109

45

(1.772)

+0.024

-0.000

45

(1.772)

+0.024

-0.000

105.9 (4.17)

9.4

(0.37)

+0.6

-0.0

+0.6

-0.0

45

(1.772)

+0.024

-0.000

45

(1.772)

+0.024

-0.000

+0.6

-0.0

+0.6

-0.0

Dimensions: mm (inch)

+0.6

-0.0

45

45

+0.6

-0.0

+0.024

-0.000

+0.024

-0.000

49.5

(1.95)

(1.772)

49.5

(1.95)

9.4

(0.37)

Failed Sensor Response:
Main Output: Sensor failure will initiate a
process shutdown

Display: “OPEN”
Alarms: Upscale
Indication Accuracy: ±(0.3% of span +1°C) @ 23°C ambient

after 20 minute warm-up (includes NIST conformity,
cold-junction effect, A/D conversion errors and
linearization conformity

Span Drift (Maximum): 130 PPM/°C
Rtd Input: 2- or 3-wire, 100 Ω platinum, alpha = 0.00385

(DIN43760), alpha = 0.0039162

Excitation: 150 µA typical
Lead Resistance: 15 Ω max per input lead
Remote Resent Input: Internally pulled up to 5 Vdc 1 mΩ
V

: 0.85V max

IL

V

: 3.65V min

IH

VIN Max: 5.25 Vdc
I

: 1 µA max

OFF

105.9 (4.17)

(1.772)

Output Specifications

Limit and Alarm Output Relays

Contact Rating: 5 A @ 250 Vac or 30 Vdc (resistive load)

1

/

10 HP @ 120 Vac (inductive load)

Life Expectancy: 100,000 cycles at max load rating
(decreasing load increases life expectancy)

Limit Output:

CN63500-R1-AL1: Form “C” relay

CN63500-R1-AL2: Form “A” relay
Selectable for high or low trip activation, if the process
temperature goes above the limit setpoint for a high trip,
or below the limit setpoint for a low trip, the limit relay will
de-energize to initiate a process shutdown; the limit output
cannot be reset until the process temperature returns to the
proper operating range; manual reset is required
(local or remote)

AlarmOutputs: 1 or 2 form “A” relays
Modes: Absolute high-acting, absolute low-acting, deviation

high-acting, deviation low-acting, inside band-acting, outside
band-acting
Reset Action: Programmable, automatic or latched; latched
alarms can be reset regardless of limit exceed condition

Standby Mode: Programmable, enable or disable
Hysteresis: Programmable

Thermocouple Inputs

Types: T, E, J, K, R, S, B, N, linear

mV, software selectable
Input Impedance: 20 MΩ, all types

Lead Resistance Effect: 0.25 µV/Ω
Cold-Junction Compensation: <±1°C typical, (±1.5°C

max), error over 0 to 65°C (32 to 149°F) max ambient
temperature range; defeated for linear mV indication mode

Resolution: 1° for all types, or 0.1° for T, E, J, K, and N only

Thermocouple

Display

Type Range ANSI BS1843

-200 to 400°C (+) Blue (+) White

-328 to 752°F (-) Red (-) Blue

-200 to 750°C (+) Violet (+) Brown

-328 to 1382°F (-) Red (-) Blue

-200 to 760°C (+) White (+) Yellow

-328 to1400°F (-) Red (-) Blue

-200 to 1250°C (+) Yellow (+)Brown

-328 to 2282°F (-) Red (-) Blue
0 to 1768°C (+) Black (+) White

32 to 3214°F (-) Red (-) Blue
0 to 1768°C (+) Black (+) White

32 to 3214°F (-) Red (-) Blue
149 to 1820°C (+)Grey No

300 to 3308°F (-)Red standard

-200 to 1300°C (+) Orange (+) Orange

-328 to 2372°F (-) Red (-) Blue

standard standard

-5.00 to 56.00mV No No

mV

RTD Type Range
385 -200 to 600°C (-328 to 1100°F)
392 -200 to 600°C (-328 to 1100°F)
Ω 2.0 to 320.0 Ω

To Order

Visit omega.com/cn63500 for Pricing and Details

Model No. Description
Standard Power Models (85 to 250 Vac, 50 to 60 Hz)

CN63500-R1-AL1 Single output, form

“C” relay, 1 alarm
CN63500-R1-AL2 Single output, form

“A” relay, 2 alarms

Low-Voltage Models (18 to 36 Vdc)
CN63500-R1-AL1-LV Single output,

form “C”, 1 alarm
CN63500-R1-AL2-LV Single output form

“A”relay, 2 alarms

Comes complete with operator’s manual.
Ordering Examples: CN63500-R1 AL2, 85 to 250 Vac power,

single-output relay, 2 alarms.
CN63500-R1-AL1-LV, 18 to 36 Vdc power single-output relay,

1 alarm.

Accessories (Field Installable)

Model No. Description

CN6-RBDLA210 Output module, single-output,

form “C” relay, 1 alarm
CN6-48111 Output module, single-output,

form “A” relay, 2 alarms
DPP-4

P-110

1

⁄

16 DIN panel punch

Wire Color

P