Page 1
D. REPAIR PROCEDURE
X-100/D-540ZOOM/C-310ZOOM
D. REPAIR PROCEDURE
[1] TROUBLESHOOTING GUIDE .................................................................................. D-2
POWER LOSS INOPERATIVE ............................................................................... D-2
TAKING INOPERATIVE ......................................................................................... D-2
NO PICTURE ..........................................................................................................D-2
[2] RENEWAL OF A FIRMWARE..............................................................................................D-3
D-1 Ver. 1
Page 2
[1] TROUBLESHOOTING GUIDE
D. REPAIR PROCEDURE
X-100/D-540ZOOM/C-310ZOOM
POWER LOSS INOPERTIVE
CHECK UNIT include
IC301-15 (SCAN IN 0)
PULSE INPUT
YES
IC302-7
(BOOST 3.6 V)
HIGH
IC301-17, 29
(VDD)
HIGH
IC301-25
(RESET)
HIGH
IC301-12
(BAT OFF)
HIGH
IC301-26, 27
OSCILLATION
YES
IC301-23, 24
OSCILLATION
YES
NO
LOW
LOW
LOW
LOW
NO
NO
SLIDE SW, CN301,
D3005, RB301
CHECK IC302
CHECK IC302
CHECK IC302
CHECK R3004,
D3007, IC302
CHECK X3001
CHECK X3002,
R3009, C3010,
C3017
TAKING INOPERATIVE
PUSH SHUTTER
BUTTON
IC301-5, 6
(SCAN IN 1, 2)
PULSE INPUT
YES
IC301-32, 33
(P ON, P(A) ON)
HIGH
IC301-13, 16, 18, 19
SERIAL
COMMUNICATION
OK
CHECK IC101
CHECK ST1 include
NO
LOW
NG
CHECK IC301, IC101
SHUTTER SW,
CN101
CHECK IC301,
POWER
CHECK IC301
NO PICTURE
CLK (48 MHz)
INPUT
IC111-16 (CLK IN 2)
OK
CLK (98 MHz)
INPUT IC111-11
(CLK IN1)
OK
CHECK SOLDERING OF
EACH CPU AND
MEMORY PIN
MAIN CLOCK FOR SYSTEM OPERATION
NG
NO OPERATION IF ABSENT
CHECK X1101 OSCILLATOR AND IC111
NG
CLOCK FOR CCD DRIVE
CHECK IC111, X1101
D-2 Ver. 1
Page 3
X-100/D-540ZOOM/C-310ZOOM
D. REPAIR PROCEDURE
[2] RENEWAL OF A FIRMWARE
1. Format a xD-picture card using X-100/D-540ZOOM/C-310ZOOM and make a directory “firmware” in the
xD-picture card. Then, change the name of binary data to “firmware.bin” and copy it to the xD-picture card.
(Making of the firmware card.)
2. Insert the firmware card in the camera, and turn ON the camera in play mode.
3. “YES/NO” is displayed on the LCD monitor. Then, chose “YES” and press OK button.
4.”ExCHANGING” is displayed on the LCD monitor and the SELF-LED is lighted up during exchanging the firmware.
Do not turn off the camera and do not operate any function during exchanging the firmware. It may damage
the camera.
5. When the exchanging was finished, the image which is same as 3 is displayed on the LCD monitor.
Then, confirm the firmware version. Chose “NO” and turn OFF the camera.
D-3
Ver. 1
Loading...