Nikon COOLPIX 800 update Manual
Nikon Firmware Update for Coolpix 800 Version 1.1
Notes:
1. It is most important that you follow the supplied directions; failure to follow
all of the steps may result in your camera being disabled.
2. This update is for Coolpix 800 cameras only! It is strongly suggested that
you avoid any background process that may disrupt the Updater
communication process.
3. It is advised not to touch the mouse or keyboard once the uploader starts
to ensure against accidental launch of an application or other process.
4. This Software and Firmware is Licensed and Copyright of Nikon
Corporation Japan
1.0 System requirements
Macintosh users:
Mac® OS 7.1 or later
Verified models:
Power Macintosh 7600/133
Power Macintosh 9600
Power Macintosh 7100/80AV
Power Macintosh G3
Power Macintosh 9600
Power Macintosh Performa
Power Book G3
Power Macintosh 8500/132
*The software application does not operate properly with the Power
Book 1400 or on Macintosh computers that do not have an original
serial port fitted such as the iMac or G4
Windows Users
1. Microsoft Windows 95
2. Microsoft Windows 98
3. Microsoft Windows 98SE
4. Microsoft Windows NT 4.0
2.0 About software and firmware
The “Firmware Uploader Software for the E800 Ver.1.1” is a computer
program that updates the firmware in your COOLPIX 800 (E-800). The
firmware is a program, which runs inside the camera and controls its
operation. By running the Uploader Software you will install the new firmware
in the camera.
The process of transferring the new firmware from the computer to the
camera is sometimes called “Uploading,” “Upgrading” or “Updating” the
firmware.
If your camera is version 1.0 it is recommended that you update the firmware
in your camera to 1.1 in order to benefit from improved operating
performance.
The entire package (Uploader software and new firmware for the camera) is
supplied in a single file, which is compressed for distribution over the Internet.
Before performing a firmware update, you must de-compress the files back to
their original format.
3.0 Improvements and bug fixes in version 1.1
The principal changes to the camera firmware with the release of version 1.1
are in the form of the following improvements to product performance and
minor bug fixes (not listed):
1. Improvement in white balance control in fixed aperture mode
If you select AE Lock mode in manual white balance mode, the image
sometimes becomes green. This problem has been solved.
4.0 Restrictions on Usage
This utility will update the firmware in your COOLPIX 800 to version 1.1. It can
only be used if the version of the firmware in your COOLPIX 800 is version
1.0 and is not suitable for use with any other model of Coolpix camera. This
version of the firmware can only update NTSC cameras.
5.0 Warnings
Your COOLPIX 800 could malfunction should any of the problems listed below
occur while the firmware is being upgraded. Please exercise all necessary
caution during the upgrade. The upgrade can be performed for you at a Nikonauthorized service center in the event that you do not have the equipment
necessary to perform the upgrade, or are otherwise unsure that you would be
able to perform the upgrade yourself. Your COOLPIX 800 could malfunction
should any of the following occur during upgrade:
1. The camera turns off during the upgrade process
2. The data cable is disconnected
3. A problem occurs with the computer
4. The upgrade is performed in a place where there is excessive electrical
noise.
The camera could also malfunction if you make a forced exit from the uploader or
another application interferes with the uploader during the upgrade. Be sure to
exit any other applications before running the uploader software.
6.0 Confirming the current firmware version
Loading...