Nokia 9232831 User Manual

Nokia Car Handset Installation Guide User Guide

HSU-4

CUW-3

9232831

Issue 2

Reproduction, transfer, distribution or storage of part or all of the contents of this document in any form without the prior written permission of Nokia is prohibited.

Nokia and Nokia Connecting People are trademarks or registered trademarks of Nokia Corporation. Other product and company names mentioned herein may be trademarks or tradenames of their respective owners.

Nokia operates a policy of ongoing development. Nokia reserves the right to make changes and improvements to any of the products described in this document without prior notice.

Under no circumstances shall Nokia be responsible for any loss of data or income or any special, incidental, consequential or indirect damages howsoever caused.

The contents of this document are provided “as is”. Except as required by applicable law, no warranties of any kind, either express or implied, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose, are made in relation to the accuracy, reliability or contents of this document. Nokia reserves the right to revise this document or withdraw it at any time without prior notice.

The availability of particular products and services may vary by region. Please check with the Nokia dealer nearest to you.

9232831 / Issue 2

For your safety

ROAD SAFETY COMES FIRST

Observe the safety and care and maintenance guidelines set out in the Nokia 610 or Nokia 616 car kit phone user guide.

Remember that the safety of operating a motor vehicle in traffic requires the full attention of all motorists. Only operate your handset if allowed by local laws and restrictions and if traffic conditions permit safe use.

1. Important information

The Nokia Car Handset HSU-4 replaces the CUW-3 input device supplied with the Nokia 610 or Nokia 616 car kit phone.

This user and installation guide supplements the user guide belonging to the scope of supply of the car kit phone.

2. Mounting the handset

The handset comes with a mount that is to be fixed in a suitable location where it is easily accessible for the user.

Remember that all equipment must be mounted so that it does not interfere with the operation of the vehicle. Check to make sure that deployment of the airbag is not blocked or impaired in any way.

With ignition off, remove the cable connection from the CUW-3 input device to the radio unit and insert the handset cable in the appropriate socket in the radio unit (see the figure on the title page).

The best location to mount the handset is horizontally on the console between the driver's and front passenger's seats.

Contact your service technician for further detailed information on alternatives for mounting the handset suitably in your vehicle.

+ 4 hidden pages