B. DISASSEMBLY AND ASSEMBLY PROCEDURE C-300 ZOOM / D-550 ZOOM
B. DISASSEMBLY AND ASSEMBLY
PROCEDURE
[1] REMOVAL OF CABINET BACK AND CABINET FRONT.......................................B-2
[2] REMOVAL OF SY1 BOARD AND LCD .................................................................. B-3
[3] REMOVAL OF ST1 BOARD AND CP1 BOARD .....................................................B-3
[4] REMOVAL OF LENS ASSEMBLY .......................................................................... B-4
[5] BOARD LOCATION ................................................................................................B-4
B-1 Ver.1
B. DISASSEMBLY AND ASSEMBLY PROCEDURE C-300 ZOOM / D-550 ZOOM
[1] REMOVAL OF CABINET BACK AND CABINET FRONT
Disassembly perform as follows and assembly perform by reversing the disassembly steps.
Be sure to discharge the main capacitor, then continue to disassembling.
! Beware of electric shock
Danger of electric shock.
Use a discharging tool to remove
the electrical charge before working.
1. Open the cover battery.
2. Nine screws 1.7 x 4
3. Cabinet back
4. Cover battery
5. Stand
6. Screw 1.7 x 4
7
8
7. Cabinet front
8. Connector
9. Discharge C5412.
10. Spacer wire st
11. Spacer wire st
12. Spacer wire st
13. Remove the solder.
2
3
6
13
12
10
11
2
gray
pink
2
2
black
13
C5412
9. Discharge both edge of
5
1
C5412.
2
4
B-2 Ver. 1
B. DISASSEMBLY AND ASSEMBLY PROCEDUREC-300 ZOOM / D-550 ZOOM
[2] REMOVAL OF SY1 BOARD AND LCD
1. Screw 1.7 x 4
2. Connector
3. Buzzer
4. Remove the solder
5. Connector
6. SY1 board
7. FPC
8. Remove the solder.
9. LCD
10. Three screws 1.7 x 4
11. Spacer CCD
12. Spacer LCD
13. Holder monitor
black
4
1
2
7
9
6
5
3
10
white
12
blue
red
11
13
red
8
white
blue
[3] REMOVAL OF ST1 BOARD AND CP1 BOARD
During assembly, check that
the sliding section A is engaged
with the rotating section B as
shown in the illustration.
1. Two screws 1.7 x 4
2. Lens VF
3. Rmove the solder
4.Two screws 1.7 x 4
5. ST1 board
6. Screw 1.7 x 4
7. Three screws 1.7 x 6
8. CP1 board
9. Holder chassis
1
2
6
7
A
4
B
9
8
black
3
5
Ver. 1
B-3
B. DISASSEMBLY AND ASSEMBLY PROCEDURE C-300 ZOOM / D-550 ZOOM
[4] REMOVAL OF LENS ASSEMBLY
1. Screw 1.7 x 2.5
2. Two screws 2 x 5
3. Two FPCs
1
2
[5] BOARD LOCATION
SY1 board
Lens
CCD
CP1 board
ST1 board
B-4 Ver. 1
Loading...