Netgear WNAP210, WG302, WG103, WNDAP350, WNDAP330 Application Note

AP configuration (WNDAP330)
LAN IP

192.168.1.235
Untagged VLAN: 1 – Management VLAN: 1

SSID Corporate – VLAN 1(ID 1)
SSID Guest – VLAN 20 (ID 20)
SSID Engineering – VLAN30 (ID 30)

Corporate

Guest

Engineering

UTM Port 1 to AP LAN

UTM 10 Configuration
LAN IP

192.168.1.1
VLAN1 (Corporate - default)

IP 192.168.1.1
Membership: Port 1, 2, 3, 4
DHCP enabled 192.168.1.x/24

VLAN20 (Guest1)
IP 192.168.20.1
Membership: Port 1
DHCP enabled 192.168.20.x/24

VLAN30 (Engineering)
IP 192.168.30.1
Membership: Port 1
DHCP enabled 192.168.30.x/24

UTM Port 2 to Switch 0/1

Internet

Wired LAN 192.168.1.x/24

Layer 2/ Layer 3 switch configuration

LAN IP

192.168.1.239
Management VLAN: 1

Membership : all ports Untagged in
VLAN1

UTM (Unified Threat Management) in a multi-SSID multi-VLAN network with
traffic separation

This document describes the steps to undertake in configuring a UTM 10 (Firmware version

1.0.16-0) and a WNDAP330 (Firmware version 3.0.3) to host a multi-SSID and multi-VLAN
network.

The solution will allow separating the Wireless traffic and Wired traffic of each of the VLANs
configured, from any other VLAN which will exist on the Wired or Wireless LAN – maintaining
same VLAN communication.

The diagram below shows a typical scenario.

Version 2.0

Table of Contents

Network Setup .................................................................................................................. 3

Physical setup ............................................................................................................... 3

Logical setup ................................................................................................................. 3

UTM10 Configuration ...................................................................................................... 4

Create a new VLAN ..................................................................................................... 4

AP configuration (WNDAP330) ...................................................................................... 5

Create a new SSID ...................................................................................................... 5

Further Notes .................................................................................................................... 6

Testing ........................................................................................................................... 6

Managing devices ........................................................................................................ 6

Version 2.0