Oliver 1508-M Installation Manual

Grand Rapids, Michigan, U.S.A. 49504-5298

USER’S OPERATING AND INSTRUCTION MANUAL

MODEL 1508-M

MANUAL TRAY LIDDER

1508S20000CV

1508M MANUAL LIDDER

INDEX

SAFETY INSTRUCTIONS........................................................................................... 1508S20015

SET UP........................................................................................................................ 1508S20016

OPERATING PROCEDURE......................................................................................... 1508S20017

ADJUSTMENTS........................................................................................................... 1508S20018

TECHNICAL SPECIFICATIONS................................................................................... 1508S20019

CLEANING................................................................................................................... 1508S20020

TROUBLE SHOOTING................................................................................................. 1508S20021

ASSEMBLIES

HEATER PLATEN ASSEMBLY ........................................................................... 1508S20022

PLATEN PUSHER ASSEMBLY ……………………………………………………... 1508S20023

FINAL ASSEMBLY.................................................................................................. 1508S20024

MACHINE EXCHANGE PROGRAM............................................................................. GEN 050819

WARRANTY................................................................................................................. GEN 040225

WARRANTY PROCEDURE.......................................................................................... GEN 040226

RETURNED PARTS POLICY....................................................................................... GEN 040227

1508S20014

1508M MANUAL LIDDER

SAFETY

Various safety devices and methods of guarding have been provided on this machine. It is essential,
however, that machine operators and maintenance personnel observe the following safety
precautions. Improper installation or operation of this equipment may cause injury to personnel or
damage to equipment.

• Before operating the Manual Lidder read through this manual. Never allow an untrained person to

operate this machine.

CAUTION

• CAUTION HOT: The heater cover and upper platen are very HOT! Caution must be used to
protect yourself and others.

• In addition to these general safety instructions, follow the specific instructions given throughout
this manual.

1508S20015

1508M MANUAL LIDDER

SET UP

1. Unpack and carefully remove the Manual Lidder. Check for completeness of your order and that

none of the items have been damaged during shipment.

2. Screw the four rubber feet in to place on the bottom of the machine.

3. Place the Manual Lidder in a suitable location that provides adequate working space. The

location must be sturdy, level, and capable of holding 50 lbs. per machine.

4. Plug the power cord into a grounded electrical outlet. The Manual Lidder requires single phase

110 VAC, 60 Hertz with 10 ampere (minimum) circuit breaker protection.

5. Install the tray carrier:

6. Load lid dispenser:

Rev. 11-9-09

1508S20016

1508M MANUAL LIDDER

OPERATING PROCEDURE

1. To turn the machine on plug in the power

cord. Wait 40 minutes to allow the heated
upper platen to reach temperature.

2. Place a tray in the tray carrier.

3. Position a single lid on the tray. Use the

retractable pins on the tray carrier to center
the lids over the tray. Be sure the adhesive

side of the lid is down.

NOTE

• The adhesive side of the lid can be

determined by pinching a fold and rubbing the

lid material against itself. Test both sides of

the lid. The rough or tacky side of the lid will

be the adhesive side.

4. Push the tray carrier into the Manual Lidder
until it stops.

NOTE

• Actuating machine with no tray or lid in place
may cause the tray carrier to stick closed.

5. Rotate the handle down into the locked

position. (Do not force handle)

6. Wait 1 second.

7. Rotate the handle up to the start position.

8. Pull the tray carrier out of the manual lidder.

9. Remove the lidded tray by pushinng up on

the bottom of the tray and lifting from tray
carrier.

1508S20017