NIKON D200 TECHNICAL INFORMATION TIE05246

QUALITY ASSURANCE DEPT.

TIE-05246

2005/12/14

H.Masumoto

Mgr

Chf

T.Ogasahara

H. Tsuru

D200》Revision of Image adjustment software (J65084) "STD.DAT

《

"

Summary

In some cases, the sensitivity reference value could not be obtained in "REFERENCE VALUE CALC" of

D200 image adjustment software (J65084). To correct this problem, "STD.DAT" le, which is included in the

software, was revised as follows:

Contents

　Change:

① The range for getting the sensitivity reference value of "STD.DAT" le was increased.

② The initial value of the sensitivity reference value of "STD.DAT

" le

was changed to the

theoretical value.

Even if the reference value has been already got, reacquire it just to make certain by using

"STD.DAT" that was revised this time.

Date of version of "STD.DAT" after decompressing the le: 2005-12-15

[There is NO change in version of the software (J65084) itself.]

　Distribution:

For service facilities where the adjustment software was already purchased, the revised version will

be separately distributed by RP (section) free of charge.

Note)

The revised "STD.DAT" le is attached in the software which is distributed on and after 2005-12-14.

P1/1